Cart Assembly Instructions (continued)
Step 4 Install The Handlebar
1. Insert the bolts with the heads and washers on the outside as
shown. The nuts go on the inside with no washers.
2. Before Tightening see the section on battery selection.
3. When tightening, hold the nut and turn the bolt, (turning the
nut will damage the powder coating.)
Transport Rack Assembly Instructions
Step 1 Attach Release Handle
1. Install the orange rod
through the black
bracket and orange
dog as shown. The end
of the rod must stick
all the way through
the black bracket ¼ to
½ inch.
2. Tighten the bolt. (It
must be very tight.)
Note: The rod can be
installed from either side.
Step 2 Attach Bottom Bracket
1. Latch the Transport Rack onto the
cart.
2. Adjust the bottom hook bracket
tight to the bottom rod on the cart,
hold in place as you tighten the
bolts.
3. Make sure the carriage bolts are
very tight.
Bottom hook bracket slides
up tight to the rod on the
cart. Hold in place as you
tighten the bolts.
Bottom rod on cart
This bolt
must be
very tight
Bottom hook bracket
