Co yright Planika S . z o.o. www. lanikafires.com 4
III. Safe y
As Lincoln roduce a real o en fire it is necessary to follow the below s ecified rules in order to enable the roduct to be
used in a technically correct and safe manner as well as to maintain the warranty.
•When installing the device according to the instructions, you must com ly with national and local regulations.
•It is required to read the installation instructions in order not to use the device in an im ro er manner or in rooms with
smaller cubic ca acity than required.
•Products should not be ex osed to atmos heric conditions. It’s the roduct for internal use only.
•When turned on, the device roduce steam, carbon dioxide and heat, therefore it’s necessary to rovide adequate
ventilation so that the total re lacement of the air in the room is min. 1 / h.
•Do not use the device in the tem erature lower than 10°C and higher than 30°C.
•Do not install the device in areas of large drafts of air, near fans, vents, etc.
•Do not install the device on esca e routes and in laces where there may be otentially ex losive atmos heres.
•The device as well as the fuel should be ke t out of reach of children, ets and unauthorized ersons.
•It is forbidden to consume the fuel. Avoid contact with skin and eyes.
•It is required to take recautions when dealing with flammable materials, for exam le in direct contact with object,
or in area within 1 m / 3.28 ft. around the device no flammable objects should be laced. Do not lace near the curtains,
blinds, etc.
•Do not lace on the grid any elements not rovided by the roducer.
•It is necessary to lace dry- owder or carbon dioxide extinguisher near the device.
•The device should be installed only on flat, level and firm surface.
•Positioning the device on a slo ing ground may cause malfunction, damage to the device or fire.
•It is forbidden to use other fuel than recommended fuel FANOLA or the fuel recommended in section II Su lies and
consumables.
•Do not heat the fuel before the heating rocess of the device is started.
•Do not start the device in case of s illage of fuel out of the tank.
•Never our fuel directly into the flame tray as this may cause damage to the device and result in fire. Such an attem t
may cause violent ignition, result in fire, burns, and can even be life threatening.
•Do not cover the device while it is switched on.
•Do not o erate near the fuel filler while the device is switched on.
•Do not o erate with the com onents contained within the flame tray under the threat of burns or damage to the device.
•Do not move the device while it is switched on. The device can be moved only after the com lete combustion of the fuel,
when it is disconnected from ower su ly and when all its elements are cooled.
•The device should not be left without adult su ervision while it is switched on.
•The device should be ke t out of reach of untrained users.
•The device must be switched on and used as er descri tion in oint IV in instructions.
•While switching on the device, the odor of fuel may be erce tible.
•The device is not suitable for continuous o eration. If the device suddenly turns off, roceed in accordance with the
instruction.
CAUTION!
•Glowing coil is heated to a tem erature of 1300 ° C. Touching, when the device is switched on may cause burns.
•While working the flame tray is heated to high tem eratures. Do not touch the flame tray or hot arts located in close
area under the risk of burn injury.
•The first startu of the device can be made only after ro er installation of the device and reading the manual.
•If the device requires trans ort it is required to burn all fuel remains and move it in a horizontal osition, avoid tilting it.
As the unburned fuel remains in the combustion chamber, during the transfer sensors could be activated. In this case,
the device could be used again only after it has dried com letely.
It is forbidden to make any re airs or changes in the device. Re airs may be made only by rofessional technician.
!
!
