1) Important Safety Notice!
Make sure you read this section very carefully! Learn to recognize
this Safety Alert Symbol. The HD 7700 has been designed to
provide a very high level of protection to an operator. Follow the
guidelines below while installing, operating and maintaining your
machine.
♦Plug the machine into an outlet that provides a 15-amp service (16 amp for
European installations) that is protected at the customer’s circuit box.
♦Always replace fuses or circuit breakers with the correct amperage and type.
♦If machine cycles on its own, call dealer immediately for service.
♦Never bypass top cover switch or reverse knob switch. Doing so may result
in personal injury!
♦Turn power switch off before removing a die or performing maintenance.
2) Placing your machine in the proper location:
Before lifting machine, turn power off. Remove plug from electrical
supply for personal safety. The machine is very heavy! Never
attempt to lift machine by yourself. It needs two people to lift
machine. It should be lifted at each side of the back end and
each side of the front end.
Place the machine on a hard level surface placing the foot pedal on the floor in
front of the machine. Set aside some room for the books that have to be punched
and also some room for the books that had already been punched.
3) Providing power to the machine: Diagram 1
Power cord shall be certified for the country where the
machine will be installed.
Plug one end of the power cord into the back of the machine. The
other end goes into the wall outlet. Install the foot pedal plug into the
receptacle, which is located on the back of the machine. The
optional palm switch can be plugged into the same receptacle if this option is to
be used. Turn machine “On” with rocker switch located at rear of punch. The
green power indicator on front panel will be illuminated when punch is ready.
Diagram 1
HD 7700 Issue 1 Page 4
