ProDaylight 800 Air
4
www.profoto.com
SAFETY PRECAUTIONS!
Read and follow all safety instructions below carefully to avoid injuries or damages! Make sure that
Profoto Safety Instructions is always accompanied the equipment! Profoto products are intended for
professional use! The equipment is only intended for indoor photographic use. Do not place or use
the equipment where it can be exposed to moisture, extreme electromagnetic fields or in areas with
flammablegasesordust!Donot usetheequipmentinambienttemperaturehigherthan+35°C(+95°F).
Do not expose the equipment to dripping or splashing. Do not place any objects filled with liquids on or
near the equipment.Do not expose the equipment to hasty temperature changes in humid conditions as
thiscouldlead to condensationwater intheunit.Do not connectthisequipment to equipment fromother
brands.Only use ballast,lamps and light shaping tools as specified by Profoto. Do not use lamp without
supplied protective glass covers or protective grids. Do not stare directly at lamp while in operation.
Minimum distance to flammable surfaces is 400 cm in front of the lamp. Limit exposure in front of the
lamp if used at close distances.Glass covers shall be changed if it has become visibly damaged to such
an extent that their effectiveness is impaired, for example by cracks or deep scratches. Lamps shall be
changed if they are damaged or thermally deformed.When placing a lamp into the holder ensure not to
touch the bulb with bare hands. Equipment must only be serviced, modified or repaired by authorized
and competent service personnel!
WARNING – Electrical Shock – High Voltage!
The equipment shall always be connected to grounded mains power supply outlet! Only use Profoto
extensioncablesandmainscables!Donotopenordisassembleballastorlamphead!Equipmentoperates
with high voltage.Disconnect lamp head cable between ballast and lamp head when changing bulb!
Caution – Burn Hazard – Hot Parts!
Do not touch hot parts with bare fingers! Bulb,protective glass cover and certain metal parts emit strong
heatwhenused!Reflectorpartsmayreachatemperatureof+200°C(+392°F).Whenthelamphasbeen
inuse,wait 10minutesbeforeremovingtheprotectiveglasscover.Donotpointlamptooclosetopersons.
All lamps may on rare occasions explode and throw out hot particles!
NOTICE – Equipment Overheating Risk
Removetransportcap fromlampheadbefore use! Do notobstructventilation by placingfilters,diffusing
materials,etc.over inlets and outlets of the equipment ventilation or directly over protective glass cover.
Note about RF!
This equipment makes use of the radio spectrum and emits radio frequency energy. Proper care should
betakenwhenthedeviceisintegratedinsystems.Makesurethatallspecificationswithinthisdocument
arefollowed,especiallythoseconcerningoperatingtemperatureandsupplyvoltagerange.Makesurethe
device is operated according to local regulations.The frequency spectrum this device is using is shared
with other users.Interference can not be ruled out.
Final Disposal
Equipment contains electrical and electronic components that could be harmful to the environment.
EquipmentmaybereturnedtoProfotodistributorsfreeofchargeforrecyclingaccordingtoWEEE.Follow
local legal requirements for separate disposal of waste, for instance WEEE directive for electrical and
electronic equipment on the European market,when product life has ended!
Safety instructions
