Satco Products, Inc.
Brent wood, NY 11717
WARNING
Do not insert smart plug into another smart plug.
The power is disconnected only when the smart plug is removed
from an electrical outlet.
The smart plug should be placed near the appliance and easily
accessible to user.
Do not open the product.
Prior to using, ensure the smart plug is not damaged.
Do not install the plug into a socket if the plug casing is damaged in any way.
Please take the Technical Data (in particular the maximum permissible
switching capacity of the relay and the type of load to be connected) into
account before connecting a load!
All load data relates to resistive loads! Do not exceed the capacity specied
for the device. Exceeding this capacity could lead to the destruction of the
device, to a re or to an electrical accident, and, the reliable switching o of a
controlled device may no longer be possible.
Do not connect any appliances which could cause re or other
damage if switched on inadvertently (e.g. irons, power tools).
Do not use plugs to disconnect appliances from the main power supply of
the home. The load is not galvanically isolated from the main power supply.
For indoor use only.
Do not use this product near water for example near a bath tub wash bowl,
kitchen sink or laundry tub, in a wet basement or near a swimming pool.
MAINTENANCE AND CARE
The product is maintenance-free. Repairs should only be performed by
qualied persons. Clean the product with a soft clean, dry and lint-free cloth
after removing the plug from the electrical outlet . Do not use cleaning agents
containing solvents.
Incorrect handling or non-observance of safety warnings may compromise
the protection afforded by the device.
CAUTION
This device complies with Part 15 0f the FCC Rules and Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause harmful interference. and (2) this
device must accept any interference received. including interference that
may cause undesired operation.
Changes or modications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device. pursuant to part 15 0f the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and. if not installed and used in accordance with
the instructions. may cause harmful interference to radio communications.
However. there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on. the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B)/NMB-3(B)
To satisfy FCC / lC RF exposure requirements. a separation distance of 20
cm or more should be maintained between the antenna of this device and
persons during device operation. To ensure compliance. operations at closer
than this distance is not recommended.
© Copyright 2020 Satco Products, Inc. 9/20
