Sanctuary SA-DIA4 Manual de usuario

IMPORTANT:

Please read this information and follow all safety rules carefully before

operating your security safe. Failure to do so will void your warranty.

033023

SECURITY SAFE INSTRUCTION MANUAL

FOR SA-DIA1, SA-DIA2, SA-DIA3 AND SA-DIA4

TABLE OF CONTENTS

www.saproducts.com 1

IMPORTANT INFORMATION ............................................................................................... 2

1. REGISTRATION ................................................................................................................ 3

2. UNDERSTANDING YOUR SAFE ...................................................................................... 4

3. INITIAL ENTRY .................................................................................................................. 5

4. ELECTRONIC LOCK SECURITY CODE SETUP....................................................................... 6

5. OPENING YOUR SAFE WITH PROGRAMMED SECURITY CODE.......................................... 8

6. LOCKED OUT OF THE SAFE............................................................................................... 8

7. INTERNAL LIGHTING .........................................................................................................9

8. LOW BATTERY WARNING................................................................................................. 9

9. LOCKOUT MODE / TAMPER PROTECTION........................................................................ 9

10. SILENT ENTRY MODE .................................................................................................... 10

11. PROPER PLACEMENT AND MOVING OF SAFE ..............................................................10

12. KEEPING YOUR SAFE DRY.............................................................................................10

13. SECURING YOUR SAFE .............................................................................................. 11

14. LOADING YOUR SAFE .................................................................................................12

15. HINGES AND INTERNAL MECHANISMS........................................................................ 12

LIFETIME WARRANTY........................................................................................................ 13

DISCLAIMER - READ BEFORE SAFE SETUP

WEAPON STORAGE

SAFETY

Thank you for choosing a Sanctuary safe to protect your valuables. We are

commied to securing, organizing and protecng your most important documents,

valuables and keepsakes.

If you experience problems or challenges with your safe, please contact us.

Many issues can be quickly resolved without the product being returned.

Be sure to keep override keys stored in a secure place away from unauthorized users.

If you choose to ulize this safe to store a ﬁrearm alwaysfollow proper ﬁrearm

storage and local laws.

SA Consumer Products strongly recommends that you do not store loaded ﬁrearms.

Always follow the ﬁrearm safety rules set out by the ﬁrearm’s manufacturer.

A Sanctuary safe or any other ﬁrearm storage device cannot take the place

of other safety procedures including advising children of the dangers of ﬁrearms.

SA Consumer Products and its distributors of the Sanctuary safes do not

recommend, suggest, advise, promote, or otherwise condone the ownership

or use of ﬁrearms. We believe the decision to own or use a ﬁrearm is a serious

decision that should only be made by an adult who has carefully considered

the risks and beneﬁts of such a decision.

PLEASE READ THIS INFORMATION CAREFULLY BEFORE OPERATING YOUR

SANCTUARY SAFE.

DO NOT LOCK THIS MANUAL OR THE OVERRIDE KEYS IN YOUR SAFE.

Contact Customer Service at [email protected] or (888) 792-4264

www.saproducts.com

REGISTRATION INFORMATION

PURCHASE DATE:

PURCHASE PRICE (BEFORE TAX):

MODEL NUMBER:

SERIAL NUMBER:

KEY NUMBER (IF APPLICABLE):

1. REGISTRATION

RETAILER NAME:

Please ensure you register your safe by vising our website. Locate the

“contact” buon on the top header on the home page. Select registraon

from the drop down menu.

By registering your Sanctuary safe we will be able to expedite and address

any problems or challenges you may have which would otherwise require a

notary leer and proof of payment.

The informaon you record onto this page will be required in the event you

cannot access the contents of your Sanctuary safe. Please ﬁll out all the required

informaon below and retain for your records and safe keeping.

PLEASE HAVE THIS INFORMATION READY PRIOR TO CALLING FOR TECHNICAL

ASSISTANCE AT:

Contact Customer Service at [email protected] or (888) 792-4264

2. UNDERSTANDING YOUR SAFE

Handle

Electronic

Lock Face

Override

Key Entry

(underneath

keypad)

Active

Locking

Plates

Key

Hooks

Adjustable Shelves

(SA-DIA1 only has one shelf

SA-DIA4 has 3 shelves)

Door Organizer

Storage Pocket

Bolt

Down Holes

Dead

Locking Plates

Interior Light

Reset

Button

Lighting

Activation Button

3. INITIAL ENTRY

1. Locate the override keys

inside the plasc bag

hanging on the front of

the safe.

Locate the override key entry

on the door of the safe.

Insert the key and turn

clockwise from the 12 to

3 o'clock posion.

Remove the lock face from

the box located inside the

safe.

BACK OF LOCK FACE

Locate the 1x9V baery.

Install into the baery

compartment on the back

of the lock face in the

proper orientaon. The

keypad will beep when

baeries are successfully

installed.

Turn the handle

counter-clockwise to

unlock the safe door. Open

the Ssafe door, then turn

the handle back to it's

starng posion so the

locking plates are extend-

ed. Remove the override

key and set aside.

Step 4Step 5

WARNING: The baeries must be inserted with the correct polarity. Exhausted baeries

must be removed from the product and discarded safely. Do not mix old and new

baeries. Do not mix alkaline or standard (carbon – zinc) baeries. Do not use recharge-

able (nickel – cadmium) baeries.

3. INITIAL ENTRY (Continued)

Plug the electronic lock cable

into the back of the lock face.

The connector on the cable

will only ﬁt into the

connector in the lock face in

one way.

Finally, we will install the

keypad onto the safe. First,

align the lock face to the

backer plate and slide the top

of the lock face up into the

two locking pins. Next, lightly

push up on the release tab

located on the boom of the

backer plate, allowing you to

push the lock face and secure

to the backer plate.

Step 7 Step 6

4. ELECTRONIC LOCK SECURITY CODE SETUP

Important: Your safe comes programmed with a factory code of [ 1 5 9 # ].

It is necessary to re-program your safe with a new security code you have personally

selected to provide maximum household security. Be careful, in choosing your new

security code, you’ll want to be sure that you can operate the unit quickly without

making an error.

To begin programming, open

door and extend locking plates

to ensure access to the safe.

On the inside of the safe door,

locate the red plasc cap.

Unscrew and remove the cap,

giving you access to the reset

buon. Press the reset buon.

You will hear 2 beeps and the

keypad will illuminate indicang

that you are now in

programming mode.

Reset buon

located

under plasc

cap

4. ELECTRONIC LOCK SECURITY CODE SETUP (Continued)

Enter your new 3 to 8 digit

security code followed by the

[ * ] symbol.

x2 x2

SUCCESS!

GREEN

If programming is is successful: Keypad

will beep 2 mes and green LED will ﬂash

2 mes.

If your code was not accepted: the

keypad will beep three mes and

the yellow LED will ﬂash 3 mes.

Press the reset buon and start again.

Inacvity Timeout: If this programming sequence is not completed within 10

seconds the red LED will ﬂash 3 mes and the keypad will shut down.

Return to step 1 to restart this process.

NEW 3-8 DIGIT SECURITY CODE

While the safe door is sll open,

conﬁrm your newly entered

security code by entering the 3-8

digit code followed by the (#)

symbol.

If successful you will hear two

beeps and you will be able to

retract the bolts.

If unsuccessful, press the reset

buon and start again.

Step 3

CONFIRM SECURITY CODE

6. LOCKED OUT OF YOUR SAFE

In the event you are locked out of your safe, use your override keys to gain access and

follow the steps in Secon 4: Electronic Lock Security Code Setup Instrucons.

If you have lost your override keys, or are sll having diﬃcules, contact customer

service at the number below. Proof of purchase is required to obtain keys.

4264

Contact Customer Service at [email protected] or (888) 792-4264

5. OPENING SAFE WITH PROGRAMMED SECURITY CODE

With keys in hand, close and lock the door.

Enter your security code followed

by the (#) buon.

If the security code is accepted,

the yellow LED will ﬂash 2 mes

followed by the green LED illuminang.

You now have access to your safe.

If the security code is rejected,

the yellow LED will ﬂash 3 mes

and beep 3 mes.

*Now that your security code is successfully programmed, store your override

keys in a secure secondary locaon. If you are not able to open your safe with your new

programmed code, repeat secon 4 to program a new security code.

9. LOCKOUT MODE / TAMPER PROTECTION

8. LOW BATTERY WARNING

Red & Green = Low Baery

This safe is equipped to alert you of Low

Baery Mode. This Low Baery Warning is

iniated immediately aer a successful code

entry. The keypad will illuminate both the red

and green LED lights for 3 seconds. It is highly

advised to immediately replace the safe's

baeries to avoid being locked out of your safe.

7. INTERNAL LIGHTING

When the safe door is opened,

internal lighng acvates for 30

seconds.

If you need to acvate your light

longer, you can press the green light

acvaon buon on the inner door

panel. This will acvate the internal

lighng for an addional 30 seconds

each me it is pressed.

Internal Light

Light Acvaon

Buon

1. Three consecuve rejected security code entries puts

the safe in “Basic Lockout” mode. The keypad is

deacvated for 30 seconds.

2. Six consecuve rejected security code entries results

in “Severe Lockout” mode. The keypad is deacvated

for 5 minutes.

Note: During lockout mode, the yellow LED will light up once

every 10 seconds. When lockout mode has ended, the

green LED will ﬂash 1 me and you will hear 1 beep to

signify the lockout mode has ended. You will now have

access to your keypad.

3. Aer the safe enters basic or severe lockout mode, the tamper indicator will trigger

to warn you that someone has unsuccessfully aempted to gain access to your safe.

This tamper indicator will signal immediately aer the next successful code is entered.

The yellow LED will ﬂash 3 mes and in addion to a 3 second long beep.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Seguro de Sanctuary

Sanctuary

Sanctuary BIOMETRIC SA-DIA1-BIO Manual de usuario

Sanctuary

Sanctuary PLATINUM SA-PLAT1 Manual de usuario

Sanctuary

Sanctuary DIAMOND SA-DIA1-COM Manual de usuario

Sanctuary

Sanctuary Diamond SA-DIA1 Manual de usuario

Sanctuary

Sanctuary Platinum SA-PLAT1-BIO Manual de usuario

Sanctuary

Sanctuary SA-PV2M Manual de usuario

Sanctuary

Sanctuary SA-PS1D Manual de usuario

Sanctuary

Sanctuary SA-PV2M-BIO Manual de usuario

Sanctuary

Sanctuary SA-PV1M-BIO Manual de usuario

Manuales populares de Seguro de otras marcas

Squire

Squire Stronghold Keysafe Manual de usuario

Phoenix

Phoenix FS0352C Hoja de información del producto

Phoenix

Phoenix KS0030E Series Manual de usuario

Vaultek

Vaultek 10 Series Hoja de especificaciones

Arregui

Arregui CLASS Manual de usuario

Beaumont

Beaumont SMART KEYBOX Manual de usuario

Honeywell

Honeywell 2077D - 1.21 Cubic Foot Anti-Theft Safe Manual de usuario

Hornady

Hornady SnapSafe Trunk Safe II Manual de usuario

SPORTS AFIELD

SPORTS AFIELD SA-HD5-BIO Manual de usuario

Honeywell

Honeywell 5912 Manual de usuario

Phoenix

Phoenix FS1280F Manual de usuario

Phoenix

Phoenix SS0992K Hoja de información del producto

Technomax

Technomax Trony Series Manual

SPORTS AFIELD

SPORTS AFIELD INSTINCT BIOMETRIC Series Manual de usuario

RICHTER CZECH

RICHTER CZECH LA Manual de operación

Olymp

Olymp GOsafe 110 Manual de usuario

Phoenix

Phoenix SS0100E Hoja de información del producto

Clarke

Clarke Strong-Arm CS1000K Manual de instrucciones