Reel Performance + Manual de usuario
2 Performance + Electric Scooter User Manual
By registering your REEL scooter, you’ll
instantly receive a 12-month warranty against
original defects in material and workmanship
and a 6-month warranty on the scooter battery.
Go to ridereel.co.uk/warranty to read more
about the policy.
Register now.
SCAN ME
Get ready
to REEL.
Performance +
Electric Scooter User Manual
4 Performance + Electric Scooter User Manual
Content.
Your REEL Scooter .05
Accessories .05
LCD Display .06
Assembly .07
Charging your REEL Scooter .08
Folding & Carrying .08
Getting Started .09
Safety Instructions .10
Prevent Dangerous Riding .12
Maintenance & Storage .14
Safety Recommendations .16
Making Minor Adjustments .17
Operating Parameters .18
Thank you for choosing to ride REEL.
Here is your user manual covering the set up, maintenance and hints and tips
on riding with confidence. We’ll make it as easy as possible and you’ll be riding
in no time.
© 2021 | All rights reserved. 5
Your REEL Scooter.
Accessories.
(you’ll need these to get riding)
Screws x 4
(provided)
Allen Key
(provided)
Charging Adapter
(provided)
Headlight
Bell
Clip
Brake Handle
Throttle
Control Panel
Power
Button
Folding Mechanism
Drum Brake
Charging Point
Clamp
Brake Light
Rear Pedal
Brake
Stand
Battery Compartment
6 Performance + Electric Scooter User Manual
LCD Display.
km/h mph
ECO D S
1. Speedometer: Displays your current speed in km/h
or mph.
2. Speed mode*: To switch between these modes,
ensure the unit is powered on and stationary. Press the
power button twice and the display will change modes
in sequence through the following:
3. ECO: Energy efficient mode. Max Speed 8-10km/h.
4. D: Drive. Max speed 15-16 km/h.
5. S: Sport. Max speed 25 km/h.
6. Headlight: Indicates the headlight is active. Activate it by pressing the power button once.
7. Walk Mode: To activate walk mode, ensure the scooter is in sport mode using the
instruction above. From there, press the power button twice and the icon should illuminate
indicating walk mode is enabled. This allows the scooter to roll freely when walking with
it at your side.
8. Bluetooth icon: Will show when paired with a device.
9. Thermometer: This symbol will appear when the scooter has overheated and is at a high
temperature. Power OFF to allow the scooter to cool down.
10. Wrench: This symbol will appear should a fault develop with your scooter. There may be
something wrong with your scooter. To diagnose the issue, go into the REEL app and click
settings, then go to system self-check.
11. Battery Indicator: Displays your current battery level.
12. Power ON/OFF: The scooter will automatically turn off after 10 minutes. Manually turn
off using the App or holding down the power button.
1.
2.
3.
4.
5.
7.
8.
6.
9.
11.
10.
12 .
* Driving modes are changeable in the REEL App or double-tap the power button to change manually.
© 2021 | All rights reserved. 7
Assembly.
1. Fix the folding clip firmly in place and
ensure the scooter is on it’s stand.
2. Align the handlebars so that when
the wheel is centred and straight, the
handlebars are straight.
3. Insert the screws into the holes on
the handlebars and tighten with the hex
wrench/allen key provided.
4. Once tightened, check the power
switch and display to ensure they
function correctly.
Powering up your REEL
To turn on the scooter, press and hold the power button for 3 seconds. The
display will then power up. To turn on the light, ensure your REEL scooter is
turned on and press the power button once. The light icon will appear on the
display when the light is on. To switch between driving modes, press the power
button twice. The display will then show which driving mode is selected.
8 Performance + Electric Scooter User Manual
Folding & Carrying.
Folding your REEL Scooter Safely
Make sure the electric scooter is turned off before
attempting to fold. Holding the front pole, loosen the
lock lever by twisting to your right. This will release the
lever that is pointing upwards. Pull this lever down. The
front pole can then be lowered, allowing the scooter to
fold. Once folded, attach the clip (found near the bell on
the handlebar) to the clamp on the rear wheel mudguard.
To unfold the scooter, unhook the clip attached to the
back wheel mudguard. Slowly elevate the front pole to a
standing position and lock both levers in place.
Charging your REEL Scooter.
The charging port is located underneath the foot plate.
1. Open the cover and
connect the charger.
Important: Close the cover once the charger has been disconnected.
Only use the REEL charger provided when charging the scooter.
Carrying your REEL Scooter
The scooter should only be carried using the locked
front pole. This can be done with one or two hands.
2. Once charging is
complete, remove
the charger. Ensure
cap is closed after
charging.
© 2021 | All rights reserved. 9
Getting Started.
REEL always recommends the use of safety equipment such as a
helmet, knee pads and gloves.
4. To slow down,
release pressure off the
accelerator. The energy
recovery system will
start, helping gradually
slow the scooter down.
To stop faster, apply
gradual pressure to the
brake lever.
5. To turn, lean your
body slightly into the
direction of the turn,
whilst gradually moving
the handlebars in the
same direction. (e.g, for
a left turn, lean the body
slightly to the left while
gradually turning the
handlebars to the left).
1. Turn on your REEL
scooter and check
the battery has
sufficient charge.
2. To start, kick off with
one foot on the floor.
3. To start, kick off with
the foot on the floor. Once
the scooter is moving,
press down on the throttle
to start the electric motor.
10 Performance + Electric Scooter User Manual
Safety Instructions.
1. It’s advised to avoid riding in the rain. 2. Whilst riding, you should slightly bend
your knees to allow for better control
when going over rough terrain. If you are
travelling on a rough road you should
stick to a low speed (5-10km/h).
3. It’s advised not to ride when passing
through doorways.
4. Do not add speed when
descending a hill.
Tabla de contenidos
