Procedure for charging the battery:
1. Connect the adapter cable to the watch.
Note: You can also charge the battery by using a USB cable (not included). You only have
to connect it to the USB port of the computer.
2. Then, plug the adapter into the wall outlet.
Charging time on first use
Durée des chargements suivants :
charging level of the battery
OPERATION
Time and date display
Appuyer sur le bouton (4) par pressions successives pour afficher la date, les secondes et
l’heure.
Press button (4) repeatedly (one by one) to display the date, seconds and date.
Setting the date and time
1. Press button (6) 2 times. The figure corresponding to the month displays.
2. Press button (4) to set the month.
3. Press button (6) to confirm and enter the day setting.
4. Press button (4) to set the day.
5. Press button (6) to confirm and enter time setting.
6. Repeat steps 4 and 5 to set the figures corresponding to hours and minutes.
Note :
- After confirming the minutes, the hour and the minutes will be displayed.
- To reset the seconds, press the button (4) repeatedly, in normal time mode display,
until the seconds display. Then press button (6) to reset the seconds.
Lighting modes
The watch has got 5 lighting modes : high intensity, medium intensity, low intensity, SOS
flashing and strobe.
Press button (1) repeatedly (one by one) to select the desired lighting mode in the following
order: high intensity, medium intensity, low intensity, SOS flashing, strobe and turning off the
light.
When you get the desired lighting mode, stop pressing.
The elapsed time between each press of the buttons must not exceed one second otherwise
the flashlight will turn off when pressing the button.
Appuyer pour le bouton (1) par pressions successives pour sélectionner le mode d’éclairage
désiré dans l’ordre suivant : intensité forte, moyenne, faible, clignotement SOS, stroboscope
et extinction de la torche.
Lorsque le mode d’éclairage désiré est obtenu, arrêter d’appuyer.
Le délai entre chaque pression ne doit pas dépasser 1 seconde car autrement la torche
s’éteindra lors de la prochaine pression.
WARNING
•DO NOT immerse the watch in water or any other liquids.
•Keep away from sources of heat, direct sunlight, moisture, water and other liquids.
•Always make sure the crown is fully return to the case to ensure water resistance.
•DO NOT operate the crown or buttons in water or when the watch is wet.
•To prolong the appearance of your watch, avoid contact with the following :Perfumes,
hairspray, cosmetics, detergents, adhesives and paints as they cause discoloration,
deterioration and damage.
•To help prevent possible damage from perspiration, dust and moisture, periodically
wipe your watch with a soft dry cloth.
•To ensure lasting durability please take note of the following points: Never attempt to
open the case of your watch. Batteries should be replaced by a qualified technician.
•Your watch is shock resistant, however please be careful not to drop or hit your watch
against hard surfaces, as this will cause damage.
