4 Installation & Operation Manual Copyright © Puretec Pty Ltd 2022
Before Installation
VERY IMPORTANT! Carefully read through this instruction booklet and check
that all requirements can be met. Faulure to meet requirements may result in
voided warranty.
• Check the mains water pressure is between 138 - 500kPa.
Note: Where maximum line pressure exceeds 500, the supplied multivalve must be
installed to comply with Australian Plumbing Standards.
• The Sparq S6 system is designed for mains/towns warter supply only.
• The Puretec Sparq S6 is designed for domestic use only. Non-domestic use
will result in voided warranty.
•Caution: Do not use with water that is microbiologically unsafe or without
adequate disinfection before or aer the system.
• Check the appliance rating plate and ensure correct power supply is available for
the appliance and the relevant circuit will not be overloaded (see Specifications).
• Check both unit and tap locations are within reach of each other and within reach
of the power and water connections
• Check there is sufficient room for the appliance inclusive of ventilation requirements
within the cupboard and that the cupboard is capable of supporting the appliance
with a net weight of 24 kg including the gas bottle (see Fig. 1).
Note: It may be required for additional ventilation to be installed within the
cupboard/door to ensure there is adequate cross ventilation to mitigate cupboard
temperature reaching 40°C or above. Inadequate ventilation can lead to malfunction
and void warranty.
Installation Note: A water filter system/tap, like any product, has a limited life and may
eventually fail. Also sometimes failure happens early due to unforeseen circumstances.
To avoid possible property damage, this product should be regularly examined for
leakage and/or deterioration and replaced when necessary. A drain pan, plumbed to an
appropriate drain or outfitted with a leak detector, should be used in those applications
where any leakage could cause property damage, and/or the water supply should be
turned off if no one is home/present.
Before Installation
