Samsung MRK-A10N Guía
Receiver & Display Unit
MRK-A10N, MRK-A10UN
Air Conditioner
user & installation manual
imagine the possibilities
Thank you for purchasing this Samsung product.
EN PT
ES DE
FR EL
IT
RU
TR ZH AR
DB68-03717A-05
SOL Receiver & Display Unit_IBIM_EN_DB68-03717A-05.indd 7 2016-05-12 오전 11:21:53
EN-2
Safety Precautions
Do not attempt to install or repair this receiver & display
unit by yourself.
This receiver & display unit contains no userserviceable
parts. Always consult authorized service personnel for
repairs.
When moving, consult authorized service personnel for
disconnection and installation of the receiver & display
unit.
Ensure that the wall is strong enough to support the
weight of the receiver & display unit.
In the event of a malfunction (burning smell, etc.),
immediately stop operation, turn off the electrical
breaker, and consult authorized service personnel.
Read carefully this installation manual before installation
and check whether the receiver & display unit is installed
correctly after installation.
Must install the receiver & display unit with the wire kit
which is supplied with the unit.
The receiver & display unit must be installed according
to the national electrical rules by an installation
specialist.
When you want to disuse the receiver & display unit,
consult authorized installation center.
WARNING
Before using the receiver & display unit, read carefully this instructions.
After reading the instructions, keep this owner’s instructions and the
installation manual in a handy and safe place. If a user is changed, you must
hand over the manuals.
Never attempt to install the air conditioning system or to move the receiver &
display unit by yourself.
SOL Receiver & Display Unit_IBIM_EN_DB68-03717A-05.indd 2 2016-05-12 오전 11:21:52
EN-3
ENGLISH
CAUTION Do not use inflammable gases near the receiver &
display unit.
Do not spill water into the wired receiver & display unit.
Do not operate the receiver & display unit with wet
hands.
Do not install the receiver & display unit in a location
where it will come into contact with the combustible
gases, machine oil, sulphide gas, etc.
Do not press buttons with a pointed thing.
Do not pull or bend the receiver & display unit cable
excessively.
Do not use this receiver & display unit for other purpose.
Do not spray an insecticide or other combustible things
on the receiver & display unit.
Do not clean the receiver & display unit with benzene,
solvents or other chemicals.
Do not give a shock to the receiver & display unit or
disassemble it by yourself.
Avoid a location where acid/alkali solution or special
spray is used.
Choose a location that is dry and sunny, but not
exposed to direct sunlight. Available temperature is
between 0°C(32°F) and 39°C(102°F).
Do not give tensile strength to the cable to avoid
disconnection.
If the receiver & display unit is installed in a hospital or
other special places, it should not affect other electronic
devices.
SOL Receiver & Display Unit_IBIM_EN_DB68-03717A-05.indd 3 2016-05-12 오전 11:21:52
EN-4
View of the Receiver & Display Unit
Filter sign indicator
Fan indicator
Timer indicator
Remote control sensor
On/Off Indicator(Blue) &
defrost Indicator for heat
pump model (Red)
SOL Receiver & Display Unit_IBIM_EN_DB68-03717A-05.indd 4 2016-05-12 오전 11:21:52
EN-5
ENGLISH
Receiver & Display Unit Installation
Accessories
Receiver & display
unit (1)
PH, +, 2, M2, L10
tapped screw (4)
TH, +, 1, M4, L20
tapped screw (2)
User & Installation
Manual (1)
Wire kit [Length:
10m (32.80ft)]
1
Remove the receiver & display unit cover by using the
tab on its bottom.
2Open the receiver & display unit.
3
Connect the end of the connector wire to the receiver
& display unit and connect the other end of the wire to
the DISPLAY connector of Indoor PCB as shown in figure.
X
Do NOT keep the receiver & display unit cable with a
220V cable because the remote controller cables have
low voltage.
Receiver &
display unit
4
Secure the receiver & display unit on the wall with
two screws.
5Reassemble the receiver & display unit cover.
X The receiver & display unit must be installed by an
installation specialist.
X Before installing the receiver & display unit, ensure that
you have turned off the main power.
X All receiver & display unit cables should be installed
according to the national wiring rules and you must install
it in the wall not to be touched by users.
SOL Receiver & Display Unit_IBIM_EN_DB68-03717A-05.indd 5 2016-05-12 오전 11:21:53
SOL Receiver & Display Unit_IBIM_EN_DB68-03717A-05.indd 6 2016-05-12 오전 11:21:53
Otros manuales para MRK-A10N
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Acondicionador de aire de Samsung
Samsung
Samsung Air Conditioner Manual de usuario
Samsung
Samsung CH094EAM Manual de usuario
Samsung
Samsung MH026FAEA Manual de usuario
Samsung
Samsung RVMH060GDM3 Manual de usuario
Samsung
Samsung AWT18Q1HDA Manual de usuario
Samsung
Samsung AC TN4FEC Series Manual de usuario
Samsung
Samsung AWT18P1HBA Manual de usuario
Samsung
Samsung AQV12F2VE Manual de usuario
Samsung
Samsung AQ18WJWB Manual de usuario
Samsung
Samsung AVXDSH020CE Manual de usuario
Samsung
Samsung AQN36VFUAGM/CV Manual de usuario
Samsung
Samsung AVMHH(C) Manual de usuario
Samsung
Samsung AST30C2BB Manual de usuario
Samsung
Samsung AC FB4DEH Series Manual de usuario
Samsung
Samsung ADC4400TB Manual de usuario
Samsung
Samsung AQV12VB Series Manual de usuario
Samsung
Samsung AS07A5MA Manual de usuario
Samsung
Samsung HC175TGZA Manual de usuario
Samsung
Samsung AF MV1MAEENTC Series Guía
Samsung
Samsung AC TNCDKC Series Manual de usuario
