This information is published for experienced repair technicians only and is not intended for use by the public. It does not contain
warnings to advise non-technical individuals of possible dangers in attempting to service a product. Only experienced professional
technicians should repair products powered by electricity. Any attempt to service or repair the product or products dealt with in this
information by anyone else could result in serious injury or death. Information provided in this bulletin is subject to change or update
without notice.
10. For the newer version digital boards with the firmware version 1025 or greater it will be
necessary to make an adjustment to the 3d comb filter settings.
11. Use the joystick buttons to highlight the 3d comb output in the Option service mode menu
and set it to 1V, see figure 1 above.
CCA Adjustment Procedures
12. While in Factory mode, highlight the CCA sub
menu (option 8) and press the right joystick
button.
13. Highlight Red-x and input the Red-x value from
the card or sticker supplied with the new light
engine or color wheel, see figure 6.
14. Use the same procedure to enter Red y and Red
–Y (LV) CCA Values.
15. Use the same process to enter the green, blue and white settings from the card or sticker.
16. After you have entered all the CCA values
highlight WB SPREAD, and then press the right
joystick button. Highlight WB Spread SET the
value will change to OK when the process is
complete. (See Fig. 7)
17. Final step in the process is entering the SP Actuator setting. Use the joystick up / down
buttons on the remote control to highlight the SP Actuator submenu (option 9) in service mode
and press the right joystick button.
18. Use the joystick buttons to highlight the actuator gain and adjust it to match the value
indicated on the sticker.
Note: Consult the Samsung Service Website at (www.samsungasc.com) for the
Service Manual and other information on this product.
Light Engine Data Figure 6
WB Spread Adjustment Figure 7
