QOLSYS IQ Tilt S Manual de usuario

IQ TILT S-LINE QUICK INSTALL GUIDE

Sensor: 2.5”H x 1”W x .5”D

Wireless signal range: 600ft (200M), open air.

Code outputs: tamper, tamper restore, alarm, alarm

restore, low battery.

Transmitter frequency: 319.5 MHz

Unique code ID

Supervisory keep-alive interval: 70 minutes.

RF Peak field strength: typical 36000 uV/m at 3m

Operating Temperature: -10C~50C

Relative Humidity: 5-95% Non-Condensing

Storage Temperature: -40-80C

Replace battery with exact replacement every 5 years

with 3V Lithium (x2).

(2) -Panasonic CR2032

-Energizer CR2032

-Duracell DL2032

SPECIFICATIONS

The IQ Tilt is designed to tell you whether an overhead garage door is open or closed. The tilt

sensor houses a cylinder with a metal bearing inside. When the sensor is tilted, the bearing rolls

down the cylinder towards from the metal contacts. This connects a circuit and sends a signal to

the panel saying that the garage has been opened. NOTE: Improper orientation and/or placement of

the bearing cylinder may result in false alarms or incorrect signals.

STEP

REMOVE

BATTERY

TABS

STEP

APPLY

ADHESIVE

TUBE

ORIENTATION

STEP

The cylinder should be

angled inside the

sensor housing as

shown

This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)

OVERVIEW

Document#: IQTILT-SQG-11-17

Revision#: 11/7/17

Issue Date: NOV 2017

Qolsys Product #: QS1131-840

STEP

LEARN

INTO

PANEL

STEP

CHOOSE

INSTALL

LOCATION

Mount the sensor horizontally with the

arrow facing UP, as shown.

Note: The “arrow” on the

side of the sensor should

be facing up.

SENSOR

PLACEMENT

Choose a mounting position on the top panel of the door.

Place your panel in

“autolearn" mode

Customize name and settings

as desired and and touch “ADD”

ADD

Open and close the case

to “tamper” the device

TechSupport@Qolsys.com

Qolsys Inc. proprietary.

Reproduction without permission is not permitted.

FCC ID: 2ABBZ-RF-CHW-S

IC: 11817A-RFCHWS

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired

operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute

interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.

CONTACT TECH SUPPORT

GOT QUESTIONS?

SECURE

CONNECTS

USING

319.5 MHz

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios de QOLSYS