Assembly
Carefully turn the Nostalgia Bluetooth 7 in 1 music system over so that lid is resting on the floor,place
it onto a soft surface to protect it from scratches.
Screw the four legs onto the underside of the 7 in 1 music system.
Stand the Nostalgia Bluetooth 7 in 1 music system on a flat ,stable surface
Using music system
Basic Functionality
Plug the DC input jack on the power adaptor into the DC input socket on the reverse of the music
system and then plug the adaptor into the mains power supply and switch it on .
Turn on the music system by rotating the on/off/volume control dial in a clockwise direction,until it
clicks .
Short Press “MODE/REC “ button until your desired operation is selected (Bluetooth,CD,Turntable,
FM,AM,Aux,USB,TAPE ).
Long press “MODE/REC “ button to USB encoding (Only encoding during turntable mode) .
Rotate the AM/FM Radio control dial in a clockwise direction to your desired radio mode
Adjust volume by rotating the on/off/volume control dial . Rotate in a clock direction to increase the
volume and Rotate in an anticlockwise direction to decrease the volume.
To pause the track,press PLAY/PAUSE button, push it again to resume the track.
Switch to next track by pressing “Next” button; play previous track by pressing “PREV” button.
To open the Disc tray by pressing “OPEN/CLOSE” button, press “OPEN/CLOSE” button again to
close Disc tray.
To Stop CD play by pressing “Stop” button.
To turn off the music system,rotate the on/off/volume control dial in an anticlockwise direction,until it
clicks.
Listening to a Record
STEP 1: Turn on the music system by rotating the ‘On/Off/ Volume Dial’ in a clockwise direction .
STEP 2: Short press the “MODE/REC “ button to turntable mode .
STEP 3: Remove the protective white needle cover by gently sliding it away from the tone arm.
STEP 4: Carefully place a record onto the turntable,remembering to apply the 45 rpm adapter first, if
listening to a 45 rpm record with a large centre hole.
STEP 5: Unlock the tone arm from the arm lock by pushing it aside.
STEP 6: Raise the tone arm using the arm raising lever or by carefully lifting it .
STEP 7: Move the tone arm across to the outlet edge of the record and gently lower it , the turntable
will begin to spin and play automatically.
STEP 8: Once the tone arm reaches the end of the record at the centre of the turntable,the turntable
will stop.Lift away the tone arm and place it back into the armrest.
STEP 9: Secure the tone arm once more by engaging the arm lock.
STEP 10: Rotate the “On/Off/ Volume Dial” in an anticlockwise direction unit it clicks ,to turn off
Turntable .
Note: Always ensure that the tone arm is secured before transporting .
Instructions For Use
8
