Printronix P7000 H-Series Manual de usuario
Quick Reference Guide
P7000, P7000HD, and P7000 H-Series
This Quick Setup Guide contains a
CD-ROM with the following materials:
•The User’s Manual
•Programmer’s Reference Manuals
•Useful utility programs
The CD-ROM is in a plastic pocket in
the back cover.
Save this guide. If you move or pack
the printer in the future, you will need to
reverse the instructions in this guide.
NOTICE
This document contains proprietary information protected by
copyright. No part of this document may be reproduced, copied,
translated, or incorporated in any other material in any form or by
any means, whether manual, graphic, electronic, mechanical, or
otherwise, without the prior written consent of Printronix.
Printronix makes no representations or warranties of any kind
regarding this material, including, but not limited to, implied
warranties of merchantability and fitness for a particular purpose.
Printronix shall not be held responsible for errors contained herein
or any omissions from this material or for any damages, whether
direct or indirect, incidental or consequential, in connection with the
furnishing, distribution, performance, or use of this material. The
information in this manual is subject to change without notice.
COPYRIGHT 2008 PRINTRONIX, INC.
5
Table of Contents
Loading Ribbon And Paper ..................................................7
Loading Ribbon...............................................................7
Loading Paper (Standard Configuration) ......................10
Set The Top-Of-Form .........................................................16
Clearing Paper Jams..........................................................19
Most Frequent Problems and Solutions .............................24
Contact Information............................................................25
Printronix Customer Support Center .............................25
Printronix Supplies Department ....................................26
Corporate Offices..........................................................26
For More Information..........................................................27
Notices ...............................................................................29
Table of Contents
6
7
Loading Ribbon And Paper
The following sections describe how to install ribbon and load
paper.
Loading Ribbon
Figure 1. Preparing to Load the Ribbon
1. Make sure the printer cover is open.
2. Raise the platen lever as far as it will go.
3. Close the blue tractor doors.
Blue Tractor
Door (2)
Platen Lever
Loading Ribbon And Paper
8
Figure 2. Loading the Ribbon
4. Place the empty spool on the right hub. Be sure the ribbon
feeds off the outside of the spool.
5. Press the spool down until it snaps into place.
IMPORTANT
The empty spool has a barcode label on the bottom side and a
date code label on the top. Once the sensor automatically
reads and logs the ribbon barcode, the Integrated Print
Management System starts to track ribbon usage.
If you remove the ribbon during the course of its life and want
to re-install the same ribbon, be sure to place the same spools
on the correct hubs. Do not reverse the spools. Be sure to
re-install the spool with the date code label on the top onto the
right hand hub.
Right Hub
Spool
9
Loading Ribbon
Figure 3. Threading the Ribbon Around the Ribbon Guide
6. Thread the ribbon around the ribbon guide and along the ribbon
path. Be sure to thread the ribbon between the hammer bank
cover and the ribbon mask.
7. Place the full spool on the left hub.
8. Press the spool down until it snaps into place.
9. Turn the left spool by hand to make sure the ribbon tracks
correctly in the ribbon path and around the ribbon guides.
Ribbon Guide
(both sides)
Left Hub
Ribbon Spool
Ribbon Mask
A
A
Hammer
Bank Cover
Ribbon Loading
Instructions
(for future reference)
Loading Ribbon And Paper
10
NOTE: If there are ink stained fingerprints on the ribbon barcode
(located on the ribbon spool), wipe it clean with a soft cloth
or towelette moistened with alcohol.
Loading Paper (Standard Configuration)
When you start this procedure, verify that the printer cover is open,
the platen lever is raised, and the blue tractor doors are open.
Figure 4. Aligning the Paper Supply
1. Prepare the paper supply:
Cabinet Model
a. Open the front door of the printer cabinet.
b. Place the paper supply inside the printer, on the floor of the
cabinet.
c. Align the paper supply with the front label on the floor of the
printer.
d. Ensure that the paper pulls freely from the box.
e. Feed the paper up through the paper slot.
NOTE: The P7220 and P7280HD model have a metal paper guide.
Load the paper on top of this guide.
Label
Otros manuales para P7000 H-Series
11
Este manual sirve para los siguientes modelos
6
Tabla de contenidos
Otros manuales de Impresora de Printronix
Printronix
Printronix P8000 Series Manual de uso y cuidado
Printronix
Printronix SMARTLINE SL4M Manual de usuario
Printronix
Printronix P7000 H-Series Manual de usuario
Printronix
Printronix T8000 Manual de uso y cuidado
Printronix
Printronix P4280 Manual de usuario
Printronix
Printronix M4L Manual de servicio
Printronix
Printronix SL5000 Series Manual de usuario
Printronix
Printronix P6000L Instrucciones de montaje
Printronix
Printronix SL5000E series Manual de usuario
Printronix
Printronix L7032 Manual de usuario
Printronix
Printronix P7000 H-Series Manual de usuario
Printronix
Printronix SMARTLINE SL4M Manual de usuario
Printronix
Printronix L1024 Manual de usuario
Printronix
Printronix T5000 Series Guía de inicio rápido
Printronix
Printronix 300 Instrucciones de uso
Printronix
Printronix N7000 H-Series Manual de usuario
Printronix
Printronix T6000 Manual de uso y cuidado
Printronix
Printronix SMARTLINE SL4M Manual de usuario
Printronix
Printronix LP844C Manual de usuario
Printronix
Printronix 300 Manual de usuario
