Sanyo CZP 3045 Manual de usuario
I
Please read this booklet before attempting to
operate your T.Kset.
[
--
—
-—
—-
SANYO COLOUR
TELEVISION
OPERATING
INSTRUCTIONS
We congratulate you on the purchase of your new Sanyo colour television. This set has
been manufactured using the most advanced technical knowledge available and the most
modern production and testing methods. ..
It complements the very high standard of modern colour transmission technology
These are the important advantages of your colour T.V. set:
●Natural and brilliant colour reproduction and easy service.
●Excellent reception of distant stations because of the full electronic all band tuner,
stabilized by AFT =Automatic Fine Tuning,
●Push button programme selection with programme indicator.
Up to eight programmed in your reception area can be memorized.
●Automatic control of important functions and the use of the latest transistors.
Autocrat Sanyo Ltd wish you many hours of enjoyment with your new Sanyo Colour
Television.
1
Controls
fb=z=—— (*g
~i I
llc_- ~II w///////a ml I
Programme Indicator
Standby Indicator
Main On/Off Switch O
Volume _
AFT .Swtich
Programme Selector Button
AFT Defeat Button
Adaptor Knob
Colour @
Brightness O
Contrast ~
Figure-1
Operation
1.
2.
3.
z
Switching onloff
The set is switched on by pressing button ~To switch off, press button again.
Volume
Use volume control button @(+ or —) to adjust the sound volume as desired.
Procrramme selection
Pre& the right side (+) of the programme selector ~,and the TV set will step up to the next
station, i.e: 1,2,3...8, 1,2,3 . . . Pressthe left side (—),and the TV setwill step down to the previous
station. The number of the programme selected will appear in the programme indicator @
Adjusting picture
The Colour ~,Brightness ~,and Contrast ~,rotary controls will have been set during
installation, h~wever, YOUmay need to readjust from time to time.
AFT and Tuning
When pre-set adjustment becomes necessary,open the control box door by pulling the right top of it
with your finger.
AFT (Automatic Fine Tuning)
AFT automatically maintains COrreCt fine tUnln9 So that it is seldom necessary to retune the set. AFT
operates automatically when AFT defeat button @is in “ON” position and the control box door is
closed.
(NOTE: AFT will be defeated when the COntrOl box door is open).
2
Tuning
Tuning Indicator @—,
Band Switch
Tuning Control
@Tuning Indicator
Imu
‘& Bandl VliFChannel l., .....3
‘@ Bandlll V!-lFChanne14 .......ll
‘~ Band UUHFChanne121 ......69
Figure-2
Figure-3
..
Tuning
1.
2.
3.
4.
5,
Refer to Figure-2.
Press either +or —programme selector button ~,step by step, until the desired number is
displayed intheprogramme indicator CJ
Reset the band switch ~to the position corresponding to the channel to be switched over
Figure-3 .Theband switch can beeasilyturned byusingtheadaptor knob @which islocatedw
the control box.
Turn thetuningcontrOl “~ corresponding to the chosen programme number until the desired
channel is indicated by tuning indicator @Read the band 1,Ill, orU scale on the indicator
corresDondina to the band switch. The tuning COntrOl should becarefully adjusted for the best
sound’and pi;ture onthe desired channel. -
Repeat the procedure for other programme numbers if required.
After presetting the required programmed, close the control box.
A.V. (Audio Video) Connection
To use the set with avideo cassette recorder the set must first be tuned to the channel signal Produced
by the VCR. Connect and operate the VCR according to the Manufacturers instructions. Select
programme”8 (AV)” and rotate the adjacent tuning control until the set istuned into the recorder signal.
For future use it will only be necessary to select programme”6 (AV)”.
3
I
575
.-+
r%
55”
—“ -.
eSANYO
-cm-.
Figure-4
Figure-5
Remote Control
Refer to Figure-4
1. Remote Control Ooaration
Main ON/OFF swi~ch of the TV set must be in the “ON” position before remote control operation.
Point transmitter towards the TV set, then press the appropriate function button for the following
controls.
2, Power ON/OFF
To switch the TV set on, press this button @To switch TV set off, press it again.
NOTE: The standby indicator @will remain illuminated if the TV set is switched off with this
button. This is to indicate that the TV set is partially energized. To cut off power to the TV
set completely, switch it off by using the main ON/OFF switch on the set itself.
3. Programme selection
%ess a(+) button of the programme selector @,and the TV set will step up to the next station,
I.e.: 1,2,3 ...8; 1,2,3, ...Press a(—) button, and the TV set will step down to the previous station. The
number of the programme selected will appear in the programme indicator ~
4, Volume
To increase the volume, press the (+) button @and to decrease it, press the (—) button.
5. Sound mute
Should. you wish to mute the sound (e.g. While talking on the telephone) Press this
button @once. To switch the sound back on, press it again.
Battery Installation
Refer to Figure-5
1. Remove the battery cover by sliding it.
2. Install two “AA’ 1.5 volt batteries so that the “+” and “-” marks on the batteries match the “+” and
‘,—“ marks inside the unit.
3. Close the battery cover.
4
NOTE:
Replace the batteries when the TV set is showing the following symptoms: Operation is unsteady or
erratic, sometimes the TV set does not work with transmitter. Discharged batteries may leak and
damage the unit. The normal life of batteries should be from nine to ten months.
Aerial
The type of aerial required depends on factors such asthesite, its distance and direction from the
transmitter, local interference etc. Your dealer will advise you on the best type of aerial to use.
The aerial socket is on the back panel of the TV set.
●The telescopic aerial is an auxiliary aerial and will only give satisfactory recepuon In areas near the
transmitter. For good reception, adjust the aerial by varying the length and angle of the rods until the
clearest picture is obtained.
.When 75 ohm (coaxial cable) is used for aerial input. Connect cable with IEC connector to
aerial socket.
●When 300 ohm feeder is used for aerial input. Install adaptor totheaerial socket as shown in ““-
Figure-6 below and connect feeder to the terminal of the adaptor.
300-75 .!2
w
MATCHING TO THE
BOX AERIAL
SOCKET
300$2 ~/
RIBBON
IFigure-6
Mains Supply
The receiver is designed to operate on an AC. mains supply of 230 volts 50Hz
Specifications
Power Source ..............................................................AC23OV.5OHz
Power Consumption ......................................................5OWatts
Television System .........................................................System B/G
Colour System .............................................................PAL
Channel Coverage ........................................................VHF. l.ll
UHF: 21-69
Aerial lnputlmpedance ...................................................75ohm
Picture Tube ...............................................................34cm diagonal, 90 degree
Audio Output ..............................................................l.5 Watts
Semiconductors ...........................................................l6Transistom
6Integrated Circuits
High Voltage ...............................................................22kV stabilized
Dimensions .................................................................463(W) X335(H) X370(D)
Weight . .. ....... ............. . . ..... .............................Ilkg
5
r- Customer responsibilities list
BEFORE YOU CALL FOR SERVICE, check the following points
which are your responsibility. Asenrice charge will be made for
service as a result ofi
1. Power point not switched on or plug not pushed in.
2. No power at power point. Check with small appliance.
3. Aerial lead not properly connected.
4. Controls not properly adjusted in accordance with operating
instructions.
Manufactured and assembled
in New Zealand under exclusive Iicence
to the Sanyo Electric Co. of Japan by:-
AUTOCRAT SANYO LTD.
142 Broadway, Newmarket,
Private Bag, Newmarket,
Auckland.
P/N 94-005895 InsiitutePress CZP3045
Tabla de contenidos
Otros manuales de TELEVISOR de Sanyo
Sanyo
Sanyo ACI-A Guía de instalación
Sanyo
Sanyo 28D2 Manual de usuario
Sanyo
Sanyo C28ER57 Manual de usuario
Sanyo
Sanyo HT28745 Hoja de información del producto
Sanyo
Sanyo CE27LD6-B Manual de usuario
Sanyo
Sanyo CP14SE1 Manual de usuario
Sanyo
Sanyo CP14SW1Z Manual de usuario
Sanyo
Sanyo NET@ DP47460 Manual de usuario
Sanyo
Sanyo CE42FD17-B Manual de usuario
Sanyo
Sanyo DP19657 Manual de usuario
Sanyo
Sanyo CP34ST3T Manual de usuario
Sanyo
Sanyo DS13330, DS19330, DS25320 Manual de usuario
Sanyo
Sanyo DP32640 - 31.5" Diagonal LCD HDTV 720p Manual de usuario
Sanyo
Sanyo CE21D4-C Manual de usuario
Sanyo
Sanyo C29LK39S Manual de usuario
Sanyo
Sanyo FC3G2 Guía de instalación
Sanyo
Sanyo AVM-27D6 Manual de usuario
Sanyo
Sanyo DP26640 - 26" Diagonal LCD HDTV 720p Manual de usuario
Sanyo
Sanyo DS25520 Manual de usuario
Sanyo
Sanyo CP21YS2 Manual de usuario
Manuales populares de TELEVISOR de otras marcas
Philips
Philips Colour Television Manual de usuario
Toshiba
Toshiba 27A10 Manual de usuario
Philips
Philips 42PF9630A/37 Manual de usuario
Hitachi
Hitachi 32FX48B Manual de usuario
DAEWOO ELECTRONICS
DAEWOO ELECTRONICS DTQ-14V1FC Manual de usuario
Changhong Electric
Changhong Electric uhd55b6000is Manual de usuario
