Quantum DLTtape DLT1 Manual de usuario

DLT™ TAPE UNIT INSTALLATION

HP® 9000 Series 700 System

HP-UX® 9.X

Installation

The system must have the appropriate SCSI interface for DLT drive to attach to, i.e., a SCSI single-ended

DLT drive can be attached only to a SCSI single-ended interface. The same is true for SCSI differential

attachment. The hardware attachment simply requires the DLT tape peripheral to be attached to the

interface while the system is powered down. After the DLT tape peripheral has been attached, you will

need to perform certain system operations that will allow DLT device system recognition.

Perform the installation as follows:

1. Shutdown the system and remove ac power from the system. Install the DLT tape

peripheral and connect it to its SCSI controller. Refer to the following manual for

switch and jumper settings and SCSI bus termination:

• DLT1/DLT7 Install and Operations Guide Set the DLT SCSI device address to an

unassigned ID.

1. Power up the system. During the power-up, the process allows you to stop the

sequence by pressing the ESC key. By doing so, you can verify drive attachment

by issuing a search for boot device selection. This will display all attached SCSI

devices including the DLT tape drive. The boot process can continue by selecting

the appropriate boot disk.

2. Log on as root and change directory to /dev/rmt

In the next step, you will create a set of device files that will allow DLT device access. These device files

allow certain DLT device modes of operation.

1. Enter the following commands:

mknod 1m c 54 0x201402

mknod 1mn c

54 0x201403

mknod 1c c 54 0x2014c2

mknod 1cn c 54 0x2014c3

The device files created are for an installed DLT device with a SCSI ID of 4 and are shown below along

with their corresponding operating characteristics:

1m - drive 1, rewind on close

1mn-d

rive 1, no rewind on close

1c - drive 1, compressed, rewind on close

1cn - drive 1, compressed, no rewind on close

Associating the device files to a DLT device with a SCSI ID other than

requires that the number "4" in the minor number of the

mknod command be changed to the new ID.

DLT Mini-Library Usage

The HP-UX operating system does not support SCSI-2 media changer device commands. Therefore, an

installed DLT7 mini-library can not be utilized in random access mode and can only be accessed in

sequential mode. Refer to the DLT1/DLT7 Install and Operations Guide for detailed description of these

access modes.

Otros manuales para DLTtape DLT1

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Almacenamiento de Quantum

Quantum

Quantum DXi V-Series Manual de usuario

Quantum

Quantum PX720 Manual de usuario

Quantum

Quantum Quantum Bigfoot CY Manual de usuario

Quantum

Quantum DAT 160 Manual de usuario

Quantum

Quantum StorNext M330 Instrucciones de instalación

Quantum

Quantum PX500 Series Guía de inicio rápido

Quantum

Quantum Scalar i40 Instrucciones de funcionamiento y seguridad

Quantum

Quantum SNC 5100 Manual de instrucciones

Quantum

Quantum Scalar i6000 Manual de usuario

Quantum

Quantum Q250 Manual del producto

Quantum

Quantum PX506 Manual de usuario

Quantum

Quantum DLT 7 Manual de usuario

Quantum

Quantum StorNext QD7000 Manual de instalación y operación

Quantum

Quantum LTO 1U Manual de usuario

Quantum

Quantum RDX 8000 Manual de usuario

Quantum

Quantum PowerStor L200 Manual de usuario

Quantum

Quantum Scalar 10K Manual de usuario

Quantum

Quantum DLTtape SDLT 600 Manual de usuario

Quantum

Quantum DXi4700 Manual de instalación y operación

Quantum

Quantum DLTtape SDLT 220 Manual

Quantum

Quantum DXi8500 Manual de usuario

Quantum

Quantum DAT 320 CD320UE Manual de usuario

Quantum

Quantum Scalar i40 Instrucciones de funcionamiento y seguridad

Quantum

Quantum DLTtape SDLT 600 Manual de usuario

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

HP StorageWorks MSL2024 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

HP P9000 Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario