Sam4s ER-180 Manual de usuario

ER-180

Electronic Cash Register

Quick Setup Guide

For 10 Departments Model

Loading Paper

•Place paper roll in the paper

holder (D)

•Insert the paper end straight

into the paper inlet of printer

(E)

•Press “FEED” button until

the paper catches and

advances through the printer

(F)

•For use as a receipt pass the

paper through the receipt

window of the printer cover

(L)

•For use as a journal attach

paper roll to the Take up

Spool.

Keyboard Layout of ER-180

FEED

RETURN

VOID

CLERK

TAX

SALE

( + )

CHECK

Dept



Dept



Dept 8



Dept 9



Dept 10



CALC

( - )

CHARGE

Dept



C / CONV

- %

Dept



Dept



+ %

Dept 7



SUBTOTAL

CASH / TEND

( = )

CLEAR PLU

•

X/TIME

( X )

Dept 6



RCPT

ON / OFF

Get Ready (cont.)

Unpack the Cash Register

Remove the cash register from the packaging.

Locate the following items:

•1 DC power supply

•1 roll of 57mm paper (ReorderP5757)

•1 set of keys (5 keys in total)

•3 AA batteries

•1 user manual

•1 Take up spool set.

PLEASE FOLLOW THESE STEPS IN ORDER

Install Batteries

•Remove battery from the

packaging.

•Remove the battery cover

which is located where the

paper roll sits.

•Push the negative pole of

the battery against the

spring firmly.

•Push the battery into

position.

•Repeat for the second and

third batteries and then

replace the battery cover.

•Incorrect installation of

one or more batteries will

result in “E Lo 0.00”

showing on the display

when the register is

plugged into the power

point.

Get Ready

RAM (Memory) All Clear - Reset

A “RAM All Clear” will reset the register back to the

factory default settings. It is strongly recommended

that a “RAM ALL CLEAR” is preformed on all new

registers before use.

•Switch the power to the

•Insert the C key and turn to

S-Mode (a hidden position

after PGM-Mode)

•Hold down the 00 button

and power up the register.

•Release the 00 button after hearing two beeps.

“02151409” will show on the display and the printer

will print EPROM information. For example,

“yyyyyyyy, 02 15 14 09 then 1y0

”.

The “RAM All Clear” procedure is now complete

turn the key to the REG position.

After the RAM All Clear, a log in

procedure is needed in order to

use ER-180.

•The display will show

CLOSEd

•Press 1 on the 0~9 key pad

followed by the CLERK

button which is to the left of

1, the display will show

“0.00” and is now ready for

use.

DO NOT USE THE DECIMAL POINT ON THE REGISTER

WHEN ENTERING AN AMOUNT.

At this point, all 16 Departments and 100 PLUs are

preset to 10% on Tax1 (GST) and OPEN PRICE (a

price must be entered for each item sale); all PLUs

link to Department 1.

RAM All Clear

OFF

REG

VOID

PGM

OFF

REG

VOID

PGM

The ER-180 has two reporting modes, one for printing

out the information without resetting any figures; this

is referred to as the X-Mode

The second is for printing and

resetting the figures back to zero

ready for next day (End of Day),

this is referred to as the Z-Mode.

•Use either a Z, Por CKey and

turn to X-Mode or Z-Mode.

•Press one of the buttons from

the table below to print out

the required report

Button Mode Report

CASH-X or Z Financial

VOID-X or Z Financial Level 2

CHECK-X or Z Period-to-Date Financial

CHARGE-X or Z Department

CLERK-X or ZClerk

Date Programming

•Use a Por Ckey and turn to

PGM-Mode

•Enter two digits for the Day

the Month and the Year in

MMDDYY format.

For example, for 15 Jul 2011,

enter 0 7 1 5 1 1-

•Press the CHECK button to finalise programming

Time Programming

•Use a Por Ckey and turn to

PGM-Mode

•Enter two digits for the Hour

and Minutes in HHMM in 24

hours format.

For example, for 3:28pm,

enter 1 5 2 8-

•Press the CASH button to finalise programming.

Status and Preset Price Programming

After a RAM All Clear, all Departments and PLUs

default to open price. When a preset price is required

the Tax or Non Tax is part of the program sequence.

For a Department

•Use a Por C key and turn to PGM-Mode

•Enter the preset price (up to 7

digits) do not use decimal

point while entering price.

•The 8th digit is the Tax status

(please refer to the table

below)

•Press the Department you

wish to program.

For example

Five Dollars with GST would be 5001

For a PLU

•Use a Por C key and turn to PGM-Mode

•Enter PLU number followed by the PLU-button

•Enter the preset price (up to 7

digit) do not use decimal

point while entering price)

•The 8th digit is the Tax status

(please refer to the table

below)

•Press PLU button to finalise

For example.

Three dollars without GST would be 3000

8th digit When Tax is VAT,

0 Non Single Item, Tax Free

1 Non Single Item, GST

5 Single Item, Tax Free

6 Single Item, GST

¾For full list, please refer to ER-180 User Manual.

Programming Status and Price

3 Reporting

Note



OFF

REG

VOID

PGM

OFF

REG

VOID

PGM

OFF

REG

VOID

PGM

OFF

REG

VOID

PGM

OFF

REG

VOID

PGM

Otros manuales para ER-180

Otros manuales de Caja registradora de Sam4s

Sam4s

Sam4s ER-265 Manual del propietario

Sam4s

Sam4s 110 Series Manual de usuario

Sam4s

Sam4s ER-380 Guía de solución de problemas

Sam4s

Sam4s ER-180 Manual del propietario

Sam4s

Sam4s SAP-6600 Manual de usuario

Sam4s

Sam4s ER-600 Manual de usuario

Sam4s

Sam4s SPS-500 Manual de usuario

Sam4s

Sam4s ER-Series Manual de usuario

Sam4s

Sam4s ER-420M Guía de solución de problemas

Sam4s

Sam4s ER-180T Manual del propietario

Sam4s

Sam4s ER-390M Manual del propietario

Sam4s

Sam4s SAM300 Manual de usuario

Sam4s

Sam4s NR-300 Series Manual de usuario

Sam4s

Sam4s SPS-500 Manual

Sam4s

Sam4s ER-5200 Manual de usuario

Sam4s

Sam4s SPS-500 Manual de usuario

Sam4s

Sam4s SPS-300 Series Manual del propietario

Sam4s

Sam4s ER-350 Manual de usuario

Sam4s

Sam4s ER-350 II SERIES Manual del propietario

Sam4s

Sam4s ER-5200M Manual del propietario

Sam4s

Sam4s NR-510B Manual del propietario

Sam4s

Sam4s SPS-2000 Manual de usuario

Sam4s

Sam4s ER-920 Manual del propietario

Sam4s

Sam4s ER-380 Guía de solución de problemas

Manuales populares de Caja registradora de otras marcas

Royal

Royal 480nt Manual de usuario

Olivetti

Olivetti ECR 8200 S Manual de usuario

TEC

TEC TEC FS-3600 Manual de usuario

Integrated System Laboratory

Integrated System Laboratory ISL 4006 Manual de usuario

Sharp

Sharp XE-A206 Manual de lista de piezas

Samsung

Samsung ER 5215 Manual de usuario

Toast

Toast Toast Manual de usuario

Sharp

Sharp XE-A130 Guía de inicio rápido

TEC

TEC MA-600-1 series Manual de usuario

QUORION

QUORION CR 1200 Manual de usuario

Olivetti

Olivetti ECR 7700 LD eco Plus Manual de usuario

Sharp

Sharp XE-A137-WH Operation Manual rápido

Sharp

Sharp XE-A203 - Cash Register Thermal Printing Graphic Logo... Manual de usuario

TEC

TEC TEC MA-1060 Manual de usuario

Casio

Casio PCR-408 Instrucciones de montaje

ELCOM

ELCOM Euro-2100TE Manual de usuario

American Changer

American Changer CLASSIC Series Manual de usuario

Sharp

Sharp ER-2540 Manual de usuario