Hooking Up the VCR
t_
RCA DSS Satellite Receiver
Advanced Hookup with Basic
Receiver
Use this hookup if your TV has audio/video jacks
and your receiver has one set of AUDIO/VIDEO
jacks.
1, Set the CH3 CH4 switch on back of receiver
to either channel 3 or 4.
You will tune the VCR to this channel to
record from the satellite receiver.
2.
To watch the satellite receiver, tune your TV
to its video input channel.
If you want to watch or record the signal
from your antenna, cable, or cable box, make
sure the satellite receiver is turned off.
Set the CH3 CH4 switch on back of receiver
to either channel 3 or 4.
You will tune the TV to this channel and use
the TV*VCR button to watch the VCR.
3. Connect as shown.
This connection may require additional
accessories not provided.
4. Plug. in power cords of VCR, TV, and
receiver.
5. Go to page 8 for VCR setup information.
Advanced Hookup with Deluxe
Receiver
Use this hookup if your TV has audio/video jacks
and your receiver has two sets of AUDIO/VIDEO
jacks.
1. Set the CH3 CH4 switch on back of receiver
to either channel 3 or 4.
You will tune the TV to this channel and use
the TV*VCR button to watch the VCR.
To record from the satellite receiver, you will
tune the VCR to its line input (L 1 ).
To watch the satellite receiver, tune your TV
to its video input channel.
2. Connect as shown.
This connection may require additional
accessories not provided.
3. Plug. in power cords of VCR, "rv, and
receiver.
4. Go to page 8 for VCR setup information.
6
4
Audio/Video Cables
(supplied)
VIDEO
.....i
RF Coaxial Cable
(supplied)
MOMO
Backof "IV
From From
Satellite Cable Box
Dlah or Antenna
Back of Satellite Receiver
(supplied)
CABLE I
MONO /ANTENNA
Back of TV
