Protech Systems BA-2501 Manual de usuario

USER

MANUAL

BA-2501

ATXIntel®6th/7th Gen.CoreTM

i7/i5/i3/Pentium®/

Celeron®Processor

BA-2501 M1

BA-2501

ATX Intel®6th/7th Gen. CoreTM i7/i5/i3/

Pentium®/ Celeron®Processor

All trademarks and registered trademarks mentioned herein are the

property of their respective owners.

This manual is copyrighted in August 2017. You may not

reproduce or transmit in any form or by any means, electronic,

or mechanical, including photocopying and recording.

DISCLAIMER

This user’s manual is meant to assist users in installing and setting up

the system. The information contained in this document is subject to

change without any notice.

CE NOTICE

This is a class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

FCC NOTICE

This equipment has been tested and found to comply with the limits for

a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

You are cautioned that any change or modifications to the equipment

not expressly approve by the party responsible for compliance could

void your authority to operate such equipment.

CAUTION: Danger of explosion may occur when the battery

is incorrectly replaced. Replace the battery only with the

same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer’s

instructions.

WARNING: Some internal parts of the system may have high

electrical voltage. We strongly recommend that only qualified

engineers are allowed to service and disassemble the

system. If any damages should occur on the system and are

caused by unauthorized servicing, it will not be covered by

the product warranty.

Contents

1 Introduction ......................................................................................... 1-1

1.1 About This Manual .................................................................... 1-2

2 Getting Started .................................................................................... 2-1

2.1 Packing List ............................................................................... 2-2

2.2 BA-2501 Specifications ............................................................. 2-3

2.3 Safety Precautions .................................................................... 2-6

3 Hardware Configuration ..................................................................... 3-1

3.1 JUMPER & CONNECTOR QUICK REFERENCE TABLE ........ 3-2

3.2 COMPONENT LOCATIONS ..................................................... 3-4

3.2.1 Top View of BA-2501RA-**N ............................................. 3-4

3.2.2 Jumper Setting of BA-2501RA-**N.................................... 3-6

3.2.3 I/O View of BA-2501RA-**N .............................................. 3-7

3.3 HOW TO SET JUMPERS ......................................................... 3-8

3.4 Setting Connectors and Jumpers ............................................ 3-10

3.4.1 COM1 and COM2 PORT ................................................. 3-10

3.4.2 COM3, COM4, COM5, COM6 CONNECTOR ................. 3-11

3.4.3 COM3 and COM4 PIN9 DEFINITION SELECTION GUIDE

......................................................................................... 3-12

3.4.4 Programmable GPIO PIN HEADER ................................ 3-13

3.4.5 KEYBOARD & MOUSE PORT ........................................ 3-14

3.4.6 DVI (Digital Video Interface) PORT ................................. 3-15

3.4.7 VGA PORT ...................................................................... 3-16

3.4.8 FRONT PANEL CONNECTOR ........................................ 3-17

3.4.9 LAN & USB PORT ........................................................... 3-18

3.4.10 LINE-IN, LINE-OUT, MIC-IN PORT ................................. 3-21

3.4.11 EMBEDDED DISPLAY PORT (EDP) CONNECTOR

(OPTION) (For C236/Q170 only) .................................... 3-22

3.4.12 FRONT PANEL AUDIO CONNECTOR ........................... 3-23

3.4.13 HARDWARE POWER FAILURE SELECTION ............... 3-24

3.4.14 FLASH DESCRIPTOR OVERRIDE SELECTION ........... 3-25

3.4.15 LAN2 ENABLE / DISABLE SELECTION......................... 3-26

3.4.16 MINI PCIE and MSATA SELECTION .............................. 3-27

3.4.17 VCCIO VOLTAGE SELECTION ...................................... 3-28

3.4.18 PCH CONFIGURATION / RECOVERY SELECTION ..... 3-29

3.4.19 CASE OPEN DETECTION SELECTION ........................ 3-30

3.4.20 MINI PCIE VOLTAGE SELECTION ................................ 3-31

3.4.21 PARALLEL PORT (LPT) CONNECTOR (For C236 SKU only)

......................................................................................... 3-32

3.4.22 I2C WAFER ..................................................................... 3-33

3.4.23 MINI PCI EXPRESS SLOT ............................................. 3-34

3.4.24 PCIE Bus ......................................................................... 3-35

3.4.25 PCI BUS CONNECTOR .................................................. 3-38

3.4.26 CPU / SYSTEM FAN CONNECTOR ............................... 3-39

3.4.27 SERIAL ATA (SATA) CONNECTOR ................................ 3-40

3.4.28 INTERNAL USB 3.0 CONNECTOR ................................ 3-42

3.4.29 INTERNAL USB 2.0 CONNECTOR ................................ 3-43

3.4.30 DISPLAY PORT CONNECTOR (OPTION) ..................... 3-44

3.4.31 SPEAKER CONNECTOR ............................................... 3-45

3.4.32 POWER INPUT CONNECTOR ....................................... 3-46

3.4.33 LPC CONNECTOR ......................................................... 3-47

3.4.34 CLEAR CMOS DATA SELECTION ................................. 3-48

4 Software Utilities ................................................................................. 4-1

iii

4.1 Introduction ................................................................................ 4-2

4.2 Installing Intel® Chipset Software Installation Utility .................. 4-4

4.3 Installing VGA Driver Utility ....................................................... 4-5

4.4 Installing LAN Driver Utility ........................................................ 4-6

4.5 Installing Sound Driver Utility .................................................... 4-7

4.6 Intel® Management Engine Components Installer Installation .. 4-8

4.7 Installing RAID Driver Utility (Only for C236/Q170, Optional) ... 4-9

4.8 Installing Intel® F6 Floppy Disk Driver Utility ........................... 4-11

4.9 Installing Intel® Serial I/O Driver Utility .................................... 4-11

4.10 Installing Intel® USB 3.0 eXtensible Host Controller Utility ..... 4-12

5 BIOS SETUP ........................................................................................ 5-1

5.1 Introduction ................................................................................ 5-2

5.2 Accessing Setup Utility .............................................................. 5-3

5.3 Main ........................................................................................... 5-6

5.4 Advanced .................................................................................. 5-8

5.4.1 Advanced – CPU Configuration ........................................ 5-9

5.4.2 Advanced - SATA Configuration ...................................... 5-10

5.4.3 Advanced – PCH-FW Configuration ................................ 5-11

5.4.4 Advanced – Trusted Computing (option) ......................... 5-12

5.4.5 Advanced – ACPI Settings .............................................. 5-14

5.4.6 Advanced – F81866 Super IO Configuration .................. 5-15

F81866 Super IO Configuration – Serial Port 1 Configuration .... 5-16

F81866 Super IO Configuration – Serial Port 2 Configuration .... 5-17

F81866 Super IO Configuration – Serial Port 3 Configuration (For

C236/Q170 Only) ......................................................................... 5-18

F81866 Super IO Configuration – Serial Port 4 Configuration (For

C236/Q170 Only) ......................................................................... 5-19

F81866 Super IO Configuration – Serial Port 5 Configuration (For

C236 Only) .................................................................................. 5-20

F81866 Super IO Configuration – Serial Port 6 Configuration (For

C236 Only) .................................................................................. 5-21

F81866 Super IO Configuration – Parallel Port Configuration (For

C236/Q170 Only) ......................................................................... 5-22

5.4.7 Advanced – Hardware Monitor ........................................ 5-23

Smart Fan Mode Configuration ................................................... 5-25

5.4.8 Advanced – F81866 Watchdog ....................................... 5-26

5.4.9 Advanced – S5 RTC Wake Settings ................................ 5-27

5.4.10 Advanced – Network Stack Configuration ....................... 5-30

5.4.11 Advanced – USB Configuration ....................................... 5-31

5.5 Chipset .................................................................................... 5-32

5.5.1 Chipset – System Agent (SA) Configuration ................... 5-33

System Agent (SA) Configuration – Memory Configuration ........ 5-34

System Agent (SA) Configuration – Graphics Configuration ....... 5-35

System Agent (SA) Configuration – Graphics Configuration – LCD

Control ......................................................................................... 5-36

System Agent (SA) Configuration – PEG Port Configuration ...... 5-37

5.5.2 Chipset – PCH IO Configuratioin ..................................... 5-38

PCH-IO Configuration – PCI Express Configuration ................... 5-39

PCH-IO Configuration – PCI Express Configuration – PCI Express

x4 slot .......................................................................................... 5-40

PCH-IO Configuration – PCI Express Configuration – Mini PCI

Express Port Configuration ......................................................... 5-41

5.6 Security ................................................................................... 5-43

5.7 Boot ......................................................................................... 5-45

5.7.1 Boot – CSM Configuration ............................................... 5-46

5.8 Save & Exit .............................................................................. 5-48

Appendix A Technical Summary ................................................ A-1

BA-2501 Block Diagram ...........................................................................A-2

Interrupt Map ............................................................................................A-3

I/O MAP ....................................................................................................A-8

Memory Map ........................................................................................... A-11

DMA Map ................................................................................................A-13

Configuring WatchDog Timer .................................................................A-14

Flash BIOS Update .................................................................................A-16

Revision History

The revision history of BA-2501 User Manual is described below:

Version No.

Revision History

Date

1.0

Initial Release

08/01/2017

BA-2501 SERIES USER MANUAL

Page: 1-1

1Introduction

This chapter provides the introduction for the BA-2501

system as well as the framework of the user manual.

The following topics are included:

•About This Manual

Otros manuales para BA-2501

Tabla de contenidos

Otros manuales de Placa madre de Protech Systems

Protech Systems

Protech Systems PROX-1750 Manual de usuario

Protech Systems

Protech Systems PMB-732LF Manual de usuario

Protech Systems

Protech Systems BM-2503 Series Manual de usuario

Protech Systems

Protech Systems PMB-531LF Manual de usuario

Protech Systems

Protech Systems PMB-891LF Manual de usuario

Protech Systems

Protech Systems BM-0947 Manual de usuario

Protech Systems

Protech Systems BU-2509 Manual de usuario

Protech Systems

Protech Systems BA-2501 Manual de usuario

Protech Systems

Protech Systems EB-591LF Manual de usuario

Protech Systems

Protech Systems PMB-881LF Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario