Renogy RBC20A1P Manual de usuario

VERSION B0

Portable

LFP Battery Charger

Quick Guide

SKU: RBC20A1P

Important Safety Instructions

Indicates a potentially dangerous condition. Use

extreme caution when performing this task.

Indicates a critical procedure for the safe and proper

installation and operation of the battery.

Indicates a procedure or function that is important to

the safe and proper operation of the battery.

NOTE

CAUTION

WARNING

General Safety Information

DO NOT open, dismantle, or modify the battery.

DO NOT touch any terminals or connectors.

Disclaimer

The manufacturer accepts no liability for any damage caused by:

Force majeure including fire, typhoon, flood, earthquake, war,

and terrorism.

Intentional or accidental misuse, abuse, neglect or improper

maintenance, and use under abnormal conditions.

Improper installation, improper operation, and malfunction of a

peripheral device.

Contamination with hazardous substances, diseases, vermin, or

radiation.

Alterations to the product without expressed written consent

from the manufacturer.

Please keep the battery away from water, heat sources, sparks,

and hazardous chemicals.

DO NOT puncture, drop, crush, burn, penetrate, shake, or strike

the battery.

Do not disassemble charger.

Do not expose charger to rain or snow.

DO NOT touch the exposed electrolyte or powder if the battery

casing is damaged.

Please make sure any battery charger(s) or charge controller(s)

are disconnected when working on the battery.

Use of an attachment not recommended or sold by the battery

charger manufacturer may result in a risk of fire, electric shock,

or injury to persons.

To reduce risk of electric shock, unplug charger from outlet

before attempting any maintenance or cleaning. Turning off

controls will not reduce this risk.

The charger outputs 20A and is intended for the use of charging

12.8V Lithium-iron phosphate (LFP, LiFePO4) batteries that can

handle the charge current.

Ensure that the LiFePO4 batteries include a PCM/BMS when

using this charger.

To reduce risk of damage to electric plug and cord, pull by plug

rather than cord when disconnecting charger.

Do not operate charger with damaged cord or plug – replace the

cord or plug immediately.

Do not operate charger if it has received a sharp blow, been

dropped, or otherwise damaged in any way.

Any uncovered battery material, such as electrolyte or powder,

that has contacted skin or the eyes must be flushed out with

plenty of clean water immediately. Seek medical attention

afterwards. Spills on clothing should be rinsed out with water.

DO NOT connect or disconnect terminals to/from the battery

without first disconnecting loads.

General Information

Product Overview

Identification ofParts

1.AC Port

2.LED Status Indicator

3.Alligator Clips

4.Blade Fuse (30A)

①

②

③

30A

④

Renogy 20A AC to DC Charger (RBC20A1P) is an automatic and

portable charger intended for 12V LFP batteries. This charger

includes 12AWG alligator clips and outputs power based on the

power, voltage, and current condition of the battery. The charger

has an LED status indicator for providing a visual means to

determine the operating mode and condition of the battery

connected to the charger. The AC-DC portable charger will

automatically monitor and maintain the battery at full charge.

Dimensions

9.17in / 233mm

2.52 in / 64 mm

4.25in / 108mm

39.37 in / 1000mm 12AWG

30A

5.90 in / 150mm 7.87 in / 200mm

4.33 in / 110mm

Operation

Never alter ACcord or plug provided on the charger.

WARNING

Never allow the alligator clips to touch each other.

To get started, connect the positive alligator clip to the positive

terminal on the LFP battery. Do the same for the negative terminal.

Upon successful connection, the status indicator will display Red

or Green depending on the status of the battery.

30A

IMPORTANT: Place the charger on a hard-flat surface. Do not place

it on a plastic, leather or textile surface.

Locate the charger as far away from the battery as DC cables

permit.

Never place the charger directly above the battery being

charged.

Do not operate the charger in a closed-in area or restrict the

ventilation in any way.

LED Status

LED Status Description

Solid red This indicates the charger is charging

normally.

Always-on

green light

There are two conditions when the

indicator light is always green.

Indicator light off

The LED indicator immediately goes out

when the charger triggers one of the

following protection mechanisms:

Over-current protection

Over-voltage protection

Under-voltage protection

Short-circuit protection

In this case, please follow the steps in

Troubleshooting below.

Condition 1: When the charger is first

connected to the AC utility terminal, but

the AC charger output is not connected to

the battery (meaning the charger is in an

idle state);

Condition 2: When the charging current of

the charger is lower than 2A (meaning the

battery is fully charged).

Short Circuit

Protection

Troubleshooting

Condition Steps to Take

1. When there is a short circuit between

the two poles of the ring terminals in the

battery charger, the Short Circuit

Protection will be triggered. The charger

stops working immediately, and the LED

indicator goes out.

Undervoltage

Protection

1. When the battery voltage is between

4V and 5V, the Undervoltage Protection

of the charger will be triggered.

2. The 12V battery has almost reached its

end of lifespan when its voltage drops to a

range of 4V to 5V. Please contact the

battery manufacturer for further support.

Overvoltage

Protection

1. When the voltage at the output terminal

of the charger is greater than 16V, the

Overvoltage Protection will be triggered.

At this time, the indicator light will go out

and the charger will stop working.

2. Disconnect the battery immediately

and check the charger.

2. Disconnect the connecting wire of the

AC terminal immediately. When the short

circuit between the live wire and the

neutral wire is resolved, wait for 10

seconds, and then reconnect the AC

terminal wire, and the charger will restart.

Technical Specifications

Reverse

Connection

Protection

Condition Steps to Take

Input Voltage 100V to 240V AC, 50 Hz/60 Hz

Input Amps 5A Max

Output Voltage 14.5 (±0.1)V DC

Output Amps 20 (±0.5)A

Minimum Battery Voltage 4V to 5V DC

Efficiency 110V AC 90% Min

230V AC 91% Min

Room Operating Temperature* -29℃to -45℃/ -20℉to -113℉

-40℃to -75℃/ -40℉to -167℉

Storage Temperature

Self-Consumption 50mA Max

Current Protection

Dimensions

Weight

Cable Length

250V 10A Fuse built in

9.2 x 4.3 x 2.5 in / 233 x 108 x 64 mm

3.8 lbs / 1.7 kg

approx. 39.4 in / 1000 mm

Model RBC20A1P

1. When the charger triggers the Reverse

Connection Protection, the external fuse

on the connection line will blow, the

charger will not work normally.

**LFP batteries should not be charged below 0℃/32℉. Otherwise,

the BMS cuts off the charging.

2. Replace the fuse on the connection line

immediately. The specification of the fuse

is 250V 30A.

Charge Curve

20A

14.6V

14V

12.8V

10A 5A 3A

Current

Voltage

2A 0.1A 0A

Manufacturer: RENOGY New Energy Co.,Ltd.

Address: No.66, East Ningbo Road Room 624-625

Taicang German Overseas Students Pioneer Park

JiangSu 215000 CN

Manufacturer: RENOGY New Energy Co.,Ltd.

Address: No.66, East Ningbo Road Room 624-625

Taicang German Overseas Students Pioneer Park

JiangSu 215000 CN

EVATOST CONSULTING LTD

Centre, Taffs Well, Cardiff, Wales, CF15 7QR

[email protected]

Suite 11, First Floor, Moy Road Business

UK REP

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cargador de baterías de Renogy

Renogy

Renogy WANDERER 30A PWM Series Manual de usuario

Renogy

Renogy PHOENIX R-PB006 Manual de usuario

Renogy

Renogy DCDC30 Manual de usuario

Renogy

Renogy REGO Manual de usuario

Renogy

Renogy DCC-1212-20 Manual de usuario

Renogy

Renogy E.POWER 10000MAH Manual de usuario

Renogy

Renogy RIV4850CH2S Manual de usuario

Renogy

Renogy RSP10BM Manual de usuario

Renogy

Renogy RBC2125DS-21W Manual de usuario

Renogy

Renogy REGO Manual de usuario

Renogy

Renogy DCC-1212 Series Manual de usuario

Renogy

Renogy REGO Manual de usuario

Renogy

Renogy REGO Manual de usuario

Renogy

Renogy RBC20D1U Manual de usuario

Renogy

Renogy REGO RBC1260DO-12B Manual de usuario

Renogy

Renogy RBC2125DS-21W Manual de usuario

Renogy

Renogy REGO Manual de usuario

Renogy

Renogy Drifter Manual de usuario

Renogy

Renogy REGO Manual de usuario

Renogy

Renogy PWM1020CC-DB Manual de usuario

Renogy

Renogy RNG-INVT-1000-12V-C Manual de usuario

Renogy

Renogy RNG-INVT-1000-12V-C-US Manual de usuario

Renogy

Renogy RIV4835CSH1S Manual de usuario

Manuales populares de Cargador de baterías de otras marcas

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Manual de usuario

Enelion

Enelion Vertica Manual de usuario

RCA

RCA CHU6 Manual de usuario

ANSMANN

ANSMANN ALCT 6/24-10 Manual de usuario

Hitachi

Hitachi UC 18YRSL Guía de solución de problemas

Olympus

Olympus B-20 LPC Manual de usuario

Exibel

Exibel ZH1708143 Manual de usuario

Lenmar

Lenmar Mach 1 Manual de usuario

CTEK

CTEK MXS 5.0 Manual de usuario

ABB

ABB HT842379 Manual de usuario

Nitecore

Nitecore Superb Charger SC4 Manual de usuario

Braun

Braun BWC02M Manual de usuario

CTEK

CTEK MXS 3.6 Manual de usuario

Black & Decker

Black & Decker BDV090 Manual de usuario

Trinity

Trinity DPD Manual de usuario

Hulkman

Hulkman Sigma 1 Manual de usuario

IKEA

IKEA koppla Manual de usuario

AKG

AKG WMS400 CU 400 Manual de usuario