pro master Infrared Remote Shutter Release Manual de usuario
For use with CANON, NIKON, OLYMPUS, PENTAX, SAMSUNG AND SONY cameras.
OPERATING INSTRUCTIONS
IMPORTANT NOTICE
Your ProMaster Remote Control features a POWER SAVE mode. Please
observe the following to ensure proper operation:
1. After initially installing the battery or changing the battery, press and
hold the shutter release button for at least 2 seconds to activate the
remote.
2. The remote will enter the POWER SAVE mode after 8 minutes of
inactivity. To wake the remote from the POWER SAVE mode and
activate it for use, press and hold the shutter release button for at
least 2 seconds.
Identifying the buttons
1. C1, C2 buttons for Canon EOS series cameras
2. A button for SAMSUNG PointShot cameras
3. P button for Pentax K series and Samsung GX series cameras
4. O button for Olympus E system cameras
5. N button for Nikon D series cameras
6. S1, S2 button for SONYAlpha and Nex series cameras
Button Funtion
C1 Instant shutter for Canon
C2 Delay shutter for Canon
A Instant shutter for Samsung
P Instant shutter for Pentax and Samsung
O Instant shutter for Olympus
N Instant shutter for Nikon
S1 Instant shutter for Sony
S2 Delay shutter for Sony
1
To use the ProMaster Universal Infrared Remote Control
1. Before using the remote for the first time, install the CR2032 battery (included).
2. Mount the camera on a tripod (recommended) or place the camera on a stable, level surface.
3. Set your camera for delayed remote or quick response remote per the instructions provided with your
camera.
4. Aim the remote control at the infrared receiver on the camera (usually within +/- 20 degree of the lens
axis, from the left to the right and from the top to the bottom) and press the shutter-release button on
the remote control. When using the remote outdoors, make sure that the subject is not backlit and
that the line of site between the transmitter and the infrared receiver is not blocked by the lens or
other obstacles.
5. How the camera focuses and shoots depends upon the options selected for your camera. For further
information, check your camera's instruction manual.
6. Infrared cannot be seen by human eyes so you will see no visible light from the LED on the front of
the remote control during operation.
To Replace the Battery
1. The remote control is powered by a three-volt CR2032 lithium battery which is included.
2. After sliding the latch in the direction shown, remove the battery holder.
3. Remove the battery from the battery holder.
4. Insert a fresh battery with the face marked "+" on top.
5. Slide the battery holder into the remote until the latch clicks into place.
Specifications
•Easy-to-replace CR2032 lithium battery.
•Operating temperature: 5°C to 40°C (40 °F to 105 °F).
•Typical Battery Life: up to 3 years, 20,000 exposures.
Care and Storage
1. When the remote control is not in use for an extended period of time, please remove the battery from
the remote control.
2. Do not expose the remote control to excessive heat or humidity.
3. Do not leave the remote control on or near a television, refrigerator, or other appliance with a
magnetic field.
4. If the remote control gets wet, wipe it with a dry towel as soon as possible.
5. Do not use organic solvents, such as alcohol or paint thinner when cleaning the remote control.
2
3
C1, C2 buttons for Canon EOS series cameras
EOS 300D EOS 350D EOS 400D EOS 450D
EOS 550D EOS 600D EOS 60D EOS 7D
EOS 500D EOS 5D Mark II EOS Rebel T1i EOS Rebel T3i
EOS Rebel XSi Digital Rebel T1 EOS Digital Rebel EOS Rebel T2i
EOS Rebel T2 Digital Rebel XT Digital Rebel XTi
A button for SAMSUNG PointShot cameras
NV10 NV11 NV15 NV20 NV30 NV40
NV100HD NV24HD NV7 OPS NV8 WB500 WB550
EX1 TL500
P button for Pentax K series and Samsung GX series cameras
Pentax K series
Kx Kr K7 K5 645D K110D
K100D K10D K100 Supper K200D K20D *ist D
*ist DS2 *ist DL2 *ist DL *ist DS
Pentax Optio series
WG-1 W90 i10 S1 S S5n
S4 S4i S5i S6 S7
430 450 550 750z S50 S40
SV 330 A10 A20 A30
SAMSUNG GX series
GX-1L GX-1S GX-10 GX-20
O button for Olympus E system cameras
E5 E3 E1 E30 E10 E20
E100 RS E300 E330 E400 E410 E450
E510 E520 E620 E600 E-P1 E-P2
N button for Nikon D series cameras
D40 D40x D50 D60 D70 D70s
D80 D90 D3000 D5000 D5100 D7000
S1, S2 button for SONY Alpha and Nex series cameras
A230 A330 A380 A500 A550 A700
A850 A900 NEX 5 A290 A450 A390
A560 A580 A33 A55
ONE YEAR UNCONDITIONAL GUARANTEE
If for any reason, your ProMaster product fails within ONE YEAR of the date of purchase, return the product
to your ProMaster dealer and it will be exchanged for you at no charge. ProMaster products are guaranteed
for ONE FULL YEAR against defects in workmanship and materials. If at any time after one year, your
ProMaster product fails under normal use, we invite you to return it to ProMaster for evaluation and repair.
Code 7613
www.promaster.com
Fairfield, CT 06825
Tabla de contenidos
Otros manuales de Accesorios para cámaras de pro master
pro master
pro master Video Tripod 24P Manual de usuario
pro master
pro master GH25K Manual de usuario
pro master
pro master Specialist Series Manual de usuario
pro master
pro master 3655 Manual de usuario
pro master
pro master LED30 Manual de usuario
pro master
pro master XtraPower Manual de usuario
pro master
pro master RL60 Manual de usuario
pro master
pro master Scout Manual de usuario
pro master
pro master SystemPro Professional Manual de usuario
pro master
pro master SM180 Manual de usuario
pro master
pro master 6942 Manual de usuario
pro master
pro master SystemPRO ProfessionalRemote + Shutter... Manual de usuario
pro master
pro master AI428C Manual de usuario
pro master
pro master US1014RGB Manual de usuario
pro master
pro master GH26 Manual de usuario
pro master
pro master 3711 Manual de usuario
pro master
pro master SM1S Manual de usuario
pro master
pro master 8363 Manual de usuario
pro master
pro master COMPACT STUDIO FLASH TRIGGER Manual de usuario
pro master
pro master 3697 Manual de usuario
