RIGHT ANGLE NewCrank SPLIT WORKSURFACE CRANK HEIGHT ADJUSTABLE... Manual de usuario

NewCrank SPLIT WORKSURFACE CRANK HEIGHT ADJUSTABLE WORKSTATION

HARDWARE PACK # 52226 PAGE 1 OF 2

SLIDING THE OTHER END OF

THE HEX ROD INTO THE HEX DRIVE ON THE COLUMN ASSEMBLY. YOU MAY

NEED TO TURN THE CRANK ON THE LEFT HAND COLUMN ASSEMBLY TO ALIGN

ERSION DATED: 3/6/12

STEP 2:

HARDWARE QUANTITIES MAY VARY

SURFACE.

COLUMN ASSEMBLY

THE HOLES IN THE WORKSURFACE SUPPORT WITH THE PILOT HOLES IN THE WORK-

THE INNER COLUMN MUST FACE THE CENTER OF THE WORKSTATION. ALIGN

PLACE THE LEFT HAND COLUMN ASSEMBLY

ON THE WORKSURFACE

AS SHOWN. THE HEX DRIVE AT THE TOP OF

LEVEL 2

INSERT THE END OF THE HEX ROD

TAPE MEASURE

ALLEN WRENCH PROVIDED

7/ 2" HEX HEAD DRIVER BIT OR

#2 SQUARE HEAD DRIVER BIT

INTO THE HEX DRIVE ON THE LEFT

#2 PHILLIPS HEAD DRIVER BIT OR

CORDLESS DRILL

(THE ASSEMBLY WITH THE

HAND COLUMN ASSEMBLY

CRANK) ON THE WORKSURFACE

TOOLS REQUIRED FOR ASSEMBLY:

ASSEMBLY INSTRUCTIONS:

STEP 1: LAY THE FIXED WORKSURFACE 1 ON A PROTECTED SURFACE WITH THE

PILOT HOLES FACING UP.

AS FAR AS IT WILL GO. PLACE THE RIGHT HAND

STEP 3:

THE HEX ROD WITH THE HEX DRIVE. ALIGN THE HOLES IN THE WORKSURFACE

SUPPORT WITH THE PILOT HOLES IN THE WORKSURFACE.

INSTRUCTION # 52639

ITEM # PART # DESCRIPTION QTY.

1 VARIES NewHeights FIXED WORKSURFACE 1

2 VARIES NewCrank LEFT HAND COLUMN ASSEMBLY 1

VARIES NewCrank RIGHT HAND COLUMN ASSEMBLY 1

4 VARIES NewCrank HEX ROD 1

5 VARIES NewHeights CROSS SUPPORT 1

6 52477 /8 INTERIOR TOOTH STAR WASHER 4

7 52470 /8-16 x /8 BUTTON HEAD SOCKET SCREW 4

8 800411 NewHeights/HOVER END CAP 2

9 51708 M5 x 18mm SQ/PH/WSHR HEAD WOOD SCREW 16

10 50219 NewHeights SWING ARM ( 00SW) 1

11 VARIES NewHeights MOVABLE WORKSURFACE 1

12 52498 7/ 2" ALLEN WRENCH 1

6703 ZINSER ST., SCHOFIELD, WI 54476

PHONE: 800.298.4351 FAX: 866.882.9475

.raproducts.com

K&A MANUFACTURING

HEX

DRIVE

SUPPORT

WORKSURFACE

STEPS 1-3

READ ALL THE INSTRUCTIONS BEFORE BEGINNING

DO NOT OPERATE THE UNIT UNTIL IT IS FULLY ASSEMBLED

OR CASTER

OR COUNTER-CLOCKWISE TO LOWER IT. FOLD

WORKSURFACE TO THE DESIRED HEIGHT AND ANGLE.

THE CRANK HANDLE BACK UNDER THE FIXED WORKSURFACE. ADJUST THE MOVABLE

WORKSURFACE

SUPPORT

STEP 8: WITH THE HELP OF AN ASSISTANT, SET THE WORKSTATION UPRIGHT IN ITS

FINAL LOCATION. LEVEL THE WORKSTATION IF REQUIRED BY TURNING THE LEVELING

GLIDES CLOCKWISE (FROM THE TOP) ON THE LOW CORNERS OF THE UNIT. IF YOUR

WORKSTATION HAS CASTERS, TURN THE BOLTS AT THE TOP OF THE CASTERS CLOCK-

WISE TO LEVEL THE UNIT.

TO OPERATE: DROP THE MOVABLE WORKSURFACE 11 USING THE INSTRUCTIONS

THAT CAME WITH THE SWING ARM 10 . UNFOLD THE CRANK. TURN IT CLOCKWISE

TO RAISE THE FIXED WORKSURFACE 1

LEVELING GLIDE

FOOT

DETAIL A

PRE-INSTALLED

T-SLOT PLATE

STEPS 4-6

6703 ZINSER ST., SCHOFIELD, WI 54476

PHONE: 800.298.4351 FAX: 866.882.9475

.raproducts.com

VERSION DATED: 3/6/12

K&A MANUFACTURING

PAGE 2 OF 2

STEP 4: WITH THE HELP OF AN ASSISTANT, PLACE (4) STAR WASHERS

6 ON (4) SOCKET SCREWS 7 . INSERT

THESE THROUGH THE HOLES AT THE ENDS OF THE CROSS SUPPORT 5 AND THREAD THEM INTO THE T-SLOT

PLATE THAT IS PRE-INSTALLED IN THE SLOT IN THE COLUMN ASSEMBLIES

2 AND 3 . SEE DETAIL A BELOW.

DO NOT FULLY TIGHTEN.

STEP 5: LEVEL THE CROSS SUPPORT 5 AT 4" FROM THE BOTTOM OF THE WORKSURFACE SUPPORT AND FULLY

TIGHTEN THE SOCKET SCREWS 7 . SEE THE DETAIL BELOW. SPECIAL EXCEPTION: ON WORKSTATIONS ON WHICH

THE LifeBalance STATION IS BEING INSTALLED, THE CROSS SUPPORT SHOULD BE INSTALLED RESTING ON THE FEET

OF THE COLUMN ASSEMBLIES TO ALLOW FOR CLEARANCE OF THE E UIPMENT.

STEP 6: ALIGN THE HOLES IN THE WORKSURFACE SUPPORTS WITH THE PILOT HOLES IN THE WORKSURFACE

1 .

ATTACH THE WORKSURFACE SUPPORTS TO THE WORKSURFACE USING (16) WOOD SCREWS

9 . DO NOT OVER-

TIGHTEN THE SCREWS. USE A LOW TORQUE SETTING ON THE DRILL.

STEP 7: PLACE THE MOVABLE WORKSURFACE 11 ON THE PROTECTED SURFACE IN FRONT OF THE FIXED WORK-

SURFACE 1 KEEPING A 1/2" SPACE BETWEEN THE WORKSURFACES. PLACE THE SWING ARM

10 ON THE WORK-

SURFACES. ALIGN THE HOLES IN THE SWING ARM AND RELEASE PADDLE WITH THE PILOT HOLES IN THE WORK-

SURFACES. ATTACH THE SWING ARM USING THE INSTRUCTIONS THAT CAME WITH THE ARM. THE SCREWS ARE

INCLUDED WTH THE ARM.

(SEE EXCEPTION IN STEP 5)

LOCATING THE CROSS SUPPORT

BOTTOM OF

WORKSURFACE

SUPPORT

4.00

STEP 7

Otros manuales de De oficina de RIGHT ANGLE

RIGHT ANGLE

RIGHT ANGLE NewFixed 3-LEG WORKSTATION Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights 4 NFD Series Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewCrank 3.5 Series Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights 4 NZP Series Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights 4 Bonita ET Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights ELECTRIC HEIGHT ADJUSTABLE... Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewCrank 3-LEG CRANK HEIGHT ADJUSTABLE... Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights Series Manual de usuario

RIGHT ANGLE

RIGHT ANGLE R-STYLE PLAN 1 WORKSTATION Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights Series Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights 4 Series Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights SPLIT WORKSURFACE ELECTRIC HEIGHT ADJUSTABLE... Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights RECTANGULAR 3-LEG WORKSTATION Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewFixed HEIGHT WORKSTATION Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights 4 FD Series Manual de usuario

RIGHT ANGLE

RIGHT ANGLE NewHeights Elegante XT Series Manual de usuario

RIGHT ANGLE

RIGHT ANGLE R-STYLE PLAN 110 Manual de usuario

Manuales populares de De oficina de otras marcas

HP m9060n - Pavilion - Elite Hoja de especificaciones

Asus

Asus E210 Series Manual de usuario

Dell

Dell Inspiron 600m Manual de usuario

Dell

Dell Inspiron 3662 Manual de usuario

TotalFlow

TotalFlow uFLO Manual de usuario

HP Presario SV7000 - Desktop PC Manual de usuario

HP ProDesk 400 G5 Manual

Logitech

Logitech MK320 Manual de usuario

Dell

Dell XPS 730 H2C Manual de usuario

Sony

Sony Vaio Series Manual de usuario

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manual de usuario

Alto

Alto MD 250 Manual de usuario

Lenovo

Lenovo ThinkCentre Edge 72 Manual

Lenovo

Lenovo ThinkStation D20 Manual

Arbor Technology

Arbor Technology FPC-7800 Series Manual de usuario

Sony

Sony VAIO VGX-TP1 Series Manual de usuario

Asus

Asus Eee Box B204 Manual de usuario

Dell

Dell Optiplex 9010 All In One Manual de usuario