3
1.SAFETYANDWARNINGS
NOTE
Before a projector’s installation, power-on, operation and maintenance, please carefully read
thesafety informationhereinafter!
Thefollowingsafetysignsareusedintheusermanual.
● When unpacking , check if there is transportation damage before using the projector. Should there be any
damagecausedbytransportation,consultyourdealeranddonotuseit.
●The manufacture is not responsible for loss caused by the user not following the manual or changing the projector as
he/shelikes
●Pleasebenotedthatthedamagecaused bychangingtheprojectoratwillisnotwarranted.
●Do nothesitate to contact the dealeror the manufacturer if any questions or advice.
● Theprojector is forindoor useonly,IP20.
● Use only in dry locations. Keep this unit away from rain and moisture, excessive heat, humidity and dust. Do not allow
contactwithwateroranyotherliquids.
●The projector should be kept away from high temperature, fire, electrical surge, vibration and strong light while being
operated
●The projector is only intended for installation, operation and maintenance by qualified personnel. And the operation
must strictlyfollowtheproceduresinthemanual
●Norepairablepartsintheprojectorand donotopencoversfor maintenance byyourself.
●Don’t look straightly into the light sources especially for epileptics, otherwise eyes will be burned.
●Do not connectthisdevice toanytypeofdimmer pack
●After lampswitchedon,theminimumdistancebetween theprojectorandilluminatedsurface is 10m
●lens and other optical parts shall be replacedimmediatelyifthey have deformed or been damaged, otherwise the light
outputwillbecompromised.
●Before operation, please confirm that all covers(housing) are on and screws tightened. It’s forbidden to use a projector
whilecovers(housing)areoff
●Keep thelamp cleananddonot touchitwithbarehands.
●Whileoperatingit, wearprotectiveitems.
●Anyelectricalconnectionmustbecarriedoutbyaqualifiedperson.
●Before installation,pleaseconfirmthevoltagesupplied matcheswhat isrequiredforthe projector
●Eachprojector mustbeproperlyearthedand installedasperrelated electricalstandards.
●Donot usepower cordwithitsinsulatordamaged andconnectthepowercordwithothercables.
●Ifthe projectoris not used or under cleaning,, please hold the plug and unplug it. Do not unplugit forcefullyorby
pullingthepower cable.
●All powercordsmustconformto relatedsafetyandregulations
●Whilebeingoperated,theprojectorshould notbeunder rainsorinhumidity.
●Do not switch on and off the projector constantly in very short intervals, otherwise the light source’s and other
electricalparts’ life willbe shortened .
