Puretec UFC Series Manual de usuario
UFC Series User Guide
High pressure Filter Housing
For correct operation & installation it is essential to observe these instructions.
FEB2017
2
Installation & Operation Manual Copyright © Puretec Pty Ltd 2017
Puretec Customer Service
Thank you for purchasing a Puretec Drinking Water Appliance. Your system is a proven
performer manufactured from only quality materials and components. It will give years
of reliability and trouble free operation if maintained properly.
This user guide is designed for Puretec Drinking Water Appliance. Be careful to ensure
the information and illustration is applicable to your particular unit.
Caution: Do not use with water that is microbiologically unsafe or without adequate
disinfection before or aer the system.
Flush system for 5 minutes or more, aer any period of non-use, more than 2 weeks.
Note: For point of entry installations an approved dual check backow prevention
device must be installed. Where maximum line pressure exceeds 690 kPa, a
pressure limiting valve must be installed.
AUSTRALIA
Customer Service: 1300 140 140
Email: [email protected]
Web: www.puretec.com.au
NEW ZEALAND
Customer Service: 0800 130 140
Email: [email protected]
Web: www.puretec.co.nz
Customer Support Established Manufacturer On the road support
3
Copyright © Puretec Pty Ltd 2017 UFC Series User Guide
What's Inside
What's Inside
Puretec Customer Service .............................................................................................................................. 2
Installation Record .............................................................................................................................................. 4
Before Installation................................................................................................................................................4
Specications..........................................................................................................................................................5
Installation Procedure........................................................................................................................................6
Filter Maintenance ...............................................................................................................................................7
Warranty....................................................................................................................................................................9
4
Installation & Operation Manual Copyright © Puretec Pty Ltd 2017
Introduction
This product is a high pressure lter and can lter tap water, ground water, cooling water,
RO extraction and trade waste water by bag ltration or an RO reverse strain core.
The lter is made of from stainless steel and is welded to ensure maximum strength.
The housing cap can be completely removed from the housing making lter change easy.
The lter is tted with an adapter to suit multiple types of cartridge styles. A xed lip on
the inside of the lter is used for securing a bag lter and a bag lter basket protects
the bag from damage
5
Copyright © Puretec Pty Ltd 2017 UFC Series User Guide
PRODUCT INFORMATION
Model Number
Serial / Batch Number
Purchased from:
Date of Installation
Installer / Plumber Details
Installation Record
For future reference, ll in the following data
Before Installation
Before Installation
Read the instructions, check that there is no damage to the unit and check if there
is adequate space to mount the components. This product is a pressure vessel and
adjustment to the unit should be done by a qualied professional such as a boilermaker.
Note: Not all ttings are supplied with the unit. Isolation valves are not supplied.
Check the mains water pressure is between 172 - 690kPa
NOTE: This product must be tted to MAINS WATER ONLY
6
Installation & Operation Manual Copyright © Puretec Pty Ltd 2017
Specications
Specications
Operating pressure min/max (water) 0 - 690 kPa
Operating temperature min/max 4 - 99°C
Inlet/outlet connection 50mm Flange
7
Copyright © Puretec Pty Ltd 2017 UFC Series User Guide
Specications
8
Installation & Operation Manual Copyright © Puretec Pty Ltd 2017
Installation
This lter housing must be installed on solid level ground. Vibration mounts can be used
to reduce the risk of tank rupture if the unit is being mounted near heavy machinery.
A pressure relief valve should be installed before the inlet to protect the system from
pressure surges.
The use of union ttings before and aer the unit is advised to allow for unit removal
during servicing.
All attached pipe work should be independently supported and should not induce any
load on the lter housing.
INSTALLING THE UNIT
1. Connect the water inlet pipe work to the inlet ange.
2. Connect the water outlet ange to the outlet pipe work.
3. Install the drain valve in the drain port on the underside of the unit.
4. Install the pressure gauge and vent valve to the vent port on the cap of the unit.
5. Undo the clamp and remove clamp.
6. Remove the lter housing lid.
7. Undo the nut on the cartridge adaptor and remove the adaptor from the lter
housing.
8. Remove the top plate from the adaptor.
9. Insert the adaptor into the centre of the cartridge and reattach the top plate of the
adapter.
10. Make sure the adapter components are all aligned withing the centre of the lter
cartridge.
11. Fasten the nut until rm and install the lter cartridge into the housing.
12. Check the O-ring is in the grove on the lip of the lter housing.
13. Place the housing lid in place and install the clamp.
14. Tighten the clamp screw tightly.
15. Close the drain port
16. Open the vent valve.
17. Open the water ow
18. Close the vent valve when water ows from the vent.
19. Check the unit pressure to ensure there are no leaks.
9
Copyright © Puretec Pty Ltd 2017 UFC Series User Guide
Maintenance
SYSTEM MAINTENANCE
Before performing any maintenance please close the inlet valve and release pressure via
the drain port.
MAINTENANCE CYCLE
Filter housing Keep the lter housing clear of debris and
sharp objects or unnecessary items.
Everyday
Pressure gauge Check that the pressure is within the correct
specications
Everyday
Water outlet Check for leaks Everyday
Water inlet Check for leaks Everyday
Tank body Make sure there are no cracks or stress
marks on the housing or any welds
Monthly
Support frame Make sure there are no cracks or stress
marks on the support frame or any welds
Monthly
Housing lid Check for leaks and ensure O-ring is
lubricated. Replace O-ring if perished.
Monthly
Filter bag Replace with new lter bag Monthly
If any damage, stress or cracks are fount in either the housing, frame or any welds,
please do not use the unit and contact Puretec immediately.
10
Installation & Operation Manual Copyright © Puretec Pty Ltd 2017
Dierential pressure
It is important to regularly check the pressure dierential across the unit during
operation. Operating above the recommended pressure will aect the ow rate and
reduce the eciency. When the dierential pressure exceeds 1.10kg/cm2 it is time to
replace the bag lter. (See pg.6)
If the pressure dierential drops suddenly, cease operation and isolate the unit, purge
the water from the unit and check the unit thoroughly for stress or fractures. Sudden
pressure uctuations can cause seal failure and/or lter rupture.
A lack of dierential pressure indicates that no ltration is taking place. When ltration
is taking place the inlet pressure should be slightly higher than the outlet pressure.
Dierential pressure will gradually increase as the lters start to retain more debris. If
a lack of dierential pressure is detected, stop the system and check for seal leaks or
housing ruptures.
Operation
Otros manuales para UFC Series
1
Tabla de contenidos
Otros manuales de Sistema de filtración de agua de Puretec
Puretec
Puretec FilterWall IM2 Series Manual de usuario
Puretec
Puretec 2CI-C Manual de usuario
Puretec
Puretec RO SERIES Manual de usuario
Puretec
Puretec Z1-MW-K Manual de usuario
Puretec
Puretec NTR-E3 Series Manual de usuario
Puretec
Puretec IF Series Manual de usuario
Puretec
Puretec CFS 2CI Series Manual de usuario
Puretec
Puretec Basic HD Series Manual de usuario
Puretec
Puretec HybridPlus Series Manual de usuario
Puretec
Puretec CR-Z2 Manual de usuario
Puretec
Puretec QT12 Manual de usuario
Puretec
Puretec ROS2700 Manual de usuario
Puretec
Puretec Z1-RW-K Manual de usuario
Puretec
Puretec HYBRID H6 Manual de usuario
Puretec
Puretec RI-HF19 Manual de usuario
Puretec
Puretec CFS Series Manual de usuario
Puretec
Puretec Hybrid-M1 Manual de usuario
Puretec
Puretec WU-UV Series Manual de usuario
Puretec
Puretec IL-UB Series Manual de usuario
Puretec
Puretec RO270 Manual de usuario
