Pittasoft BLACKVUE LCD Manual de usuario
Name |Car Dashcam
Manufacturer |Pittasoft Co.,Ltd. / Korea
Address |(Gasan-dong, BYC HIGHCITY), A-7th floor, 131, Gasan digital 1-ro, Geumcheon-gu, Seoul,
153-718, Republic of Korea
Sales Headquater |Tel: +82-2-6947-4670(#3) |Fax: +82-2-6947-4699
| e-mail: [email protected]
EN/FR/DE/SC
Name |Car Dashcam
Manufacturer |Pittasoft Co.,Ltd. / Korea
Address |(Gasan-dong, BYC HIGHCITY), A-7th floor, 131, Gasan digital 1-ro, Geumcheon-gu, Seoul,
153-718, Republic of Korea
Sales Headquater |Tel: +82-2-6947-4670(#3) |Fax: +82-2-6947-4699
| e-mail: sales@pittasoft.com
BLACKVUE LCD
DR750LW-2CH
For more detail, download the manual from the BlackVue homepage (www.blackvue.com).
ENGLISH
BLACKVUE LCD I 3
ENGLISH
Table of Contents
Getting Started 4 Package Components
5 Name of Each Part
Install the BlackVue 7 Checking Installation Position
8 Insert & Remove the microSD Card
9 Installation
BlackVue Viewer and App 11 BlackVue Viewer
11 BlackVue App
4
Getting Started Package Components
Front View Camera Manual
Power Cable Cable Clips (8 EA)
microSD Card Reader Rear View Camera
Double-Sided Tape
for the Mounting Holder
microSD Card
(BlackVue Viewer and User Guide
Included)
Rear View Camera Connection Cable
Note
yPictures of the components may dier from the actual.
yTo enhance the performance of the product, the components may be
changed without prior notice.
yThe additional package components and parts sold separately can be
purchased from the website of BlackVue (www.blackvue.com).
BLACKVUE LCD I 5
ENGLISH
Name of Each Part
Front View Camera
Mounting Holder
Camera Angle Control Bolt
Camera Lens
DC in (Power Terminal)
V in
(Terminal for
Connecting to the
Rear View Camera)
GPS
(External GPS Terminal)
LCD Screen
microSD Card Slot
Mounting Holder
Detachment Button
Wi-Fi LED
GPS LED
REC LED
Power Button
• Pressing Short: Starts and stops voice recording.
• Pressing Long: Turns on or o the power.
Note
yThe external GPS is sold separately.
y‘Hancom Inc.’ owns the copyright of the ‘HANDotum / HANDotumB /
HANDotumExt’font used in DR750LW-2CH rmware.
6
Rear View Camera
Mounting Holder Camera Lens
V out
(Terminal for
Connecting to
the Front View
Camera)
Rear Security LED
Caution
yRisk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
BLACKVUE LCD I 7
ENGLISH
Install the BlackVue Checking Installation Position
1
It is recommended to install the front view camera next to the room mirror.
Clean any foreign substances and moisture from the place where the prod-
uct will be installed with a dry cloth
2
It is recommended to install the rear view camera at the higher part of the
back window.
Note
yDo not install the product where it can interfere with the driver's vision.
yIt is recommended to install the product at the spot specied.
8
Insert & Remove the microSD Card
1
Insert the microSD card into the microSD card slot, of the front view camera,
in the direction as shown in the gure below:
2
In order to detach the microSD card, gently push the center of the microSD
card with your thumb and pull out the card. Make sure that the microSD
card does not spring out when detaching the card.
Caution
yDo not remove the microSD card while it is saving or reading data. This
may cause data damaged or malfunction.
yCopy important data to other storage medias. Pittasoft Co., Ltd. is not
accountable for data loss resulting from carelessness.
Note
yInsert or remove the microSD card only when the product is turned o.
yMicroSD cards are consumables. Replace them with new ones after
prolonged use.
BLACKVUE LCD I 9
ENGLISH
Installation
1
In a bright and safe place, stop the vehicle engine and pull out the vehicle
key.
2
Attach the front view camera on the vehicle windshield glass with double-
sided tape.
3
Attach the lens of the rear view camera on the vehicle’s back window with
double-sided tape, so that the lens can also be placed at the center of the
vehicle.
4
Connect the V in terminal of the front view camera to the V out terminal
of the rear view camera by using the cable for connecting to the rear view
camera.
5
Use the power cable to connect the DC in of the front camera to car’s power
socket.
Note
yIt is necessary to use Power Magic (the Battery Discharge Prevention
Device) to record video while the car is parked.
yTo use BlackVue with other equipment that uses a power cable, purchase
and use a dual power outlet adaptor.
Otros manuales para BLACKVUE LCD
4
Tabla de contenidos
Idiomas:
Otros manuales de Cámara de salpicadero de Pittasoft
Pittasoft
Pittasoft BlackVue DR300G Manual de usuario
Pittasoft
Pittasoft BlackVue DR500-HD Manual de usuario
Pittasoft
Pittasoft BlackVue DR650S-1CH Manual de usuario
Pittasoft
Pittasoft DR380-HD Manual de usuario
Pittasoft
Pittasoft BlackVue 7-1CH Manual de usuario
Pittasoft
Pittasoft BlackVue DR500GW-HD Manual de usuario
Pittasoft
Pittasoft BLACKVUE LCD Instrucciones de uso
Pittasoft
Pittasoft BlackVue DR650GW-2CH Manual de usuario
Pittasoft
Pittasoft DR380-HD Manual de usuario
Pittasoft
Pittasoft DR400G-HD II Manual de usuario
