Qtx FH-700 Manual de usuario

FH-700

Fog/Haze Machine

Item ref: 160.458UK

User Manual

160.458UK User Manual

INTRODUCTION:

FH-700 Fog/Haze Effect Machine

This mini effects unit produces both a fog and haze. The flow rate and internal rotary

fan can be adjusted to produce either thick fog effects or light haze depending on

your requirements. Supplied with a handheld timer remote control, making it suitable

for a wide variety of applications such as nightclubs, laser shows mobile DJs and

theatres.

6,000 Cu Ft (170m³) per minute (approx.)

Anti-jamming pipe technology

Intelligent microcomputer keeps the temperature high

Removable tank for easy maintenance

Robust metal housing

Timer output control included

High grade haze fluid should be used with this machine (we recommend

160.590 or 160.591)

160.458UK User Manual

PACKAGE CONTENTS:

Please check the contents to ensure that the product has been received in good

condition.

FZ-700 Unit x 1pc

User’s Guide x 1pc

Power Cord x 1pc

Remote Control x 1pc

If you find any accessory is missing or the machine has arrived with any problems,

please contact your local dealer at once. Do not try to fix this item yourself or you

will lose the warranty. Please keep the original package and invoice for any possible

replacement or returned demand.

RECOMMENDED FLUID:

For the FH-700 haze machine we strongly recommend the following fluid which has

been specifically formulated to perform best with any heater based haze machines.

QTX Ref Code

Description

Size

Results

160.590UK

High quality

professional Haze fluid

1 Litre

High quality ultra

fine mist

160.591UK

5 Litre

160.458UK User Manual

SETUP:

1. Unpack the FH-700 unit.

2. Unscrew the top cap of the tank and remove to fill with the recommended

haze fluid.

3. Replace the bottle and screw the cap securely ensuring the pipe is fed down to

the bottom of the bottle so a consistent flow of fluid is supplied to the

machine.

4. Connect the remote control.

5. Connect the IEC mains plug and power up.

6. Heat up time is usually between 5-6 minutes. Please ensure no button is

pressed during the heat up time. When the machine is ready the LED light on

the remote control will illuminate.

7. Turn the output to max and press the green button on the remote control for

5 seconds so the fluid has a chance to flow through the heater block making it

ready to use.

8. After this adjust the fan speed on the unit and the output on the remote

control to find the level you desire. It is recommended to produce haze/fog

with small pauses in between so that the temperature is maintained and the

thermostat doesn’t switch off.

CAUTION! TO PREVENT MORTAL ELECTRICAL RISK AND LONG LIFE OPERATION:

For your safety, please kindly pay attention to all of the warnings listed below:

Always plug in the power plug last and disconnect from the mains when the

device is not in use or before cleaning.

Do not install and operate the device in rain or extreme heat, moisture or dusty

environments.

This device is for indoor use only and in a dry environment.

Do not switch on immediately but wait until it reaches to room temperature if

the device has been exposed to drastic temperature fluctuations.

Do not shake the device and avoid brute force when installing or operating.

Do not use the device during thunderstorms and please disconnect the power.

Do not use solvents or aggressive detergent to clean the device. Use a soft and

clean cloth.

Do not modify the device or the connected power cord without authorisation.

160.458UK User Manual

CONNECT WITH POWER SUPPLY –THE GROUND WIRE MUST BE CONNECTED:

Use the plug to connect to the main power supply as follows:

Wire

Connection

International signal

Brown

Live

Blue

Neutral

Yellow /Cyan

Earth

QUICK TROUBLE SHOOTING

If the unit is not functioning properly

Check if main power is on.

Check the fuse hasn’t blown.

Check the unit isn’t in DMX mode.

Check there is fluid in the tank and the pipe is pushed down to the bottom of the bottle

If there is blockage use distilled water or haze machine cleaning fluid

REPLACING FUSE

Disconnect from the main power supply first. Then remove the fuse holder above the IEC

Socket to reveal the fuse. Replace the correct fuse rating as stated on lighting or user guide.

Then, lock the fuse holder cover back into place.

GENERAL MAINTENANCE

To maintain optimum performance and minimize wear, the item should be cleaned frequently.

Usage and environment are contributing factors in determining frequency. As a general rule,

fixtures should be cleaned after use to avoid dust build-up and blockages, which can result in

poor performances, overheating and breakages. Be sure to power off fixture before conducting

maintenance.

Unplug fixture from power. Use a vacuum or air compressor and a soft brush to remove dust

collected on external vents and internal components. Clean the external case when the fixture

is cold with a dry cloth or tissue, and drag dirt and grime to the outside case.

160.458UK User Manual

LAYOUT FH-700:

1. Carry handle

2. Haze nozzle output

3. Bottle cap and feed tube

4. Removable bottle

5. Fill level indication

160.458UK User Manual

REAR PANEL FH-700:

1. Power ON/OFF

2. Power IN (Use IEC lead provided)

3. Controller connection

4. Fan Speed*

*Fan Speed control: The FH-700 features a manually adjustable fan to control the distance the

fog / haze can be dispersed.

Generally low speeds are suitable for small areas where as higher speeds are for larger areas.

160.458UK User Manual

TIMER CONTROLLER

1. Timer on/off button

2. Continuous output

3. Manual override button

4. Timer LED indicator (Illuminated Yellow when timer active)

5. Manual ready indicator (Illuminates Green when ready)

6. Power indicator (Illuminates red when power is on)

7. Adjust the output level between 0-100%. Generally 0-30% is haze effect and 31-100%

is Fog level output.

NOTE:

The below controls are only used when in timer mode

8. Adjust the interval gap between each release (between 0 –30 Min approximately)

9. Adjust the duration the Haze / Haze is released at each interval (between 0 –15

seconds approximately)

For best results select “continuous” and adjust output to achieve desired effect, note it

can take around 30 seconds for the machine to produce the correct output.

160.458UK User Manual

TECHNICAL SPECIFICATION

Power supply

230Vac, 50Hz

Fuse

F5A

Power

700W

Re-heat time

5-6 min (approx.)

Haze Output

6,000 Cu Ft (170m³) per minute

Tank capacity

2.5 Litres

Dimensions

400 x 215 x 210mm

Weight

5.3kg

DISPOSAL:

Please disposal of the unserviceable device according to the current statutory requirements.

Errors and omissions excepted.

Tabla de contenidos

Manuales populares de Máquina de niebla de otras marcas

Antari

Antari ICE Manual de usuario

Boost

Boost BOOST-FOG400LED-BK Manual de usuario

Home Accents Holiday

Home Accents Holiday FM1000-ASH Manual de usuario

EuroLite

EuroLite ZEITGEIST FOG-1200 Manual de usuario

Dyna-Fog

Dyna-Fog CYCLONE ULTRA 2734 Manual de usuario

PROEL

PROEL DRAGO HEAVY PLFD150HY Manual de usuario

Sparklyn

Sparklyn Y846 Manual de usuario

Magicfx

Magicfx CO2 Gun Manual de usuario

Ibiza

Ibiza LSM500LAS Manual de usuario

Antari

Antari M-5 Manual de usuario

Venue Lighting Effects

Venue Lighting Effects ULTRA MINI-FOGGER Manual de usuario

High End

High End F-100 Manual de usuario

Chauvet

Chauvet ARENA 2100 FLEX Manual de usuario

Antari

Antari X FAZER Manual de usuario

Beamz

Beamz F1600 Manual de usuario

Sagitter

Sagitter SG ARS900C Manual de usuario

KISANKRAFT

KISANKRAFT KK-STF-480 Manual de usuario

Orion

Orion OT-U250PP Guía