
5
INSTALLATION INSTRUCTIONS
FLAT HEAD
SCREWDRIVER
5/32" ALLEN
WRENCH
PHILLIPS HEAD
SCREWDRIVER
TOOLS NEEDED FOR INSTALLATION
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR OUTDOOR REFRIGERATOR
•Remove the exterior and interior packing.
•Before connecting the outdoor refrigerator to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
•Clean the interior surface with lukewarm water using a soft cloth.
•This appliance is intended to be used in household and similar applications such as
– staff kitchen areas in shops, offices and other working environments;
– farm houses and by clients in hotels, motels and other residential type environments;
– bed and breakfast type environments;
– catering and similar non-retail applications.
•When disposing your appliance, please choose an authorized disposal site.
INSTALLATION OF YOUR OUTDOOR REFRIGERATOR
•This appliance is designed to be for free standing installation or built-in (fully recessed)
(Refer to sticker location the back of this appliance).
•This appliance is intended to be used exclusively for the storage of beverages or cold drinks.
•Place your outdoor refrigerator on a floor that is strong enough to support it when it is fully
loaded. To level your outdoor refrigerator, adjust the front leveling leg at the bottom of the
outdoor refrigerator.
•This appliance is using flammability refrigerant. So never damage the cooling pipework during the trans-
portation. Locate the outdoor refrigerator away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to
perform properly.
•Avoid locating the unit in moist areas.
•Plug the outdoor refrigerator into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized products service center.