RuggedCom RUGGED VDSL RS910L Manual de usuario

RuggedCom Inc. I30 Whitmore Road, Woodbridge, Ontario, Canada L4L 7Z4

Tel: (905) 856-5288 I Fax: (905) 856-1995 IToll Free: (888) 264-0006

Rugged

RuggedRugged

RuggedVDSL

VDSLVDSL

VDSL





RS9

RS9RS9

RS91

Serial and Ethernet Device Server with Ethernet over VDSL

Uplink

Installation Guide

www.ruggedcom.com

Federal Communications Commission

Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device

pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications

Operation of this equipment in a residential area is likely to cause harmful interference in which

case the user will be required to correct the interference at his expense

Trademarks:

Ethernet is a trademark of Xerox Corporation

RuggedSwitch, RuggedRated, ROS and eRSTP are trademarks of RuggedCom® Inc

Caution

This product contains a laser system and is classified as a “CLASS 1 LASER PRODUCT”

Use of controls or adjustments or performance of procedures other than those specified herein

may result in hazardous radiation exposure This product contains no user serviceable parts

Attempted service by unauthorized personnel shall render all warranties null and void

Should this device require service see the “Warranty” section of this installation guide

Important

This unit should be installed in a restricted access location where access can only be gained by

service personnel or users who have been instructed about the reasons for the restrictions

applied to the location and about any precautions that shall be taken; and access is through the

use of a tool or lock and key, or other means of security, and is controlled by the authority

responsible for the location

Table of Contents

1Product Overview ............................................................................................................................... 5

1.1 Functional Overview ................................................................................................................... 5

1.2 Feature Highlights ...................................................................................................................... 5

1.3 RS910L Front Panel Description ................................................................................................ 6

1.4 RS910L Bottom Panel Description.............................................................................................. 7

2Installation........................................................................................................................................... 8

2.1 Din Rail Mounting....................................................................................................................... 8

2.2 Power Supply Wiring and Grounding ......................................................................................... 9

2.3 Failsafe Output Wiring.............................................................................................................. 12

2.4 RS232 Console Port Wiring ...................................................................................................... 13

3Serial Ports ........................................................................................................................................ 14

4Ethernet Ports ................................................................................................................................... 18

4.1 RJ11 Ethernet over VDSL Port ................................................................................................. 18

4.2 RJ45 Ethernet Ports .................................................................................................................. 20

4.3 Fiber Optic Ethernet Ports........................................................................................................ 21

4.4 Ethernet Panel Description ....................................................................................................... 22

5Technical Specifications ................................................................................................................... 23

5.1 Operating Environment............................................................................................................. 23

5.2 Power Supply Specifications ..................................................................................................... 23

5.3 Failsafe Relay Specifications .................................................................................................... 23

5.4 RJ11 Ethernet over VDSL Port Specifications .......................................................................... 24

5.5 Serial Ports................................................................................................................................ 24

5.6 Ethernet Ports............................................................................................................................ 25

5.7 Communication Standards ........................................................................................................ 25

5.8 Mechanical Specifications......................................................................................................... 26

6Type Tests.......................................................................................................................................... 27

6.1 IEC 61850-3 Type Tests ............................................................................................................ 27

6.2 IEEE 1613 Type Tests ............................................................................................................... 28

6.3 IEC Environmental Type Tests.................................................................................................. 28

7Warranty ........................................................................................................................................... 29

Table of Figures

Figure 1 - RS910L Front Panel Description............................................................................................... 6

Figure 2 - RS910L Bottom Panel Description ............................................................................................ 7

Figure 3 - RS910L DIN Rail Mounting....................................................................................................... 8

Figure 4 - RS910L Power Supply Inputs.................................................................................................... 9

Figure 5 - DC Power supply wiring and grounding diagram ................................................................. 10

Figure 6 - Dielectric Strength Testing....................................................................................................... 11

Figure 7 - RS910L Failsafe Output Relay ................................................................................................ 12

Figure 8 - RS232 Female DCE pin-out ..................................................................................................... 13

Figure 9: Fiber Serial Interface (ST Connector) ..................................................................................... 14

Figure 10: DB9 Port pin-out...................................................................................................................... 15

Figure 11: RJ45 Port pin-out..................................................................................................................... 16

Figure 12: Conceptual recommended RS485 wiring diagram ............................................................... 17

Figure 13 - RJ11 port pin-out and LEDs.................................................................................................. 18

Figure 14 - RJ45 Ethernet port pin-out.................................................................................................... 20

Figure 15: 10FL ST connector.................................................................................................................. 21

Figure 16: 100FX MTRJ connector ......................................................................................................... 21

Figure 17: 100FX ST connector ............................................................................................................... 21

Figure 18: 100FX LC connector............................................................................................................... 22

Figure 19: 100FX SC connector ............................................................................................................... 22

Figure 20: Ethernet panel LED description ............................................................................................ 22

Figure 21 - Mechanical Specifications ...................................................................................................... 26

Table of Tables

Table 1 - Status LEDs................................................................................................................................... 6

Table 2 - RJ11 port pin-out ....................................................................................................................... 18

Table 3 - RJ11 port LED description........................................................................................................ 18

Table 4 - Typical Performance on 24 AWG PIC twisted-pair................................................................ 19

Table 5 - RJ45 Ethernet port pin-out ....................................................................................................... 21

Table 6 - Operating Environment............................................................................................................. 23

Table 7 - Power Supply Specifications...................................................................................................... 23

Table 8 - Failsafe Relay Specifications...................................................................................................... 23

Table 9 – RJ1 Ethernet over VDSL Port Specifications ......................................................................... 24

Table 10: Copper Port Specification......................................................................................................... 24

Table 11: Fiber Optic Port Specification.................................................................................................. 24

Table 12: Ethernet Ports - Copper Specifications ................................................................................... 25

Table 13: Ethernet Ports – Fiber Optic Specifications........................................................................... 25

Table 14 - Communication Standard Compliance .................................................................................. 25

Table 15 - Mechanical Specifications........................................................................................................ 26

Table 16 - IEC 61850-3 Type Tests ........................................................................................................... 27

Table 17 - IEEE 1613 Type Tests .............................................................................................................. 28

Table 18 - Environmental Type Tests....................................................................................................... 28

1 Product Overview

1.1 Functional Overview

The RuggedVDSLTM RS910L is an industrial hardened serial server and managed Ethernet switch

su orting Ethernet over VDSL (EoVDSL). The RS910L can be configured with 2 serial orts

(RS485/RS422/RS232/fiber) and/or 2 Ethernet orts (co er or fiber). The RS910L can

interconnect multi le ty es of intelligent electronic devices (IEDs) that have different methods of

communications. The EoVDSL ort allows for aggregation of these devices at a remote location

back to the central control room using existing tele hone grade cable (or other legacy serial

cabling). The EoVDSL u link allows u to 4km LAN segments at u to 50 Mb s.

1.2 Feature Highlights

•Interface Ports

o1 Ethernet over VDSL (EoVDSL) interface

o2 Serial and/or 2 Fast Ethernet Ports

oRS485/RS422/RS232 Serial Ports (DB9 and RJ45)

oSerial Fiber Interface (ST) available

o10/100BaseTX or 100BasesFX Ethernet orts

•Ethernet Over VDSL Port Characteristics:

oU to 4 km LAN segments

oSymmetric data rates u to 50 Mb s

oAutomatically selects fastest data rate based on distance and quality of cable

oSoftware selectable to be master or slave

oFrequency Division Multi lexing (FDM)

1.3 RS910L Front Panel Description

Failsafe Relay Power Port

Ports 1 & 2

RS485/422/232

Serial

Serial over Fiber

Ports 3 & 4

10/100Base-T

100Base-F

10Base-FL

Port 9

Ethernet over VDSL

Power & Alarm

Figure 1 - RS91 L Front Panel Description

Status LED Colour Activity Comments

Power LED Green Solid Power On

Alarm LED Red Solid Alarm condition exists

Table 1 - Status LEDs

1.4 RS910L Bottom Panel Description

Failsafe Relay

Console Port

Power

Port

Chassis

Ground

Optional Din-Rail

Mounting Bracket

Figure 2 - RS91 L Bottom Panel Description

2 Installation

2.1 Din Rail Mounting

An o tional DIN rail mounting bracket is available for the RS910L. The figure below details

mounting instructions for the standard 1” DIN Rail.

Figure 3 - RS91 L DIN Rail Mounting

2.2 Power Supply Wiring and Grounding

2.2.1 AC Power Supply Wiring and Grounding

Figure 4 - RS91 L Power Supply Inputs

The RS910L AC ower su ly in uts should be connected as follows:

1. +/L should be connected to AC Line/Hot.

2. -/N should be connected to AC Neutral.

3. Surge Ground should be connected to the Chassis Ground via a braided cable or other

a ro riate grounding wire. Surge Ground is used as the ground conductor for all surge

and transient su ression circuitry internal to the unit.

4. Chassis Ground must be connected to the AC ground terminal.

NOTES:

1. Equi ment must be installed according to the a licable country wiring codes.

2. All line-to-ground transient energy is shunted to the Surge Ground terminal. In cases

where users require the in uts to be isolated from ground, remove the ground braid

between Surge and Chassis Ground. Note that all line-to-ground transient rotection

circuitry will be disabled.

2.2.2 DC Power Supply Wiring and Grounding

Figure 5 - DC Power supply wiring and grounding diagram

The RS910L low voltage DC ower su ly features reverse olarity rotection and dual

inde endent in uts. The latter feature allows the connection of two DC sources with the same

nominal voltage to rovide redundant ower su ly in uts.

The RS910L DC ower su ly in uts should be connected as follows:

1. Connect to the DC in uts according to the olarity markings on the unit.

2. Surge Ground should be connected to the Chassis Ground via a braided cable or other

a ro riate grounding wire. Surge Ground is used as the ground conductor for all surge

and transient su ression circuitry internal to the unit.

3. Chassis Ground must be connected to the rotective earth.

NOTES:

1. Equi ment must be installed according to the a licable country wiring codes.

2. All line-to-ground transient energy is shunted to the Surge Ground terminal. In cases

where users require the in uts to be isolated from ground, remove the ground braid

between Surge and Chassis Ground. Note that all line-to-ground transient rotection

circuitry will be disabled.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Hardware de red de RuggedCom

RuggedCom

RuggedCom RUGGEDMAX WIN7000 Manual de usuario

RuggedCom

RuggedCom RUGGEDBACKBONE RX1510 Manual de usuario

RuggedCom

RuggedCom RuggedMAX WiN7013 Manual de usuario

RuggedCom

RuggedCom RuggedServer RS416 Manual de usuario

RuggedCom

RuggedCom RuggedWireless RS900W Family Manual de instalación y operación

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario