Süd wind Ambientika Smart Manual de usuario
_
_
_
Ambientika Smart APP
EN – CONFIGURATION AND USER MANUAL
TABLE OF CONTENTS
1. INTRODUCTION
a. DOWNLOADING THE APP 2
b. REGISTERING YOUR ACCOUNT 2
2. CONFIGURATION
a. CREATING YOUR HOME 4
b. SEARCHING FOR DEVICES 5
c. CONFIGURING YOUR DEVICES 7
d. RESETTING THE PRODUCT 11
3. ADDITIONAL CONFIGURATIONS
a. ADDING A HOME 12
b. RECONFIGURING OR REMOVING A HOME 13
c. RENAMING A HOME OR PRODUCTS 16
4. INSTRUCTIONS FOR USE
a. APP 17
5. USER PROFILE
a. USER DETAILS 25
6. FAQ 26
7. NOTES 27
2
INTRODUCTION – DOWNLOADING THE APP
Download the App from the store and install it on your smartphone.
(for iOS® devices from the App Store, for Android® devices from the Play Store)
Read the QR codes through the camera or search for the app directly in the stores.
INTRODUCTION – REGISTER YOUR ACCOUNT
To control your devices, you will need to register in the app following the directions
provided and detailed below;
1
Tap the “Register” button to create
an account.
2
Read the “Terms and Conditions”
and “Privacy Policy” and tap next.
3
3
Select the ticks to accept these (at
least the two mandatory ones) and
tap confirm.
4
Enter the requested information and
tap register.
5
Enter the code that was sent to the
email listed on the previous page.
Wait a few minutes, in case the
security code has not yet reached
you, and check your “Junk” folder, or
request a new code.
6
You can now access the APP using
the data you just entered.
4
CONFIGURATION – CREATING YOUR HOME
To set up the system you will need to have Bluetooth and Wi-Fi enabled on your phone.
To configure the system, the fan units should be connected to the power supply and powered
as per the product instructions.
Creating your own home:
1
Once you are logged in, tap “Add
new home.”
2
Enter the requested information
about the location of the home. This
is needed for data collection of
outdoor air conditions.
5
CONFIGURATION – SEARCHING FOR DEVICES
Searching for installed devices and associating them with your home Internet network:
1
Once the home is registered, the
APP will search via Bluetooth for
devices available to be configured,
which will be displayed in a list.
2
Select one of the products in the list.
3
Associate the product with the Wi-Fi
network by entering the name (if
different from the one that appears)
and password of the network.
If all products are connected to the same
Wi-Fi network, it will not be necessary to
re-enter the data on each additional
device, and you can just tap continue.
6
5
Name the device, select the room it
is in, and tap continue.
When a device is selected from the list, the
corresponding physical product will cause
the white LED to flash and beep so that it
can be identified.
6
You will need to repeat this with all
products in the list.
If more products are installed than
those in the list you will need to go
closer to them so that the phone's
Bluetooth can detect them.
7
Once all products have been
registered, tap “Proceed with
configuration.”
7
CONFIGURATION – SETTING UP THE SYSTEM
AUTOMATIC
By choosing automatic configuration, the APP autonomously decides how to configure
products according to the layout in the rooms.
The configuration of individual products can be changed manually later from the “Home
management” section in the APP.
1
Select “Automatic” from the
“Configure your devices” screen.
2
Select “Single system” if you want to
configure all installed products in one
system.
(to choose this option, skip to step 6)
Select “Zone system” if you want to
divide products over multiple zones,
(e.g., Ground floor - Floor 1 or Zone
daytime - Zone nighttime)
8
3
If you have chosen the configuration
as “Zone system” tap on the “Add
zone” button
4
Proceed by naming the first zone and
selecting the rooms you want to
enter.
Once the rooms have been selected,
tap confirm.
5
Now you need to add the other
zones, and proceed with step 3 and
4 until all rooms are associated with
a zone.
6
When all zones have been
configured, or you have chosen the
“Single system” configuration, tap
continue to configure the devices and
access the APP home screen.
Tabla de contenidos
Otros manuales de Sistema de calefacción de Süd wind
