RCA RPJ112 Manual de usuario
MODEL NO. RPJ112
MULTIMEDIA PROJECTOR
,16758&7,210$18$/
3/($6(5($'%()25(23(5$7,1*7+,6(48,30(17
7KLVSURGXFWLVPDQXIDFWXUHGDQGVROGE\&XUWLV,QWHUQDWLRQDO/WG
5&$WKH5&$ORJRWKHWZRGRJV1LSSHUDQG&KLSSHUORJRDUH
UHJLVWHUHGWUDGHPDUNVRUWUDGHPDUNVRI5&$7UDGHPDUN
0DQDJHPHQWDQGDUHXVHGXQGHUOLFHQVHE\&XUWLV,QWHUQDWLRQDO/WG
$Q\RWKHUSURGXFWVHUYLFHFRPSDQ\WUDGHRUSURGXFWQDPHDQGORJR
UHIHUHQFHGKHUHLQDUHQHLWKHUHQGRUVHGQRUVSRQVRUHGE\
5&$7UDGHPDUN0DQDJHPHQWRULWVDIILOLDWHV
Important Safety Instrucons
Important Safety Instrucons
1
1. Read these Instrucons.
2. Keep these Instrucons.
3. Heed all Warnings.
4. Follow all instrucons.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any venlaon openings. Install in accordance with the
manufacturer’s instrucons.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifier) that product heat.
9. Protect the power cord from being walked on or pinched parcularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
10.Only use aachments/accessories specified by the manufacturer.
11.Unplug this apparatus during lightning storms or when unused for long periods of
me.
12.Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
13.Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer
or sold with the apparatus. When a cart is used, use cauon when moving the cart/
apparatus combinaon to avoid injury from p-over.
Addional Warnings and Precauons
2
1. Do not look directly into the projector light.
2. Don’t touch the project lens
3. Mains adapter is used as disconnect device and it should remain readily operable
during intended use. In order to disconnect the apparatus from the mains completely,
the mains plug should be disconnected from the mains socket outlet completely.
4. CAUTION: Use of controls or adjustments or performance of procedures other than
those specified may result in hazardous radiaon exposure.
5. WARNING: Changes or modified to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
6. WARNING: Use of this unit near fluorescent lighng may cause interference regarding
use of the remote. If the unit is displaying errac behavior move away from any
fluorescent lighng, as it may be the cause.
7. WARNING: Shock hazard - Do Not Open.
8. Cauon and marking informaon is located at the rear or boom of the apparatus.
9. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to
rain, moisture, dripping, or splashing.
10. Objects filled with liquids, such as vases, shall not be placed on the apparatus.
FCC Warning
3
Warning: Changes or modified to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protecon against harmful interference in a residenal installaon. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instrucons, may cause harmful interference to radio
communicaons. However, there is no guarantee that interference will not occur in a
parcular installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Table of Contents
In The Box
Important Safety Instructions
Additional Warnings and Precautions
FCC Warning
Table of Contents
In The Box
Remove & Close the Dust Cap
Install the Focus Ring
Placing Your Projector
Placing Your Projector On Ceiling
Adjust the Vertical Location
Adjust the Focus and Trapezoidal Screen
Controls of Remote
Install / Remove Battery Of Remote
Controls of Projector
Install Power Adapter
Main Operation
Connect HDMI show the Image On Projector Screen
Connect VGA Show The Image On Projector Screen
Connect AV Show The Image On Projector Screen
Connect Audio Output (Aux Out / Line Out / Earphones)
Install USB Device And Micro Sd Card “TF”
Using SD Card and USB Playback
Using Projector Menu 1.0
Using Projector Menu 2.0
Using Projector Menu 3.0
Using Projector Menu 4.0
Specifications
P1
P2
P3
P4
P4
P5
P5
P6
P7
P8
P8
P9
P9
P10
P11
P11
P12
P13
P14
P15
P16
P16
P17
P18
P19
P20
P21
4
MODEL NO. RPJ112
MULTIMEDIA PROJECTOR
,16758&7,210$18$/
3/($6(5($'%()25(23(5$7,1*7+,6(48,30(17
7KLVSURGXFWLVPDQXIDFWXUHGDQGVROGE\&XUWLV,QWHUQDWLRQDO/WG
5&$WKH5&$ORJRWKHWZRGRJV1LSSHUDQG&KLSSHUORJRDUH
UHJLVWHUHGWUDGHPDUNVRUWUDGHPDUNVRI5&$7UDGHPDUN
0DQDJHPHQWDQGDUHXVHGXQGHUOLFHQVHE\&XUWLV,QWHUQDWLRQDO/WG
$Q\RWKHUSURGXFWVHUYLFHFRPSDQ\WUDGHRUSURGXFWQDPHDQGORJR
UHIHUHQFHGKHUHLQDUHQHLWKHUHQGRUVHGQRUVSRQVRUHGE\
5&$7UDGHPDUN0DQDJHPHQWRULWVDIILOLDWHV
Remote
Main unit
Lens Hood User ManualAC Power Adapter
If the projector is not used for an extended period of time,
please cover the lens with the included lens cap.
Remove & Close The Lens Cover
Install The Lens Hood
5
CLOSE
REMOVE
LENS COVER
LENS COVER LENS HOOD
LENS COVER
REMOVE
INSTALL
LENSGHOOD LENS COVER
REMOVE INSTALL
Close the lens cover when unit not in use.
For protect the projector lens.
You projector can be installed in four different configurations (see pictures below).
Distance between the projector and screen
Placing Your Projector
NOTE: If the projector is installed in rear configurations, please use a screen suitable
for rear projection.
6
FRONT PROJECTION FRONT PROJECTION
REAR PROJECTION REAR PROJECTION
THE CENTER OF LENS
SCREEN
P
P
P
P
P
Square /Rectangle
To reduce image distortion, it is
recommended to position the projector
as close to the center of the screen as
possible.
A projector mount is required to install
the projector in a ceiling.
Installing your projector in the ceiling
7
CEILING
PROJECTOR MOUNT
REMOVE THE KNOB
SCREW HOLE FOR FASTENING
PROJECTOR MOUNT
When installing the projector in the ceiling, please purchase a projector mount
recommended by an installation professional and follow the instructions that come
with the mount.
Before installing the projector in the ceiling, please check to make sure the ceiling
structure can support the weight of the projector and the mount. If in doubt, please
ask the advise from an installation professorial.
Note: Projector mount and screw(s) not included.
Follow below picture to adjust the vertical location.
Adjust The Vercal Locaon
Follow below picture to adjust the focus and trapezoidal screen.
Adjusng Focus and Keystone
8
SCREEN
PROJECTOR
VERTICAL
DIMENSION
VERTICAL
DIMENSION
SCREEN
PROJECTOR
FOCUS ADJ. KNOB
To reduce image distortion, it is recommended that the center of the projector
lens be as close to the center of the screen as possible.
KEYSTONE CORRECTION KNOB
Adjust the focus by turning the
knob while observing the image
pixels near the center of the
screen. Optimal focus is
obtained when the pixels are
clearly visible. Depending on
the projected screen size, the
focus near the screen edges
may be less sharp than the
screen center.
Then sharpen the image
by rotating the focus knob.
Keystone image is created
when the projector beam is
projected to the screen in an
angle. Keystone correction will
restore the distorted image to a
rectangular or square shape.
Controls of Remote
Install / Remove Baery Of Remote
9
EXIT
POWER
MUTE
IR
FLIP
SKIP
SEARCH
PLAY /PAUSE VOLUME
SOURCE
MENU
NETVIGATOR
ZOOM
BATTERY COMPARTMENT
(VIEW SIDE OF REMOTE)
AAA / UM4
AAA / UM4
BATTERY DOOR
Remove the baery compartment cover on the back of your remote by carefully sliding
to open. The baery cover can then be lied away. Fit the correct baeries (not
included), referring to the polarity markings. Finally, replace the cover.
NOTES:
• Baeries shall not be exposed to excessive heat such as sunshine, fire
• Be sure that the baeries are installed polarity correctly.
• Do not mix old and new baeries.
• Only same or equivalent type baeries as recommend are to be used.
• Do not dispose of baeries in fire, baery may explode or leak. Do not try to
recharge a baery
Tabla de contenidos
Otros manuales de Proyector de RCA
RCA
RCA PJ28BT Manual de usuario
RCA
RCA P50M Manual de usuario
RCA
RCA RPJ240-COMBO-VOUCHER Manual de usuario
RCA
RCA RPJ275 Manual de usuario
RCA
RCA RPJ402 Manual de usuario
RCA
RCA RPJ116 Manual de usuario
RCA
RCA RPJ143-50DISP Manual de usuario
RCA
RCA RPJ119 Manual de usuario
RCA
RCA RPJ133-B Manual de usuario
RCA
RCA RPJ106 Manual de usuario
RCA
RCA RPJ138 Manual de usuario
RCA
RCA RPJ060 Manual de usuario
RCA
RCA RPJ107-BLACK Manual de usuario
RCA
RCA RPJ129 Manual de usuario
RCA
RCA RPJ106 Manual de usuario
RCA
RCA RPJ300 COMBO-BLK Manual de usuario
RCA
RCA RPJ065 Manual de usuario
RCA
RCA RPJ133_24DISP Manual de usuario
RCA
RCA RPJ116-B-PLUS Manual de usuario
RCA
RCA RPJ167 Manual de usuario
