Russell Hobbs 24440 Manual de usuario

I www.russellhobbs.com

24440

Visit uk.russellhobbs.com/product-registration You must register within 28 days of purchase

H B

o s

MAX nm

ef gij

Read the instructions, keep them safe, pass them on if you pass the iron on.

IMPORTANT SAFEGUARDS

Follow basic safety precautions, including:

This appliance can be used by children aged from 8 years and above and

persons with reduced physical, sensory or mental capabilities or lack of

experience and knowledge if they have been supervised/instructed and

understand the hazards involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be done by children unless they

are older than 8 and supervised. Keep the iron and cable out of reach of

children under 8 years.

Sit the base unit on a stable, level, heat-resistant surface, preferably a

purpose-built “steam generator” type ironing board.

Rest the iron only on the base unit.

Don’t leave the iron unattended while plugged in or standing on the

ironing board. It could be knocked over.

Don’t use the iron if it’s dropped, damaged, malfunctions or leaks.

If the cable is damaged, return the iron, to avoid hazard.

h The surfaces of the appliance will get hot.

BDon’t put the iron in liquid, don’t use it in a bathroom, near water, or

outdoors.

• Route the cable so it doesn’t overhang, and can’t be tripped over or caught.

• Don’t iron clothing while it’s being worn – you’ll burn or scald the wearer.

• Don’t touch the soleplate, and keep away from the steam coming from it.

• Don’t use the iron in the vicinity of children.

• Don’t sit the base unit on a soft, carpeted, or upholstered surface, as this may block the vents

underneath the base unit.

• Keep the cables and steam pipe away from hot parts.

• Don’t use the iron for any purpose other than those described in these instructions.

• Take care not to scratch the soleplate – avoid buttons, zips, etc.

• The iron has a protective thermal fuse, which will blow if it overheats. If this happens, the iron will

stop working, and must be returned for repair.

HOUSEHOLD USE ONLY

DIAGRAMS

1. Temperature control

2. Steam trigger

3. Steam pipe

4. Mark

5. Thermostat light

6. Reservoir

7. Hose clip

8. Plug storage

9. Resin lter (inside reservoir)

10. On/o button

11. Warning light/reset button

12. Steam Control

BEFORE FIRST USE

• Remove any labels, stickers or packaging from the iron and soleplate.

• Before using the iron for the rst time, or if it’s not been used for a long time, iron a scrap piece of

cotton (an old towel is ideal) to remove any accumulated residues.

• Don’t worry if the iron smokes a bit at rst, it will soon stop as the manufacturing residues evaporate.

AUTO SHUTOFF

If you don’t press the steam trigger for 8 minutes your iron’s auto shut-o feature will operate. The iron will

beep and the temperature light will ash to tell you that it is in auto shut-o mode. To cancel the auto

shut-o mode, press the steam trigger. Note that your iron will need time to heat up again to the selected

temperature. Wait until the temperature light has stopped ashing before resuming ironing.

FILLING/REFILLING

• Don’t add anything to the water and don’t use water with anything added to it. When the water is

converted to steam, chemicals, perfume, and other additives will coat the inside of the steam

chamber, shortening the life of the iron.

1. Remove the reservoir by pulling it away from the body of the steam generator using the grip on the

front of the reservoir .

2. Fill the reservoir to the max mark. Do not exceed the max mark.

3. Ret the reservoir into the base unit.

PRELIMINARY SETTINGS

1. Put the iron on top of the base unit.

2. Put the plug into the power socket (switch the socket on, if it’s switchable).

3. Turn the unit on by setting the on/o button to I.

4. Turn the temperature control to bring the setting you require next to the mark. The thermostat light will

ash until the iron has reached its desired temperature. Once the temperature has been reached the

light will remain on.

This will take 30-60 seconds after you rst switch on your steam station.

5. Use the steam control to select the amount of steam you want (

= low,

= high).

TEMPERATURE SELECTION GUIDE

1. Check for textile care symbols (ij kl)..

2. Iron fabrics needing low temperatures rst, then those that need medium temperatures , and nish

with those needing high temperatures (or max).

3. Turn the temperature control to bring the setting you require next to the mark.

If the instructions on the fabric label dier from this guide, follow the instructions on the label.

abel marking Dot setting

jcool – nylon, acrylics, polyester •

kwarm – wool, polyester mixtures ••

lhot – cotton, linen •••/max

ido not iron

When the soleplate reaches operating temperature, the thermostat light will stay permanently on.

STEAM IRONING

1. Set the temperature control to lor higher – otherwise the steam might condense on the soleplate,

giving you water instead of steam.

2. Use the steam control to select the amount of steam you want ( m= low, l= medium, h= high).

3. Squeeze the steam trigger to produce steam, release it to stop.

NOTE: When you rst start your steam station and pull the trigger for steam ironing, there will be a

delay as your steam station pumps water from the reservoir to prime the system. This is normal and

may take 20-30 seconds. This will also happen after relling the reservoir.

DRY IRONING

You can dry iron by just not pressing the steam button, but if you want to make sure you don’t press it

accidentally, then you should iron with an empty reservoir. You can do your dry ironing rst, then switch

o, ll the reservoir and do your steam ironing.

VERTICAL STEAMING

Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.

• Check that there’s adequate ventilation behind the fabric, otherwise moisture may build up, causing

mildew.

• Check that there’s nothing behind the fabric that may be damaged by the steam.

• Check that pockets, turn-ups, and cus are empty.

1. Check that the temperature control is at lor higher.

2. Hold the iron close to (but not touching) the fabric. Hold it well away for delicate fabrics.

We recommend using the steam trigger to produce steam for smaller areas, as it gives you better control.

AFTER USE

1. Put the iron on top of the base unit and turn the temperature control to •.

2. Turn the unit o by setting the on/o button to O.

3. Empty the reservoir.

4. Let the iron cool down completely before cleaning it, moving it, or storing it away.

5. The steam pipe can be coiled together and placed into the hose clip.

6. Wrap the mains cable around the steam generator in an anti-clockwise direction then slot the plug

into the socket (Fig C).

7. The water reservoir must be emptied when storing your steam station vertically.

CARE AND MAINTENANCE

1. Unplug the base unit, and let the appliance cool down fully.

2. Wipe outer surfaces with a damp cloth. If necessary, use a little washing-up liquid.

3. Remove spots from the soleplate with a little vinegar.

4. Take care not to scratch the soleplate

ANTISCALE CARTRIDGE

To extend the life of the appliance and to avoid problems with lime scale, your steam generator is tted

with an anti-scale cartridge. The life of the anti-scale cartridge depends on the frequency of use and the

hardness of the water in your area. In a soft water area this should be about 100 uses. Do not put any

descaling products (including vinegar) into the reservoir. This can damage the appliance.

To replace the cartridge:

1. Switch o and unplug your steam generator

2. Allow your steam generator to cool down for at least 1 hour until the soleplate is cold.

3. Remove the water tank from the front of the unit.

4. Pull the anti scale cartridge vertically out of the water tank. Note that the cartridge may contain water

when it is removed (Fig A).

5. Fit the new cartridge and push it down rmly into the water tank.

6. Rell and ret the water tank.

7. Plug in your steam generator.

8. Once the appliance is ready, pull the steam trigger until the steam is being produced. This will prime

the system.

Important: Using the appliance without changing the cartridge can cause a reduction in the generated

steam output and damage the appliance. The guarantee will not cover damage caused to the appliance by

not changing the anti- scale cartridge when required.

REPLACEMENT ANTISCALE CARTRIDGES

1. Have the appliance Model Number to hand, as we won’t be able to help you without it. It’s on the

rating plate (usually underneath the product).

2. Ring 0345 658 9700, or email service@russellhobbs.com, for prices, then purchase replacements using

VISA or MASTERCARD.

FILTER

We recommend that you remove and clean the lter every 6 uses depending on the water hardness in

your area. The warning light/reset button will ash to remind you that the lter needs cleaning. Doing this

will extend the life of the unit.

To remove the lter:

1. Unplug the appliance and let it cool down.

CAllow your steam generator to cool down for at least 1 hour until the soleplate is cold.

3. Remove the reservoir from the front of the unit. The lter is behind the reservoir.

4. Turn the lter anticlockwise and remove it (Fig B).

5. Rinse the lter under a tap.

6. Ret the lter and tighten it rmly.

7. Reset the reminder light.

T22-9001448

RECYCLING

WTo avoid environmental and health problems due to hazardous substances, appliances

and rechargeable and non-rechargeable batteries marked with one of these symbols

must not be disposed of with unsorted municipal waste. Always dispose of electrical

and electronic products and, where applicable, rechargeable and non-rechargeable

batteries, at an appropriate ocial recycling/collection point.

SERVICE

If you ring Customer Service, please have the Model Number to hand, as we won’t be able to help you

without it. It’s on the rating plate (usually underneath the product).

The product isn’t user-serviceable. If it’s not working, read the instructions, check the plug fuse and main

fuse/circuit breaker. If it’s still not working, consult your retailer.

If that doesn’t solve the problem – ring Customer Service – they may be able to oer technical advice.

If they advise you to return the product to us, pack it carefully, include a note with your name, address, day

phone number, and what’s wrong. If under guarantee, say where and when purchased, and include proof

of purchase (till receipt). Send it to:

Customer Service

Spectrum Brands (UK) Ltd

Fir Street, Failsworth, Manchester M35 0HS

email: support@russellhobbs.com

telephone: 0345 658 9700 (local rate number)

Please note: If you have purchased the product within the last 6 months, please contact the retailer in the

rst instance to deal with any matters relating to warranty.

GUARANTEE

Defects aecting product functionality appearing within the guarantee period will be corrected by

replacement or repair at our option provided the product is used and maintained in accordance with the

instructions. Your statutory rights are not aected.

Guarantee period = 2 years from rst retail purchase.

To claim an extra 1 year guarantee, register your product online within 28 days of purchase. Register at:

uk.russellhobbs.com/product-registration

Consumables are guaranteed only for their recommended lifecycle. Replacement/Spare parts* are

excluded and are only covered by a 1 year warranty.

* Examples include lters, removable grill plates, drip trays/crumb trays etc.

JONLINE

www.russellhobbs.com for more products

Tabla de contenidos

Otros manuales de Hierro de Russell Hobbs

Russell Hobbs

Russell Hobbs RHI2010BL Guía

Russell Hobbs

Russell Hobbs Steamglide Manual de usuario

Russell Hobbs

Russell Hobbs RHC455 Manual de instrucciones de instalación

Russell Hobbs

Russell Hobbs Diamond Elite Manual de usuario

Russell Hobbs

Russell Hobbs 20562-56 Manual de usuario

Russell Hobbs

Russell Hobbs Diamond Elite RHC590 Guía de instalación

Russell Hobbs

Russell Hobbs Turbo Steam RHC925 Manual de instrucciones de instalación

Russell Hobbs

Russell Hobbs RHC280 Guía de instalación

Russell Hobbs

Russell Hobbs RHC950 Manual de usuario

Russell Hobbs

Russell Hobbs 26731 Manual de usuario

Russell Hobbs

Russell Hobbs RHI2000 Guía

Russell Hobbs

Russell Hobbs Light & Easy Brights Manual de usuario

Russell Hobbs

Russell Hobbs Light and Easy Brights 24820-56 Manual de usuario

Russell Hobbs

Russell Hobbs steamXpress RHC901 Guía

Russell Hobbs

Russell Hobbs Easy 20330-56 Manual de usuario

Russell Hobbs

Russell Hobbs Steam Iron Manual de usuario

Russell Hobbs

Russell Hobbs 20630-56 Manual de usuario

Russell Hobbs

Russell Hobbs SMOOTH IQ PLUS RHC700 Manual de instrucciones de instalación

Russell Hobbs

Russell Hobbs RHI101 Guía de instalación

Russell Hobbs

Russell Hobbs Light and Easy Brights 24840-56 Manual de usuario

Russell Hobbs

Russell Hobbs 26483-56 Manual de usuario

Russell Hobbs

Russell Hobbs 20630 Manual de usuario

Russell Hobbs

Russell Hobbs RHC450 Manual de instrucciones de instalación

Russell Hobbs

Russell Hobbs 26020-56 Manual de usuario

Manuales populares de Hierro de otras marcas

Clatronic

Clatronic DB 3703 Manual de usuario

TEFAL

TEFAL FV4093Z0 Manual de usuario

Gorenje

Gorenje SIH 2200 BS Manual de usuario

Philips

Philips GC6012 Manual de usuario

Bosch

Bosch 2 Series Manual de usuario

Riffel

Riffel Catena KB-819 Manual de usuario

Texi

Texi Hestia Manual de usuario

Maxwell

Maxwell MW-3010 Manual de usuario

TREVIDEA

TREVIDEA Girmi ST60 Manual de usuario

Philips

Philips HI5914/30 Manual de usuario

Primula

Primula Vapormat Manual de usuario

Magio

Magio MG-541 Manual de usuario

Scarlett

Scarlett SC-1334S Manual de usuario

Bosch

Bosch Sensixx B22L Manual de usuario

Philips

Philips GC651 Manual de usuario

Vitek

Vitek VT-1247 VT Manual de usuario

Cleanmaxx

Cleanmaxx 3397 Manual de usuario

Philips

Philips GC800 Manual de usuario