Samsung RL33EBMS Manual de usuario
MODEL:
RL33EBMS
C C
SERVICESERVICE
MANUALMANUAL
Electric Refrigerator CONTENTS
PREVENTIVE ACTIONS 2
PRODUCT SPECIFICATIONS 3
ELECTRIC & COOLING PART SPEC. & CRITERION 4
FUNCTIONAL & OPERATIONAL INSTRUCTIONS 5
FUNCTIONS 10
CIRCUIT DETAILS 15
TROUBLE ANALYSIS & REPAIR SOLUTIONS 19
PART BREAKDOWN AND LIST 24
DISASSEMBLY & ASSEMBLY 33
CIRCUIT DISGRAM 39
!
1
This represents the materials with regard to the A/C circuit and spare part safety.
Prior to repair, please pull the plug out of the socket from the wall to disconnect the
power to hold the human and wealth harmless.
1-2-1.Direct plug in-and-out is recommended when replacing the relay that attaches to
the compactor lead terminal. When inserting and pulling the plug, relay wobbling
will more likely destroy the compactor terminals or relay.
1-2-2.Restart is not allowed within 5 minutes after power off. Immediate plug in-and-out
will disable the restart.
Do not make any by-pass or circuit change attempt without manufacturer's prior
suggestion.
No prelonged cable or double terminal board is recommended.
For human safety, this procut must be properly earthed. But phone lines and gas
pipes are not recommended for earthing.
!
1. PREVENTIVE ACTIONS
1-1 Safety Precautions
Only qualified technicians who have full command and knowledge of the
cooling system and safety inspection are allowed to deliver the maintenance
service as specified on the manual.
Please be sure to keep the work place ventilated and safe as this product
adopts the combustible and explosive R600a refrigerant.
1-2 Preparations Before Maintenance
This represents the materials included in the appliance maintenance.
1-3.Warning
1)Liquid AddingPipe 2)Turn off the valve core 3)Solder the pipe onto
the compactor
4) Turn on the valve
core tightly
5)Vacuumize and add liquid 6) Onload the pipe nut
1-3-1 Pay attention to the safety during maintenance as R600a refrigerant is
combustible and explosive.
1-3-2 Keep the work place well ventilated without fire source and combustible and
explosive objects arround during the maintenance of R600a refrigerator.
1-3-3 Make sure to lay the R600a clean during CYCLE maintenance (ensure the
system unblocked by inflating nitrogen under HV and LV state.)
1-3-4 Fire soldering is not allowed until the work place is ventilative without R600a
left in the CYCLE.
1-3-5 When no leakage and blocking are found by nitrogen inflation, shut the fire by
the soldering fulid pipe (valve core available at one end) at the process pipe.
1-3-6 Adding the fulid by vacuumizing the liquid pipe and screw on the nut.(no fire,
appliance, MP3, walkman and mobile phone are allowed during operation)
Note: LOCK RING is only used for pipe connection rather than pipe sealing after
adding fluid. If special tools are available for liquid releasing, lead the R600a
via pipes to the designated location.
2
1-4 Special Tools During Maintenance
1-5 Maintenance Method
3
1.Maintenance Environment
1-1 Pay attention to the safety during maintenance as R600a refrigerant is
combustible and explosive.
1-2 Keep the work place well ventilated without sparks and hot resource around
when repairing the refrigerator's cooling system. Soldering or heating are not
recommended. No smoke also.
1-3 Fire soldering is not allowed until the work place is ventilated without R600a
left in the CYCLE.
2.Refrigerant Remnants Discharging
Prior to reinjecting the refrigerant, conduct the trouble inspection. If the leaking
point is found, eject the remained R600a out.
2-1 Open the compactor back cover, reel out the two process pipes and cut them
by a knife or pilers to discharge the remained R600a refrigerant.(See figure 1)
cutting position
2.2 Leave the refrigerant for a while (about 30 minutes) and connect to the dry
nitrogen to ensure R600a refrigerant is completely discharged and the system
are unblocked. connect to the nitrogen
Gas out
3-2 Close the process pipe on the dry filter and connect the compactor's special
liquid process pipe to a vacuum pump for vacuumizing.
4.Reinjection of Refrigerant
4
3.Vacuumizing
3-1 After all the refrigerants are out, repair the leaking points and replace the driers
and process pipes. The compactor must be fitted with the special liquid process
pipes (see below figure)
Special liquid process pipe
fire soldering
4-1 When the pipe is entirely vacuumized, fill in the R600a refrigerant in the
quantity as shown on the brandplate, and weigh by the electric balance. The
injection quantity must be exact to the evel of 2g.
4-2 No fire is allowed around when adding liquid. No pocket mobile phone and
walkman are allowed during operation.
4-3 Turn on the pipe nut when finishing the liquid adding, and sort the pipes to
avoid the abnormal noise.
5
Temp control type
Temp display type Digital
Functions
Fast refrigeration
Door opening alarm
Standard run
Refrigerating off
Fast freeze
Electronic
1EA
3EA
1EA
2EA
1EA
1EA
1EA/1EA
290
90
200
595
646
1768
76
toughened glass shelf
Spotlight Lamp
Bottle guard
Milk guard
Big bottle guard
Egg guard
dairy guard
Cyclopentane
R600a(60g)
Refrigerating compartment
Bottle guard partition
Egg tray
Freeze compartment
1EA
1EA
Rl33EBMS
2. PRODUCT SPECIFICATION
Model
Volume (ISO)
Total volume
Freeze compartment
Refrigerating compartment
N.V. (L)
Size
Width (mm)
Deepth(mm)
Height(mm)
N.W. (Kg)
Cooling mode Compartment cooling
Control &
display
Shelf
Fruit& vege. Tray/partition
Drawer
Ice box
Vesicant
Refrigerant
Three-piece set
Revolving ice box
6
SPEC
Item
Model
Power
230V/50Hz
Compressor
Model
Start mode
Oil type
Evaporator
Condenser
Drying filter
Capillary
Molecular sieve XH-9
Finned
Natural convection
RSCR
Sensor
Heater
Freeze
Refrigerating
Defrost
Environmental temp
Defrost
Air heater
Return-air heater
Fuse Defrost
Defrost Defrost time
Hold time
Run capacitor
Refrigerating compartment
Model
ON temp
OFF temp
PTC relay Model
Resistance
Lamp
Freeze compartment
Gear motor Freeze
compartment
Door light switch
Fan motor
ID 0.72L2800mm
502AT
502AT
502AT
502AT
240V/15W
3-19 hours (vary with environmental temp.)
4hours 10min (first cycle)
240V 6.5W
HC-050K4 2.5A250VAC
220~240VAC,50/60Hz
MN71MNBA6(M2LA49Z)
400VAC/4.5uF
115~125
55~70
B52-120/B
7min 2 min
250V/10A,72 4
15W/220V
7W/220V
280W/220V
JIA XIPERA ZBS1115CY
QP2-12/B
9~17
HC-10
3. SPEC. AND CRITERION OF ELECTRIC & COOLING PARTS
Cooling cycle
Electric spare parts
Capacitor
Overload
protector
Rl33EBMS
A B C D E F G H I J K
G
CB
ED
A
F
J
K
H
I
RL33****
7
595 764.5 9 900 42.5 1768 646 1725 43 38.2 1161
4. FUNCTIONAL & OPERATIONAL INSTRUCTIONS
4-1 Product size
Unit:mm
Code
Model
8
C C
4-2 Part Discription & Disassembly
Pull out the shelf in the
arrow direction to
disassembly it.
Take out the foods
and pull it out in the
arrow direction
Ice box Fruit& vege. Tray/salad box Freeze compartment drawer
condensing pipe
dew proof pipe
liquid barrel
Evaporator
loop pipe
dry filter
Compressor
discharge pipe
silver welding rod soldering
silver welding rod soldering
9
4-3Cooling System Cycle Diagram
Tabla de contenidos
Otros manuales de Refrigerador de Samsung
Samsung
Samsung RF23HTED Manual de usuario
Samsung
Samsung RZ32 Series Manual de usuario
Samsung
Samsung RF21 Series Manual de usuario
Samsung
Samsung SR-L62 series Manual de usuario
Samsung
Samsung RFG29PHD SERIES Manual de usuario
Samsung
Samsung RS20BR Series Manual de usuario
Samsung
Samsung RH22H8010SR/AA Manual de usuario
Samsung
Samsung RFG293HA Manual de usuario
Samsung
Samsung SRG-058 Manual de uso y cuidado
Samsung
Samsung RB46TS154WW Manual de usuario
Samsung
Samsung RS26WUNS Guía de seguridad
Samsung
Samsung Refrigerator Manual de usuario
Samsung
Samsung RF268AB SERIES Manual de usuario
Samsung
Samsung RF267AEBP Manual de usuario
Samsung
Samsung RF261B Manual de usuario
Samsung
Samsung RT35 Manual de usuario
Samsung
Samsung SR-608EV Manual de usuario
Samsung
Samsung RL37SGPS Manual de usuario
Samsung
Samsung RT27 Manual de usuario
Samsung
Samsung RFG237 Series Manual de usuario
