Pyle PSW976S Manual de usuario

Multifunctional wall mount

IMPORTANT: If don’t understand about right install ways, please

consult to normal installing specialist.

IMPORTANT:

Item No.:PSW976SItem No.:PSW976S

INSTALLATION GUIDE

-12-

Ideal for Flat Panels from 32 to 50""

Weight Capacity:15kg/33lbs~60kg/132lbs

Adjustable Tilt

Adjustable Roll Control

Adjusting the display

Note:

This mount provides a wealth of display adjustment to offer the best viewing from a

number of seating positions. See Fig. 6.

Vertical Tilt Adjustment Angle

Vertical adjustment angle is -5º to 15º.

Left to Right Swivel Adjustment Angle

The display can swivel ±60º from left to right. Choose the desired position and use

provided Wrench to tighten the back bolt on the top of the Arm Assembly.

Stowing the Display -Positions the display against the wall Grasp the side edges of the

display, swivel and pull the display into the center position, and then push the display

straight back towards the wall into the stowed position.

Use care when stowing the display to ensure that cables do not become pinched.

Lateral Tilt adjustment angle is ±5º.

Left to Right Pan Adjustment Angle

The display can pan ±60º from left to right. Choose the desired position and use

provided Wrench to tighten the front bolt on the top of the Arm Assembly.

Adjusting the display

Note:

Fig. 6

±60°

-5 15°~ °

±60°

±5°

www pyleaudio com..

MADE IN CHINA

Bulit in leveler system

Pyle Audio

1600 63rd st , Brooklyn, NY, 11204

(718)236-8000

-2- -11-

Contents of the ox: Hardware shown as actual size

Make sure that none of these parts are missing before beginning

installation. If there are parts missing stop the installation and contact us.

Contents of the ox: Hardware shown as actual size

Right Bracket

Cable management clip

Square washer

Long bolt

Wall anchor

Long bolt washer

Spacer

ID Description

Arm Assembly

Left Bracket

Plastic Cover

M4 mm×12 bolt

M4 mm×16 bolt

M5× mm16 bolt

M6× mm16 bolt

M8×16mm bolt

M ×36mm5 bolt

M6×36mm bolt

M ×36mm8 bolt

Qty

A-H L

ID Description

Qty

Step 5:Using Cable Management

This mount includes a cable management feature, where cables can be routed along

length of the Arm Assembly. Route the signal cables and power cable along the Cable

management clip as shown in Fig.5. Be sure to leave enough slack for all cables.

With all cables in place, swivel the display at each pivot and check that the Arm

Assembly moves freely, without stretching or damaging the cables.

Step 5:Using Cable Management

5X5 Wrench

4X4 Wrench

Cable management clip

Cable routing access points

Fig. 5

-10- -3-

WARNING

We are not responsible for any personal injury or product damage due to mishandling,

incorrect mounting, incorrect assembly or incorrect use of this product.

The supplied wall mounting hardware is not for use on steel stud walls or cold

cinder block walls. If you are uncertain about the nature of your wall, please consult a

qualified contractor. If the hardware you required is not included please contact your

local hardware store.

Note:

Caution:This Product LCD /Plasma Wall Mount Bracket is intended for use only

with the maximum weights indicated .See apparatus instructions .Use with products

heavier than the maximum weights indicated may result in instability causing possible

injury .

Caution:

Fig 4b

2,3

Knob

Fig 4c

Lock

Open

Lock

Closed

Rod

Step 1: Attach bracket to TV

Check your TV manual to confirm the diameter of bolt to be used or choose an

appropriate bolt according to size, height and position of the holes on your TV. See

pages 4-5 of these instructions for examples.

"" .

For correct installing, make sure that hook of every bracket must facing down. Use

selected bolts, spacers and washers for installing bracket at the back of display.

Adjust two brackets to equal heights and level. Once aligned, tightly secure the

bolts. the UP side on the top As shown in Fig.1.

Don't force the bolt into the hole, which will cause a damage of

equipments and injure of person. Don't use electric drill to fasten any bolts.

Note:

IMPORTANT:

Step 1: Attach bracket to TV

IMPORTANT

Note:

Fig 1

-4- -9-

Following examples shows how to use bolts, spacers and square washers.

1.Some displays have vertical backs. No spacer is required. Install the bracket directly

to the back of display by using bolts and square washers provided. As shown in Fig.1a.

Step 3: Installing the Plastic Cover

Secure the separated Plastic Cover over the Wall Plate by pushing them

towardeachotheruntiltheylockinplace.SeeFig.3.

Step 3: Installing the Plastic Cover

Plastic Cover

Fig. 3

Fig. 4a

Step 4: Hang the Display

Note:

With the help of an assistant, lift the display

intopositioninfrontofthewallplate.

Align the slots on the mounting rails with the

rods on the wall plate, and then lower the

display onto the rods. (Fig. 4c) Make sure that

both rods are fully engaged before releasing

the display.

Prior to lifting the display, make sure

that the flip lock is in the open position, as

shown in Fig. 4a.

Once in place, the lateral position of the

display can be adjusted by gently sliding it

along the rods.

(Fig. 4b)

Step 4: Hang the Display

Note:

Safety Lock

Knob

Lock

Closed

Lock

Open

Fig 1a

M4 Fig bit M5 Fig bit

M6 Fig bit

A,B

M8 Fig bit

-8- -5-

2. Some displays have curved backs with

recessed mounting lands(Fig.a). It will

require the use of spacer. For this display,

install a spacer(M) between display and

thebracket.AsshowninFig1b.

Fig a

Brick, Concrete and Stone wall:

Using a awl or nail to make where the nails are located. Distance between two nails

for fixing wall mount must not less than 16 . Pre-drill these holes with a 10mm drill

bit to at least 80mm in deep hole. Use wall mount as a template to mark the location

of other three holes and drill the same holes. Please make sure these holes are level

and eudipleural. Insert wall anchors(K) into each of these holes. Attach the wall

mount to the wall using 4 long bolts(J) and washers(L).

”

Brick, Concrete and Stone wall:

Fig. 2e

Concrete Wall

Fig. 2d

Fig 1b

M6 Fig bit

M5 Fig bit

M8 Fig bit

-6- -7-

15 degree

viewing angle

eyelevel

Fig 2a

Step 2: mount to wall

First, determine the height of stand

The best height of stand is parallel to eyelevel of a person who sitting on a couch.

Normally, the horizontal distance of eyelevel is about 4’ from ground level.

The following two conditions are for determining the perfect height of stand:

1) the distance between wall and couch(Fig 2a).

2) the distance of eyelevel from ground level plus the distance measured from

eyelevel of a person sitting on couch with viewing angle of 15 (Fig 2a).

For example:

1) the distance of ‘a’ is 5’-7’, the distance of ‘b’ is about 1’

2) the distance of ‘a’ is 8’-13’, the distance of ‘b’ is about 3’

3) the distance of ‘a’ is 14’-17’, the distance of ‘b’ is about 4’

The perfect height of stand centre will be anywhere within b, where you feel

comfortable for viewing.

AttachStep 2: Attach mount to wall

After determining the height of stand, follow the installation instructions in below

to install wall mount to different kinds of wall

Using a awl or nail to make where the nails are located, as shown as Fig.2b. Distance

between two nails for fixing wall mount must not less than 16 . Pre-drill these holes

with a 5mm drill bit to at least 80mm in deep hole. Use wall mount as a template to

mark the location of other three holes and drill the same holes.

Fix the wall mount to the wall with 4 long bolts(J) and

washers(L).

-wooden, brick, concrete and stone.

Please make sure these

holes are level and eudipleural.

Wooden wall:

”

Wooden wall:

Fig. 2b

16”

Fig. 2c

Wood stud

Tabla de contenidos

Otros manuales de Soporte de TV de Pyle

Manuales populares de Soporte de TV de otras marcas

Ergotron

Ergotron Neo Flex Cantilever UHD Manual de usuario

StarTech.com

StarTech.com FPCEILBTB Manual de usuario

VonHaus

VonHaus 05/038 Manual de usuario

Techlink

Techlink ECHO TV Manual de usuario

Sandstrom

Sandstrom SSTVMC12X Manual de usuario

Sony

Sony SU-WL700 Guía

ICW

ICW SCACC18 Manual de usuario

LG WM-L640V Manual de usuario

Gembird

Gembird WM-65ST-01 Manual de usuario

ERARD

ERARD FiTUP XXL 035320 Manual de usuario

PEERLESS

PEERLESS PLCK-1 Guía

Kanto

Kanto RCF180 Manual de usuario

GEM

GEM GEM GP001 Manual de usuario

Gladiator Joe

Gladiator Joe GJ0A0053 Manual de usuario

Vivotek

Vivotek AM-105 Manual de usuario

Vivo

Vivo VESA STAND-VAD1B Manual de usuario

AmazonBasics

AmazonBasics B07QG3LMG4 Manual de usuario

Secura

Secura QLF210 Manual de usuario