ERV HE1XRT
WWW.RENEWAIRE.COM INSTALLATION, OPERATION AND MAINTENANCE MANUAL 1.800.627.44992
ERV HE1XRT
WWW.RENEWAIRE.COM INSTALLATION, OPERATION AND MAINTENANCE MANUAL 1.800.627.44992
HE1XRT info......................... 2-9
Installation....................... 10-18
Start-up............................19-21
Maintenance.....................22-23
TABLE OF CONTENTS
HE1XRT INFO
1. Before servicing or cleaning the unit, switch
power off at disconnect switch or service panel
and lockout/tag-out to prevent power from being
switched on accidentally. More than one discon-
nect switch may be required to de-energize the
equipment for servicing.
2. This installation manual shows the suggested
installation method. Additional measures may be
required by local codes and standards.
3. Installation work and electrical wiring must be
done by qualified professional(s) in accordance
with all applicable codes, standards and licens-
ing requirements.
4. Any structural alterations necessary for instal-
lation must comply with all applicable building,
health, and safety code requirements.
5. This unit must be grounded.
6. Danger of severe injury to bystanders and dam-
age to unit or property if high winds move this
unit. Secure this unit to the building!
7. Sufficient air is needed for proper combustion
and exhausting of gases through the flue (chim-
ney) of fuel burning equipment that might be in-
stalled in the area affected by this equipment. If
this unit is exhausting air from a space in which
chimney-vented fuel burning equipment is locat-
ed, take steps to assure that combustion air sup-
ply is not affected. Follow the heating equipment
manufacturer’s requirements and the combus-
tion air supply requirements of applicable codes
and standards.
8. Use the unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
9. This unit is intended for general ventilating only.
Do not use to exhaust hazardous or explosive
materials and vapors. Do not connect this unit to
range hoods, fume hoods or collection systems
for toxics.
10.When cutting or drilling into wall or ceiling, do
not damage electrical wiring and other hidden
utilities.
RISK OF FIRE, ELECTRIC SHOCK, OR INJURY. OBSERVE ALL CODES AND THE FOLLOWING:
WARNING
The unit’s fresh air inlet should be at least 10’ away from any exhaust, such as dryer vents, chimneys,
furnace and water heater exhausts, or other sources of contamination or carbon monoxide. Do not locate the
fresh air inlet where vehicles may be serviced or left idling. Never locate the unit inside a structure.
Danger of damage or severe injury if high winds move this unit. Secure unit to structure. Observe local code
requirements at a minimum.
WARNING
