Satel AQUA Series Manual de usuario

DIGITAL PASSIVE INFRARED DETECTOR

AQUA RING

CEILING MOUNT

aquaring_e 06/04

The microprocessor-based, fully

digital AQUA series detectors

feature high sensitivity and

interference resistance. A dual pyro

electric element is used in the AQUA

RING detector.

TERMINALS:

NC - alarm relay (NC)

TMP - tamper contact (NC)

COM - ground (0V)

12V - supply input (9-16V DC)

Three pairs of pins are used to set the detector working parameters (see Table)

JP1 JP2 JP3

Low sensitivity

Medium sensitivity

High sensitivity

LED indicator ON

LED indicator OFF

- pins open - pins shorted

The LED lights red when the detector is actuated, which enables the installer to

check the detector for correct functioning and to approximately determine the

protected area.

For 30 seconds after the power is turned on, the detector remains in a starting

state, which is signalized by rapid LED blinking. Only then the detector enters its

operational readiness state.

The detector monitors the supply voltage. If the voltage drops below 9V (±5%) for

more than 2 seconds, the detector will signalize a violation state until a voltage of

minimum 9V (±5%) is restored.

INSTALLATION

The detector is designed for ceiling mount. Prior to installation, remove the

electronics board and make adequate openings for screws and cable in the

housing.

Be careful so as not to soil or damage the pyro element in the process of

installation.

LED

NC NC TMP TMP COM 12V

PIR SENS.

LED ON/OFF

JP1

JP2

JP3

pyro element

tamper contact

relay

positioning scale operating parameter

setting pins

Figure 1. View of detector electronics board

Figure 3 shows typical examples of connecting the detectors in EOL (parameter)

configuration and 2EOL (two-parameter) configuration. Resistors should be

mounted inside the detector housing.

NC NC TMP TMP COM 12V

AQUA RING detector

Z2 - programmed as „24h TAMPER” – NC type

+12V COM Z1 Z2 COM Z3 Z4 COM Z5 Z6 COM Z7 Z8 COM

R R

NC NC TMP TMP COM 12V

AQUA RING detector

Figure 3. Examples of detector connection

open

Figure 2. Detector view

TECHNICAL DATA

Nominal supply voltage ...............................................................................12V DC

Mean power consumption (±10%)..................................................................9.5mA

Violation signaling time........................................................................................ 2s

Protected area: when mounted at a height of 2.4m........................................36m2

when mounted at a height of 3.7m........................................80m2

Operating temperature range ................................................................-10...+50°C

Detectable motion speed....................................................................... up to 3 m/s

Dimensions ........................................................................................... ø97x29mm

Recommended installation height............................................... from 2.2m to 4.5m

Latest EC declaration of conformity and product approval certificates can

be downloaded from our Web site www.satel.pl

SATEL sp. z o.o.

ul. Schuberta 79

80-172 Gdańsk

POLAND

tel. + 48 58 320 94 00

info@satel.pl

www.satel.pl

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Sensor de seguridad de Satel

Satel

Satel AQUA RING S Manual de usuario

Satel

Satel CD-2 Manual de usuario

Satel

Satel VD-1 Manual de usuario

Satel

Satel COBALT Pro Manual de usuario

Satel

Satel AQUA PET Manual de usuario

Satel

Satel abax 2 ACD-220 Manual de usuario

Satel

Satel GRAPHITE Pet Manual de usuario

Satel

Satel AQUA PRO Manual de usuario

Satel

Satel AMD-103 Manual de usuario

Satel

Satel INDIGO Manual de usuario

Satel

Satel COBALT Manual de usuario

Satel

Satel abax 2 ADD-200 Manual de usuario

Satel

Satel ABAX 2 APD-200 Manual de usuario

Satel

Satel AOCD-260 Manual de usuario

Satel

Satel GRAPHITE Manual de usuario

Satel

Satel AGD-100 Manual de usuario

Satel

Satel INDIGO TESTER Manual de usuario

Satel

Satel ARD-100 Manual de usuario

Satel

Satel AQUA S Manual de usuario

Satel

Satel SILVER Manual de usuario

Satel

Satel AQUA PET Manual de usuario

Satel

Satel OPAL Plus Manual de usuario

Satel

Satel SLIM-PIR-LUNA-PET Manual de usuario

Satel

Satel AOCD-250 Manual de usuario

Manuales populares de Sensor de seguridad de otras marcas

THORLABS

THORLABS PDA10JT Manual de usuario

Waeco

Waeco UV-DETECT Manual de usuario

Intermatic

Intermatic IOS-DSIMF Manual de usuario

urmet domus

urmet domus 1083 Manual de usuario

Siemens

Siemens AZL66 Series Manual de usuario

BTI

BTI Profiline Multi Finder Manual de usuario

Challenger

Challenger SL01 Manual de usuario

DMP Electronics

DMP Electronics 1122INT Manual de usuario

Rielta

Rielta Ladoga MK-RK Manual de usuario

Mirion Technologies

Mirion Technologies ACCURAD PRD Manual de usuario

Bosch

Bosch DS835 Manual de usuario

DBI SALA

DBI SALA EZ Stop Manual del operador

Lamptime

Lamptime ST05C Manual de usuario

Ubiquiti

Ubiquiti MFI-MSC Manual de usuario

Subsite

Subsite 910R Instrucciones de instalación

Aleph

Aleph XC-1XTEU Manual de usuario

Pima

Pima LARIS QUAD Manual de usuario

Solinst

Solinst 301 Manual de usuario