www.aps-supply.com
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
F: 1 619 263 6814
APS Australia
Unit 1, 72 Kent Way
Malaga WA 6090 Australia
P: 61 (8) 9248 4419
F: 61 (8) 9248 4901
APS: Singapore
Colombia
Chile
Perú
Brasil
PREVIEW SIDE DEFENDER II MANUAL APS-SUPPLY.COM
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interferenc e to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct the interference.
INDUSTRY CANADA STATEMENT
Per RSS-Gen, Section 8.4 This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Par RSS - Gen, Section 8.4 Cet appareil est conforme à Industrie Canada exempts de licence standards RSS. Le
fonctionnement est soumis aux deux conditions suivantes : (1 ) ce dispositif ne peut pas provoquer d’interférences et ( 2)
cet appareil doit accepter toute interférence , y compris les interférences qui peuvent causer un mauvais fonctionnement
de l’appareil.
REGULATORY COMPLIANCE
The PreView® Side Defender® is compliant with the following countries/regions and their regulations as of the published
date of this manual. The sensor may be compliant in other countries/regions. Please check your local regulations or
contact PRECO Electronics® for support.
• United States - FCC- Part 15.249
• FCC ID: OXZJCKP2016
• Canada - RSS-210 Radio Standards Specication
• IC ID:
• European Union - ETSI EN300 440-1 Electromagnetic Compatibility and Radio Spectrum Matters (ERM)
• Australia/New Zealand - AS/NZ 4268 Radio Equipment and Services – Short Range Devices
Patent pending
This document may be amended, corrected, and enhanced in keeping with the sensor development progress. The most
recent version can be found at www.preco.com
TRADEMARKS
The names of actual companies and products mentioned herein may be the trademarks of their respective owners. Any
rights not expressly granted herein are reserved.
