24VDC(+20%, -15%), 250mA, 6W (for T-E
module)
24VDC (+20%, - 15%), 270mA, 6.48W (for TN-E
module)
Power
(with 5 Expansions)
24VDC(+20%, -15%), 500mA, 12W (for T-E
module)
24VDC(+20%, -15%), 520mA, 12.48W (for TN-E
module)
10.1”, 1024 x 600pixels, WVGA color TFT with
4-wire analog resistive touch screen
Up to 1GB that includes user application, data
log, alarms, retentive memory and logic
memory
Built-in, date and time function
It support 5 expansion slots*
268.0(W) x 190.0(H) x 36.8(D)mm
1 USB Type C Port and 1 USB Host Port
Micro SD [High Capacity (4GB to 32GB)]
Speed Class:
[While inserting and removing SD card, please make
sure to TURNOFF the power to the unit.]
10 to 90% (Non-Condensing)
IEC 60068-2-27
25g, 11ms, 6 shocks per axis, total 18 shocks (X,
Y, Z)
IEC 60068-2-6
5 to 150Hz, 3g peak (X, Y, Z)
EN 55011 : 2009/A1 : 2010
EN 61131-2 : 2007
EN 61000-6-2 : 2005/AC : 2005
EN 61000-6-4 : 2007/A1 : 2011
IP66 for front panel mounting
CE, UL(Class1 Div2) & RoHS
[*Note: Applicable only for FP4101Tx-E models.]
[**Note: For UL, operating temperature range is 0° to 50°C.]
[Panel Cutout Dimensions: 256.00(W) x 178.00(H)mm,
Panel Thickness: Maximum 6mm and Mounting Clamps: 6]
Tighten the mounting screws evenly to a torque between 0.4N/m
to maintain water and dust resistance.
Product Code:
FP4101T: 1024 x 600, WVGA, 10.1” color TFT with 4-wire
analog resistive touch screen with 2 comm port, one USB
Type C port & Host port.
FP4101TN: 1024 x 600, WVGA, 10.1” color TFT with 4-
wire analog resistive touch screen with 2 comm port, one
USB Type C port, one USB Host port & 1 Ethernet Port.
FP4101T-E: 1024 x 600, WVGA, 10.1” color TFT with 4-
wire analog resistive touch screen with 2 comm port, one
USB Type C port & Host port. It supports upto 5
expansions.
FP4101TN-E: 1024 x 600, WVGA, 10.1” color TFT with 4-
wire analog resistive touch screen with 2 comm port, one
USB Type C port, one USB Host port & 1 Ethernet Port. It
supports upto 5 expansions.
User should follow the given sequence to configure and
use any FlexiPanels series unit:
1.
Install FlexiSoft Software.
2.
Create a PZM application using FlexiSoft software.
3.
Connect programming cable.
4.
Download Firmware i.e. driver for the HMI.
5.
Download application.
6.
Now FP unit is ready to use in the system.
