Samsung SP-46L3HR Guía

Your New Wide TV

English - 6

Replacing the Lamp

•Why do I need to replace the lamp?

The lamp used in a projection TV has a limited lifespan. For the best screen quality it needs to be

replaced periodically. After replacing the lamp, the screen quality will be bright and clear as new.

•When do I need to replace it?

It should be replaced when the screen becomes darker, less clear or when all three LEDs on the front

(Timer, Lamp, & Temp.) are flashing.

•Check before lamp replacement

1. The lamp must be the same code number and type.

2. The lamp type is indicated on the right side of the TV. It is also indicated on the lamp case.

3. After checking the code number for the lamp, give the code number to the store where you

purchased the TV or to a Samsung Service center.

•Caution

1. Replace with the correct code numbered lamp to avoid damage to the TV.

2. Turn the power off and wait for 30 minutes before replacing the lamp as it will be hot.

3. Do not touch the glass part of the lamp with your bare hands nor insert any foreign object inside

the cover as it may cause poor screen quality, electric shock or fire.

4. Do not place the old lamp near flammable objects or within the reach of children.

• For replacement, you will need a 5.91 Inches-long Phillips screwdriver and a pair of gloves.

NOTES

•Be sure the replacement Lamp is the same type.

•After replacing the lamp, align the lamp cover with the groove and secure the screw.

•The TV will not turn on if the lamp cover is not correctly closed (as this will activate the

protective circuit).

1Unplug TV, then use a

screwdriver to remove the

screw.

2Remove the Lamp cover.

3Remove the screws securing

the Lamp by using a

screwdriver.

4Separate the Lamp from the

engine by holding the handle

and pulling it out.

5To reinstall the Lamp, follow

these steps in reverse order.

English - 7

English - 8

List of Features

Your TV was designed and engineered using the latest technology. It is a full-featured, high-performance

unit that exceeds industry standards. In addition, it has these special features:

• Easy-to-operate remote control

• Easy-to-use on-screen menu system you can access from the side panel or remote control

• Automatic timer to turn the TV on and off at any time you choose

• Adjustable picture and sound settings and the ability to memorize your favorite settings

• Automatic channel tuning for up to 181 channels

• A special filter to reduce or eliminate reception problems

• Fine tuning control for the sharpest picture possible

• A built-in multi-channel sound decoder for stereo and bilingual listening

• Built-in, dual channel speakers

• A special sleep timer

• Picture-in-Picture capability that lets you watch two channels at once

• Widescreen TV with adjustable image size

• Life-like clear images provided by DNle technology

• My Color Control Mode for corresponding with your color style

• Color weakness Mode

Accessories

Once you have unpacked your TV, check to make sure that you have all the parts shown here. If any

piece is missing or broken, call your dealer.

Your New Wide TV

Remote Control

(BP59-00048C)/

AAA Batteries

(4301-000103)

Instruction Manual/

Safety Guide Manual/

Quick Guide Manual

Warranty Cards (2)/

Registration Card (1)

English - 9

Side Panel Buttons

The buttons on the right side panel control your TV’s basic features, including the on-screen menu

system. To use the more advanced features, you must use the remote control.

Press to switch between viewing TV programs and signals from connected components.

Press to see the on-screen menu.

Press to lower or raise the volume and to select items when using the on-screen menu.

Press to change channels and move between items on the on-screen menu.

Press to activate (or change) a particular item.

Side Panel Jacks

Use the right side panel jacks to connect a component that is used only occasionally (a camcorder

or video game, for example).

Connect the video signal from a camcorder or video game.

Connect the audio signal from a camcorder or video game.

Connect an S-video signal from a camcorder or video game.

(S-Video 3 jack and Audio L/R input 3 are used in conjunction.)

Your New Wide TV

English - 10

Front Panel LED Indicators

The three lights on the front panel indicate the status of your TV.

: Light is On

: Light is Blinking

: Light is Off

• It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.

• The TV has a fan to keep the inside lamp from overheating. You’ll occasionally hear it working.

TIMER

Standby state.

The picture will automatically appear in about 15 seconds.

Auto Timer ON/OFF has been set and the set will automatically be

turned on in about 25 seconds.

A cooling fan inside the set is not operating normally.

Lamp cover on rear of the set is not properly shut.

Check if the ventilation hole on the rear of the set is blocked, because if

the inner temperature is too high, the power will shut off.

Lamp may be defective. Please contact a certified technician.

LAMP STAND BY/TEMP Indication

Remote Control Sensor

Aim the remote control towards this spot on the TV.

POWER

Press to turn the TV on and off.

English - 11

Rear Panel Jacks

Use the rear panel jacks to connect components such as a VCR. You can connect different components

such as VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks and

three set of component video input jacks on the rear panel of your TV. For more information, please see

“Connections”.

ANTENNA terminals

Two independent cables or antennas can be connected to these terminals.

Use “ANT 1 IN” and “ANT 2 IN” terminals to receive a signal from

VHF/UHF antennas or your cable system. Use the “ANT 1 OUT” terminal to

send the signal being received by the “ANT 1 IN” terminal out to another

component (such as a Cable Set-Top Box). The PIP channel can be received

only when a signal source is connected to “ANT 1 IN”.

S-VIDEO INPUT jacks

Connects an S-Video signal from an S-VHS VCR or DVD player.

VIDEO/AUDIO INPUT jacks (VCR1, VCR2)

Connect video/audio signals from external sources, such as a VCR or DVD

players.

VIDEO/AUDIO OUTPUT jacks

Sends a video signal from the TV to an external source, such as a VCR.

Note: It is available only in RF, Video and S-Video modes.

Component1, 2 jacks (Y, PB, PR, L, R)

Use these jacks to connect the component video/audio signals from a DVD

player or a set top box when using the component video input jacks.

PC AUDIO INPUT jacks

Connect these to the audio output jacks on your PC.

∏

PC VIDEO INPUT jack

Connect these to the video output jack on your PC .

”

DVI (Digital Video Interface) AUDIO INPUT jacks

Connect to the digital audio output jacks for device with DVI output.

’

DVI (Digital Video Interface) VIDEO INPUT jack

Connect to the digital video output jack for device with DVI output.

HDMI (High Definition Multimedia Interface)

VIDEO/AUDIO INPUT jack

Connect to the HDMI jack for device with HDMI output.

SERVICE

This jack is for repair and software upgrades.

Remote Control

You can use the remote control up to about 23 feet from the TV. When using the remote control, always

point it directly at the TV. You can also use your remote control to operate your Set-Top box, VCR, Cable

box or DVD player.

Your New Wide TV

English - 12

1. POWER

Turns the TV on and off.

2. S.MODE

Adjust the TV sound by selecting one of the

preset factory settings (or select your personal,

customized sound settings.)

3. P.MODE

Adjust the TV picture by selecting one of the

preset factory settings (or select your personal,

customized picture settings.)

4. +100

Press to select cable channels over 100 on TV.

5. VOL +, VOL

Press to increase or decrease the volume.

6. MUTE

Press to mute the TV sound.

7. FAV.CH (Favorite Channel)

Press to switch between your favorite channels.

8. MENU

Displays the main on-screen menu.

9. STILL

Press to stop the action during a particular

scene. Press again to resume normal video.

10. P.SIZE

Press to change the picture size.

11. MODE

Selects a target device to be controlled by the

Samsung remote control (i.e., TV, STB, VCR,

CABLE, or DVD).

12. PRE-CH

Tunes to the previous channel.

13. SOURCE

Press to display all of the available video

sources (i.e., TV, Set-Top box, VCR, DVD, DTV,

PC).

14. CH , CH

Press to change channels.

15. INFO

Press to display information on the TV screen.

16. EXIT

Press to exit the menu.

17. ▲, ▼, œ, √, ENTER

Press to select highlight up, down, left, or right.

While using the on-screen menus, press the

ENTER to activate (or change) a particular item.

18. MTS (Multichannel

Television Stereo)

Press to choose Stereo, Mono or SAP (Secondary

Audio Program).

19. SRS

Activates TruSurround.

20. ADD/DEL

Press to add or erase channels in the TV’s

memory.

Use the ADD/DEL button to memorize and erase

the fine tuning after fine tuning channels.

21. SLEEP

Press to select a preset time interval for

automatic shutoff.

22. PIP (Picture In Picture)

Activates PIP.

23. SET

Used during set up of this remote control, so

that it will work compatibly with other devices

(Set-Top box, VCR, Cable box, DVD, etc.)

24. DNIe (Digital Natural

Image engine)

Activates DNIe.

25. PIP Controls

SIZE; Press to select the size of PIP window.

SWAP; Press to exchange the video signal that

is currently displayed on the main screen with

the signal in the PIP window.

CH / ; Press to display the available

channels in sequence. (These buttons change

channels in the PIP window only.)

26. VCR/DVD Controls

Controls VCR or DVD functions: Rewind, Stop,

Play/Pause, Fast Forward.

27. RESET

If your remote control is not functioning

properly, take out the batteries and press the

reset button for about 2~3 seconds. Re-insert

the batteries and try using the remote control

again.

Installing Batteries in the Remote Control

With normal use, the batteries in the remote control should last about a year. If you notice a performance

degradation while using the remote, the batteries may need to be replaced. Make sure you replace both

batteries and do not mix old and new batteries in the remote control. If you won’t be using the remote

control for a long time, remove the batteries and store them in a cool dry place.

1Slide the back cover all the way out

to open the battery compartment of

the remote control.

2Install two AAA size batteries.

Make sure to match the “+” and

“–” ends of the batteries with the

diagram inside the compartment.

3Slide the cover back into place.

English - 13

Otros manuales para SP-46L3HR

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de TELEVISOR de Samsung

Samsung

Samsung HL-R4667W - 46" Rear Projection TV Manual de usuario

Samsung

Samsung BHT Manual de usuario

Samsung

Samsung TXH1372 Manual de usuario

Samsung

Samsung HG43AU800N Manual de usuario

Samsung

Samsung CL-21M40MQ Manual de usuario

Samsung

Samsung QN65LST9TAFXZA Manual de usuario

Samsung

Samsung TV Manual de usuario

Samsung

Samsung CS21K3DX/BWT Manual de usuario

Samsung

Samsung UE65AU6905KXXC Guía

Samsung

Samsung PN51E550 Guía

Samsung

Samsung 14F2 Manual de usuario

Samsung

Samsung HL72A650 - 72" Rear Projection TV Manual de usuario

Samsung

Samsung The Terrace LST7T Series Manual de usuario

Samsung

Samsung LN22D450G1F Manual de usuario

Samsung

Samsung 400 Series Manual de usuario

Samsung

Samsung QE55Q90R Manual de usuario

Samsung

Samsung TXN2668WHF Manual de usuario

Samsung

Samsung CFT27908X/SMS Manual de usuario

Samsung

Samsung CL-21M40MQ Manual de usuario

Samsung

Samsung AU8000 Guía

Samsung

Samsung COLOR TELEVISION Manual de usuario

Samsung

Samsung LED 7450 Guía

Samsung

Samsung CT25D4WZX/GSU Manual de usuario

Samsung

Samsung SMART TV Guía

Manuales populares de TELEVISOR de otras marcas

Philips

Philips Colour Television Manual de usuario

Toshiba

Toshiba 27A10 Manual de usuario

Philips

Philips 42PF9630A/37 Manual de usuario

Hitachi

Hitachi 32FX48B Manual de usuario

DAEWOO ELECTRONICS

DAEWOO ELECTRONICS DTQ-14V1FC Manual de usuario

Changhong Electric

Changhong Electric uhd55b6000is Manual de usuario

Philips

Philips Matchline 21CE7551 Manual de usuario

Panasonic

Panasonic Genus TX-G10 Manual de usuario

Toshiba

Toshiba 19A20 Manual de usuario

Philips

Philips 25PT4523-16 Manual de usuario

Sony

Sony XBR-100Z9D Manual de usuario

Philips

Philips PR0930X3 Manual de usuario

Philips

Philips Brilliance 231P4QPY Manual de usuario

Philips

Philips 32HF9385D Guía de solución de problemas

Sharp

Sharp LC-40FI5012E Manual de usuario

Loewe

Loewe Table Stand Reference 55 Manual de usuario

Philips

Philips 32PFH5300 Manual de usuario

Sylvania

Sylvania 6427FB Manual de usuario