RHINO FM60A Manual de usuario

RHINO®

1020 S. SangamonAve.

Gibson City, IL60936

800-446-5158

Email: [email protected]

PART'S MANUAL

An Operator's Manual was shipped with the equipment in the

Manual Canister. This Operator's Manual is an integral part of

the safe operation of this machine and must be maintained

with the unit at all times. READ, UNDERSTAND, and FOLLOW

the Safety and Operation Instructions contained in this manual

before operating the equipment. If the Operator's Manual is

not with the equipment, contact your dealer or Servis-Rhino

(800-446-5158) to obtain a Free copy before operating the

equipment.

FM60A/72A

Rear Discharge

60A & 72A Rotary Mowers

Rev 11-12 Effective S/N FM60A-14000 to Current Part No. 00778236P

FM72A-15800 to Current

TO THE OWNER/OPERATOR/DEALER

Allimplementswithmovingpartsare potentiallyhazardous. Thereisno substituteforacautious, safe-mindedoperatorwho

recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to

be used with all its safety equipment properly attached to minimize the chance of accidents.

BEFOREYOUSTART!! Read the safety messages on the implement and shown in your manual.

Observe the rules of safety and common sense!

WARRANTY INFORMATION:

Readand understand the complete Warranty Statementfound inthis Manual. Fill outthe WarrantyRegistration Form

in full and return it within 30 Days. Make certain the Serial Number of the Machine is recorded on the Warranty Card

andontheWarrantyFormthatyouretain.Theuseof"will-fit"partswillvoidyourwarrantyandcancausecatastrophic

failure with possible injury or death.

PARTS

SECTION

Parts Section – 1

Parts Section – 2

For maximum safety and to guarantee optimum product reliability, always use

genuine Servis-Rhino Parts. The use of inferior replacement parts may cause

premature or catastrophic failure which could result in serious injury or death.

Direct any questions regarding parts to:

The following instructions are offered to help eliminate needless delay and error in processing

purchase orders for the equipment in this section.

1. The Parts Section is prepared in logical sequence and grouping of parts that belong to the

basic machine featured in this manual. Part Numbers and Descriptions are given to help

locate the parts and quantities required.

2. The Purchase Order must include the name and address of the person or organization

ordering the parts, who should be charged, and if possible, the serial number of the machine

for which the parts are ordered.

3. The Purchase Order must clearly list the quantity of each part, the complete and correct part

number (be sure to include all periods), and the basic name of the part.

4. The Manufacturer reserves the right to substitute parts where applicable.

5. Some parts are unlisted items which are special production items not normally stocked and

are subject to special handling. Request a quotation for such parts before sending a

Purchase Order.

6. The Manufacturer reserves the right to change prices without prior notice.

NOTE: Please refer to The Safety Section in the front of this Manual for the proper

Part Number when ordering Replacement Safety Decals.

PARTS ORDERING GUIDE

RHINO®

1020 S. Sangamon Ave.

Gibson City, IL 60936

800-446-5158

Email: [email protected]

PART NAME INDEX

BELT ASSEMBLY 60" .......................................................................................................................................................... 14

BELT ASSEMBLY 72" .......................................................................................................................................................... 15

BLADE AND SPINDLE ASSEMBLY ..................................................................................................................... 9

CASTER WHEEL ASSEMBLY .......................................................................................................................... 12

DRIVELINE ASSEMBLY......................................................................................................................................................... 5

GEARBOX ASSEMBLY.......................................................................................................................................................... 6

OPTIONAL QUICK ATTACH HITCH KIT Rev 07-04 ........................................................................................................... 16

ROLLER- FRONT (EXTRA EQUIPMENT)........................................................................................................................... 11

SAFETY DECAL SHEETS ................................................................................................................................................... 17

SHIELD ASSEMBLY Rev 09-05............................................................................................................................................. 8

SPINDLE ASSEMBLY .......................................................................................................................................................... 10

3-POINT LIFT ASSEMBLY..................................................................................................................................................... 4

FM60A/72A (Sep-03) Rev 09-05

3-POINT LIFT ASSEMBLY

ITEM PART NO. QTY. DESCRIPTION

1 00757949 1 BAR TOP LINK BD80

2 00768320 4 BAR, HITCH

3 00769453 2 BAR-A-FRAME

4 00769549 2 BAR-REAR LIFT STRAP FM60A

00768319 2 BAR, REAR LIFT STRAP FM72A

5 00761724 4 BUSHING HITCH

6 00762082 6 BUSHING HITCH

7 00757953 1 BUSHING 1-1/4X7/32X3 A-FRAME

8 00603500 2 PIN, HITCH CAT I

9 37107B12 1 PIN TOP LINK CAT 1(PLATED)

10 37107B13 1 CLIP-X HAIR PIN

11 00037200 3 LOCKNUT

12 00748598 1 HEXB 3/4-10UNC 5-1/2 PL5

13 02929200 2 HHCS 3/4-10UNC 1-1/2 PL5

14 2196 2 CLIP (LYNCH PIN), 13/32 DIA.

15 02793900 4 HHCS 7/8-9UNC 2-1/2 GR 5

16 5JRC1490 4 NUT TOPLOCK 7/8 NC PLB

17 00750952 2 HEXB,5/8NC X 2-1/2,ZP,GRD5

18 00695100 4 LOCKNUT

19 00001400 4 FLATWASHER

20 00008300 2 BOLT

21 00778212 1 WDMT,DECK - FM60A

00778203 1 WDMT,DECK - FM72A

FM60A/72A (Sep-03) Rev 09-05

DRIVELINE ASSEMBLY

ITEM PART NO. QTY. DESCRIPTION

00768041A - DRIVELINE

1 00764500A 2 COMPLETE COLLAR YOKE

2 00756231 2 CROSS & BEARING KIT SERIES 40

3 00759169 1 PIN ROLL 8mm X 60mm

4 00759165 1 PIN ROLL INNER TUBE

5 00764506 1 COLLAR-GUARD-RETAINER

6 00754330 6 BOLT, NYLON - SAFETY SHIELD]

7 00764507 1 COLLAR-GUARD-RETAINER

8 00768168 1 SHIELD, ASY, CMPLT

9 00768165 1 DRIVELINE, HALF ASY, OUTER

10 00768164 1 DRIVELINE, ASY, INNER HALF

11 00774079 2 KIT,SLIDE COLLAR REPAIR

FM60A/72A (Sep-03) Rev 09-05

GEARBOX ASSEMBLY

FM60A/72A (Sep-03) Rev 09-05

GEARBOX ASSEMBLY

ITEM PART NO. QTY. DESCRIPTION

00777688 - ASY,GEARBOX

1 00778239 1 HOUSING GEARBOX

2 2716532 2 SNAP RING

3 2716540 1 CAP PLUG

4 00564800 1 BEARING, BALL

5 00754761 2 SHIM

6 2716564 1 SHIM KIT

7 00755615 2 BEARING

8 2716656 1 LOCKNUT

9 00778240 1 SEAL OUTPUT

10 00778241 1 SHAFT INPUT

11 00763206 1 SEAL, INPUT SHAFT

12 00754757 1 BEARING

13 00778242 1 COVER GEARBOX

14 00778243 1 SHIM

15 00755633 1 PLUG,3/8"

16 00756649 1 SNAP RING

17 00778244 1 GEAR ,CROWN

18 00772980 1 PLATE

19 00771879 1 SHIM

20 00778245 1 SHAFT, PINION

21 00778246 1 WASHER, EXTERNAL TOOTH

22 4840 1 NUT, CASTLE

23 00771856 4 BOLT METRIC

24 00778187 1 PLUG,BREATHER DIPSTICK

25 70497 1 COTTER PIN

00765444 1qt QT,ALAMO 000 GEAR LUBE

FM60A/72A (Sep-03) Rev 09-05

SHIELD ASSEMBLY Rev 09-05

ITEM PART NO. QTY. DESCRIPTION

1 00774843 1 PLATE GEARBOX MOUNT

2 00777538 1 SHIELD,RH MOLDED BELT FM60A

00777540 1 SHIELD,RH MOLDED BELT FM72A

3 00777539 1 SHIELD,LH MOLDED BELT FM60A

00777541 1 SHIELD,LH MOLDED BELT FM72A

4 00769933 1 NUT-PLASTIC KNOB 3/8 NC PL

5 00748823 2 HHCS 1/2-13UNC 1-1/2 PL5

6 00777688 1 ASY,GEARBOX

7 00001800 8 LOCKNUT

8 00002700 4 FLATWASHER

9 26168 6 CRG-BLT 3/8 X 1 GR5

10 00695100 4 LOCKNUT

11 00008300 4 BOLT

12 00769451 1 PLATE-GEARBOX SLIDE

13 02886900 4 CARR 1/2-13UNC 1-1/2 PL5

14 00769446 1 PLATE-GEARBOX ADJUSTMENT

15 00013901 2 NUT

16 00769898 1 BOLT 3/8 NC 4-1/2 PL2

17 02961255 6 PUSHNUT, BOLT RETAINER, 3/8

18 00758582 1 SHIELD,IMPLEMENT

19 00011700 4 LOCKWASHER

20 00023500 4 FLATWASHER

21 02958784 4 BOLT METRIC 8-P1.25- 20MM PL5

22 02030700 4 HHCS 1/2-13UNC 1-1/4 PL5

23 00011100 1 FLATWASHER 3/8 PL STD

FM60A/72A (Sep-03) Rev 09-05

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cortacésped de RHINO

RHINO

RHINO FR162 Manual de usuario

RHINO

RHINO 1900 Manual de usuario

RHINO

RHINO 48-inch Manual de usuario

RHINO

RHINO SE4 Manual de usuario

RHINO

RHINO TW25 Manual de usuario

RHINO

RHINO TW60 Manual de usuario

RHINO

RHINO 148cc B&S450 Manual de usuario

RHINO

RHINO Turbo 120 Manual de usuario

RHINO

RHINO TURBO 96 TURBO 96 Manual de usuario

RHINO

RHINO FM84 Manual de usuario

RHINO

RHINO 1900 Manual de usuario

RHINO

RHINO RX5 Manual de usuario

RHINO

RHINO TR210 Manual de usuario

RHINO

RHINO SE8A Manual de usuario

RHINO

RHINO BOOM ROTARY MOWER 2160 Manual de usuario

RHINO

RHINO 160 Manual de usuario

RHINO

RHINO SE42 Manual de usuario

RHINO

RHINO 1958 Manual de usuario

RHINO

RHINO DM112 Manual de usuario

RHINO

RHINO RHINO EC72 Manual de usuario

RHINO

RHINO TWISTER 10 Series Manual de usuario

RHINO

RHINO FN180 Manual de usuario

RHINO

RHINO FINISHING MOWERS GK6072 Manual de usuario

RHINO

RHINO FN120 Manual de usuario

Manuales populares de Cortacésped de otras marcas

Wolf Garten

Wolf Garten Compact plus 40 B Manual de usuario

Cub Cadet

Cub Cadet LTX 1045 Manual de usuario

Craftsman

Craftsman 917.378461 Manual de usuario

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Manual de usuario

Challenge

Challenge CH18V2 Instrucciones de operación

TALEN TOOLS

TALEN TOOLS AVR HGM30 Manual de usuario

DEWEZE

DEWEZE ATM-725 Manual de operación

Weed Eater

Weed Eater 180083 Manual de usuario

Husqvarna

Husqvarna Poulan Pro PP185A42 Manual de usuario

Better Outdoor Products

Better Outdoor Products Quick Series Manual de usuario

Cub Cadet

Cub Cadet 23HP Z-Force 60 Manual de funcionamiento

MTD

MTD 795, 792, 791, 790 Manual de usuario

Toro

Toro Groundsmaster 3505-D Manual de usuario

Dennis

Dennis FT 610 Manual de usuario

AIRFORCE

AIRFORCE F-15 Gen 3 Manual de usuario

MTD

MTD 126-220-000 Manual de usuario

Toro

Toro 74806 Manual de usuario

Stihl

Stihl RMA 443 PV Manual de usuario