Pyle PMD43 Manual de usuario
www.pyleaudio.com
METAL / CURRENT DETECTOR
PMD43 USER’S GUIDE
Thanks for buying our product. Please go through the
instruction manual before using the meter and carefully
follow these safety rules.
1) Locate battery cover and turn it counter-clock wise
using a coin to open.
2) Insert the battery in the sleeve and close (battery
not included).
3) Turn on the device by turning the wheel.
Keep turning the wheel until the indicator light
comes on and the alarm sounds.
Make sure that no metal or conductive object is
near the unit. Turn the wheel in the reverse
direction until the light and alarm turn off. The
device will then be ready to use.
4) If the indicator light does not work, turn the wheel a
half turn and slowly turn the adjustment resistor
using a screwdriver until the alarm comes on or
goes off according to the desired setting.
5) To detect metal objects, hold the device by the
handle and move the device horizontally against
the wall. The alarm will sound when there is a
metallic object nearby.
6) Electrically conductive objects will be indicated by a
flashing light that will become continuous when the
device is close to the conductor.
IMPORTANT
This device’s sensitivity can be adjusted to the exact
position of a metallic object or electrical conductor.
First, set the wheel. Once the light goes off, turn the
wheel a little further to narrow the detection zone.
SAFETY
When the device indicates “no current” (no flashing
light), check the device by operating it close to a place
where you know there is a current before touching the
conductor.
CAUTION
Protected conductors will not be detected: only metal
will be detected.
NOTES
1) Certain walls contain metallic fire-resistant fibres.
This can create an electrical field. You can cancel
this effect by putting your hand against the wall.
2) Rubbing or hitting the detector against the wall can
create static electricity leading to a read error.
CURRENT LOSSES
Due to the low level of current used to trigger lighting,
some detectors can appear to be faulty. A poorly
insulated conductor touching a wet wall will lead to
detection of current on the wall.
In this case, the device will indicate a potential danger
that should be checked using a voltmeter.
Tabla de contenidos
Otros manuales de Detector de metales de Pyle
Pyle
Pyle PMD58 Manual de usuario
Pyle
Pyle PHMD72 Manual de usuario
Pyle
Pyle PHMD84 Manual de usuario
Pyle
Pyle Secure Scan PMD38 Manual de usuario
Pyle
Pyle PMD24 Manual de usuario
Pyle
Pyle PHMD2 Manual de usuario
Pyle
Pyle PHMD3 Manual de usuario
Pyle
Pyle PHMD74 Manual de usuario
Pyle
Pyle PHMD55 Manual de usuario
Pyle
Pyle PHMD53 Manual de usuario
Manuales populares de Detector de metales de otras marcas
Steinberg Systems
Steinberg Systems SBS-MD-12 Manual de usuario
GOLDEN MASK
GOLDEN MASK 5 Manual de usuario
Grizzly
Grizzly YM 203 Manual de usuario
Fisher Research Labs
Fisher Research Labs 1280-X Aquanaut Manual de usuario
Treasure Cove
Treasure Cove Vibra-Probe 560 Manual de usuario
Accurate Locators
Accurate Locators XL16 IMAGER Manual de usuario