Roksan Audio Corus2 Guía
Corus2
Stylus
User & Installation
Manual
Thank you for purchasing this Roksan Corus2 stylus.
REPLACING THE STYLUS
1. The stylus needs to be removed with the cartridge still attached
to the tonearm. It is advisable, but not necessary to remove the
platter to give more room when swapping stylus.
2. Remove the stylus housing by holding the cartridge body and
stylus housing and pulling them apart vertically as shown below.
3. Ensure the stylus guard is in place on the new stylus housing align
the stylus under the cartridge and press into place.
The lifetime of the stylus is approximately 800 - 1000hours.
4. You may wish to recheck the alignment of the cartridge using a
tonearm alignment protractor.
5. Conrm the tracking weight is 2g using a stylus balance gauge.
6. Raise the stylus guard prior to playing any records.
SAFETY PRECAUTIONS
• Keep the product away from small children to avoid accidents.
• Do not put the stylus in a location where it is exposed to direct
sunlight, near heating devices, or in places with high temperatures,
high humidity, or high concentrations of dust.
• Do not touch the stylus cantilever to avoid damage.
• Do not subject the stylus to strong impact.
CARE
Use a stylus brush to remove dirt and dust from the stylus tip. Always move
the brush in the direction in which the record rotates. Clean the record
using a record cleaning brush before playing.
For more information visit roksan.com
Please visit roksan.com/videos/Corus2
or scan this QR code to view the
installation video
Otros manuales de Accesorios de Roksan Audio
