Connued on the reverse, please turn over.
Lithium Iron Phosphate (aka LFP or LiFePO4) baeries are widely considered to be extremely safe and dependable. Roamer only use brand
new, factory original grade A cells purchased directly from top er manufacturers. We also record all serial numbers for full traceability.
Roamer have taken every precauon to ensure that our baeries are as safe as possible to give you peace of mind while using our products to
power your adventures.
The Roamer Baery Management System connuously monitors current draw, voltage, and temperature within the baery to catch the early
warning signs of a problem. The acve balancer ed in your baery ensures that the cells experience equal load, meaning no one cell is
stressed more than another, minimising the risk of a wear-and-tear related problem.
Several passive protecon measures are also in place such as re-retardant materials in the case and internal structure, and pressure relief
valves on the cells to carefully manage vapour release events.
No baery is 100% safe however, and cauon should always be taken when handling or operang equipment containing, or connected to,
high-capacity energy storage devices.
1. Always read the instrucon manual before using the baery or equipment and retain the original product literature for
future reference.
2. Do not dismantle, open, crush, incinerate, electrocute, or otherwise alter the baery.
3. Do not use a baery which is deformed, discoloured, leaking or otherwise abnormal.
4. Do not subject the baery to mechanical shock including being dropped, or having other objects dropped on or collide
with it. If mounted in a vehicle, the baery must be restrained securely and insulated from excessive vibraon.
5. Do not expose the baery to excessive cold, heat sources, or re. Avoid storing the baery in direct sunlight. An air gap
or insulang material should be posioned between the baery if it rests directly against cold surfaces.
6. Keep the baery clean, dry, and away from sources of liquid.
7. Do not short-circuit the baery. Do not store the baery without protecon over the terminals, or in an unprotected or
unlabelled box. Do not place in contact with conducve materials or liquids.
8. Mistreated baeries can present a risk of electrical, thermal, or chemical burns.
9. Keep the baery out of the reach of children and away from animals.
10. In the event of a cell or baery leak, do not allow any liquid or debris to come in contact with the skin or eyes, avoid
ingesng any liquid or debris, and avoid inhaling vapours.
11. If contact has been made, ush the aected area connuously with water and seek medical advice. If vapours have
been inhaled or liquid or debris ingested, remove the casualty to an area with fresh air and seek medical advice.
12. Large baeries can be extremely heavy and appropriate care should be taken when handling them.
13. The baery should not be handled or installed by children. Small component parts present a choking hazard.
14. The baery should be installed by competent persons. Insulated electrical tools must be used.
15. Do not remove the baery from its original packaging unl required for use.
16. Do not mix baeries of dierent manufacturers, capacies, voltages, or types.
17. A smoke and/or heat alarm should be installed in the same compartment as the baery.
18. Strictly observe the posive (plus, +) and negave (minus, −) marks on the baery and equipment, and ensure
connecons are made with the correct polarity.
19. The baery terminals should be connected using the provided connecon hardware to the recommended torque
rang.
20. Only a single cable connecon should be aached to the baery terminals. Busbars should be used if mulple cables of
the same potenal are required.
21. Voltages of greater than 85V across the baery terminals will cause serious malfuncon even if the baery is in charge
protecon mode. If the system in which the baery is installed includes solar panels which operate above this voltage,
addional protecon should be installed to migate the risk of direct connecon.
