910
TTL Flash
Set
the
camera's
shooting
mode
to
<P>(
Program
automatic
exposure)
or < >(Auto),when fully automatic flash will make photography
became as simple as <P> mode and < > mode under normal automatic
exposure.
Set the flash exposure compensation value
1.Select the flash mode
2.Press 【MODE】 mode button until
the LCD display
Canon
Nikon
Set the flash exposure compensation value.
When press five select button settings
group【Up】 【Down】to set the
compensation value.
1.Select the Settings button group【RIGHT】keys,power values increase
sequentially.
Select the Settings button group【LEFT】keys,power values decrease
sequentially.
2.The compensation value is in the range of +3.0EV to -3.0EV.
The compensation value icon:
0EV→+0.3EV→+0.7EV→+1.0EV→+1.3EV→+1.7EV→....→+3.0EV
0EV→-0.3EV→-0.7EV→-1.0EV→-1.3EV→-1.7EV→....→-3.0EV
State of charge indicator
Before shooting,confirmed that flash charging
indicator light and camera viewfinder lights
have been lit.
Turn on the power
1.The external power connector
Provides more adequate power.
2.Conetect with the PC sync
Make sure camera and speedlite synchronized flash.
following:
After automatically shut off power opened,When the speedlite do
not working within 60 seconds,the CPU automatically into Sleep.In this
case press any key to wake up the speedlite.When the speedlite does not
work for more than 30 minutes,the CPU will shut down automatically.
