FYG3/REV2 5
6. Use:
After removing all plastic, clean the plate with an appropriate detergent and then
grease the plate.
To start the plate press the knob and turn it counter- clockwise to the maximum
position (large flame print ), then press the lighter one or more times, observe if
the flame lit, if so keep the knob pressed for 10 to 15 seconds more.
Allow the plate to warm, and then you can start to use it.
The regulation of the heating is made with the handle in the range between the
big flame (maximum) and the small flame (minimum).
7. Cleanliness and conservation:
So that cleaning can be done the easiest way, put some water on the plate,
light it up in the minimum position until the water bubbles, this will facilitate the
release of trapped particles. After cooling, use a damp cloth and, if necessary,
some detergent, finish cleaning.
Perform this operation at the end of each use but never with the hot plate!
Remove and clean the grease trimmer periodically so that it does not overflow
on the front panel and on the knobs. To remove the trimmer, lift up a little at the
front and pull out carefully.
