Rosen AV7700 Manual de usuario
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide
AV7700 Installation Guide
Chrysler/Dodge/Jeep
NOTICE OF INTENDED INSTALLATION AND USE
ROSEN ENTERTAINMENT SYSTEMS VIDEO PRODUCTS ARE NOT INTENDED FOR VIEWING
BY THE DRIVER, AND ARE TO BE INSTALLED ONLY TO BE VIEWED BY REAR-SEAT
OCCUPANTS.
IMPROPER INSTALLATION COULD DISTRACT THE DRIVER OR INTERFERE WITH SAFE
OPERATION OF THE VEHICLE, WHICH COULD RESULT IN SERIOUS INJURY OR DEATH,
AND COULD ALSO VIOLATE STATE LAW.
ROSEN ENTERTAINMENT SYSTEMS DISCLAIMS ANY LIABILITY FOR ANY BODILY INJURY
OR PROPERTY DAMAGE THAT MAY RESULT FROM ANY IMPROPER OR UNINTENDED
INSTALLATION AND/OR USE.
STOP
Damage to the vehicle may occur
Do not proceed until process has been completed
CAUTION
CAUTION
Process must be carefully observed in order to reduce
the risk of damage to the accessory or vehicle
CRITICAL
Process must be carefully observed in order to ensure a
quality installation
TOOLS and EQUIPMENT
Specific tools and equipment recommended for this
process
SAFETY RISK
Observe safe practices, this process can be dangerous
and there is a risk of personal injury
TESTING and TROUBLESHOOTING
Content specific testing and troubleshooting points
AV7700 Chrysler/Dodge/Jeep Seat Back Headrest Solution
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 2
PREPARING FOR THE INSTALLATION
Before you start, please read these critical steps below
STEP
1
BEFORE YOU START THE
INSTALLATION,
READ THIS GUIDE!
VISIT
Rosen Dealer Central
For the latest Updates, Corrections and Technical
Tips about this product and installation
www.RosenDealerCentral.com
CHECK THE BATTERY
Test the battery voltage to make sure it’s fully
charged to a minimum of 12.8 VDC
This only takes seconds and can save hours of
troubleshooting later.
TURN THE VEHICLE
OFF
Keep the Vehicle Off during the installation to
avoid setting various Vehicle Fault sensors
Keep the Vehicle OFF during the
installation
Failure to follow this may cause the AIRBAG
FAULT SENSOR to become enabled. Dealer
Service Departments charge a significant fee to
reset the Fault Sensor.
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 3
Prepare Electronics
You will need to install the vehicle specific mounting brackets.
The following steps will guide you through this process
Note: 2011 Jeep Grand Cherokee Shown
STEP
2
Locate hardware mounting kit.
(Part# CY100B contents shown)
Locate clean, non-abrasive working surface to
prepare the headrest units and proceed to
mount brackets.
Proper mounting bracket position is at 150mm
spacing which is shown below.
See Below for more details
Attach mounting brackets to electronics by using 4 supplied screws
Spacing for this application will be 150mm.
Use image below as a reference.
= Screw Location
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 4
Routing Cable Through Headrest Bracket
You will need to route the cable through the headrest bracket. The following steps will guide you
through this process
Note: 2011 Jeep Grand Cherokee Shown
STEP
3
Place the AV7700 electronics system on clean flat
surface.
Route cables through rectangular slots in
mounting brackets. (Shown Right)
Note: Critical process for proper cable routing
during installation
Attach Color-Matched Back Covers
Attach back covers to AV7700 electronics
STEP
4
Each AV7700 kit is supplied with color-matched
back cover based on application ordered
Align back cover with AV7700 mounting holes and snap into place
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 5
Steps For Assembling Bushings
Below are steps to prepare bushings for installation into vehicle
Note: 2011 Jeep Grand Cherokee Shown
STEP
5
Step A
Push down on seat material around post guide (shown below) to determine if locking tabs
need to be removed or if they need to remain intact.
(Use steps below to determine what mods need to be done based on vehicle)
Step B
Remove tabs as needed based on your vehicle’s post guide dimensions.
Tabs highlighted in Green
Step C
Identify all 4 bushings. Notice that each piece is numbered. 1-4
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 6
CAUTION
CAUTION
CAUTION
Installing AV7700 Electronics
You will need to install the AV7700 electronics and route the cable through the seat backs. The
following steps will guide you through this process.
Note: 2011 Jeep Grand Cherokee Shown
STEP
6
Pull at bottom of seatback to remove.
Seatback released
Seatback removed
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 7
CAUTION
CAUTION
CAUTION
CAUTION
Back of seat showing SRS headrest cable
Caution: Do NOT unplug this cable at any
time
Both seatbacks removed
Use long zip tie to route cable into seat.
Go forward and route between seat frame and
front seat foam
Cables routed
Assemble bushings and install as shown at right.
Bushings 1 & 2 are for left post guide
Bushings 3 & 4 are for right post guide
Assemble bushings and install as shown at right.
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 8
CAUTION
CAUTION
CAUTION
A
V7700 electronics seated in bushings that were
assembled in previous step.
Lock in AV7700 electronics using small set
screws included in hardware package.
Locate proper power source underneath
passenger seat.
14 gauge pink w/ green stripe is 12volt switched
12 gauge black for ground
Power and ground shown at right
Mount interface module underneath
passenger seat
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 9
Test System for full functionality
Install Complete
Routing Harnesses and Making Connections
You will need to route the harnesses and make the power connections to the
vehicle.
Proper routing of cables is crucial to making sure cables do not get damaged
STEP
7
This system requires a minimum of 12V (+) ACC Switched and Ground (-) to operate. The
12V (+) ACC Switched source must be capable of supplying a minimum of 7A.
Installation Guide AV7700
Rosen Entertainment Systems Copyright 2011 All Rights Reserved
AV7700 System Installation Guide AP2004-CY Rev A
Page 10
Wiring Diagram STEP
8
Otros manuales para AV7700
4
Tabla de contenidos
Otros manuales de Sistema de vídeo para coche de Rosen
Rosen
Rosen ClearVue Ultra Manual de usuario
Rosen
Rosen Necvox DVA310X Manual de usuario
Rosen
Rosen DS-TY10A0 Toyota 4-Runner Manual de usuario
Rosen
Rosen AV7500 Manual de usuario
Rosen
Rosen AC3003 Manual de usuario
Rosen
Rosen GM SERIES DS-GM0710 Manual de usuario
Rosen
Rosen DA-7169 Guía de inicio rápido
Rosen
Rosen AV7700 Manual de usuario
Rosen
Rosen Rosen inVUE II Manual de usuario
Rosen
Rosen DS-TY0820-H11 Manual de usuario
Rosen
Rosen T8 Guía de referencia
Rosen
Rosen AV-BW0801-B21 Manual del propietario
Rosen
Rosen R5505 Manual de programación
Rosen
Rosen M10 Manual de usuario
Rosen
Rosen 10.2” Overhead All-In-One DVD/CD/MP3 System Manual de usuario
Rosen
Rosen AV7500 Manual de usuario
Rosen
Rosen CV1005 Manual de usuario
Rosen
Rosen DA-7169 Guía de inicio rápido
Rosen
Rosen UN7000 Manual de programación
Rosen
Rosen DS-TY0830-H11 Manual de usuario
