Philips SIC4014H/G7 Manual de usuario
Glide Handheld Scanner
SIC4014H/G7
User Manual
Scanner à main Glide
Manuel d'utilisation
Escáner de mano deslizante
Manual del usuario
ENGLISHFRANÇAISESPAÑOL
1
Important Safety Instruction
• Keep away from water or moisture and dusty areas.
• Do not place this product under direct sunlight or near heat sources,
such as in a closed car under sunlight or near a stove. The outer casing
of this product may become deformed and the sophisticated sensors
inside may become damaged due to excessive heat.
• The battery and inside of the scanner become hot during large volume
scanning operation. Allow few minutes to cool-down before operating the
unit again.
• Ambient temperature ranges from 0°C to +40°C.
• Only use attachments/accessories specified by the manufacture.
• Avoid using the scanner in a dusty environment. Dust particles and other
foreign objects may damage the unit. Place the scanner in the pouch if not
in use.
• Operate the scanner on a level, well-grounded work surface, free of
excessive vibration.
• Do not attempt to disassemble or modify this product. Attempting to do
so is extremely dangerous and will void the warranty.
• When replacing AAA batteries, only use the ones with same capacity.
Do not mix new batteries with used ones.
• Please recycle the batteries in accordance with local regulations.
Disposing of a battery in fire may cause an explosion.
This symbol on the product or in the instructions means that your
electrical and electronic equipment should be disposed at the
end of its life separately from your household waste. There are
separate collection systems for recycling in the EU. For more
information, please contact the local authority or your retailer
where you purchased the product.
Package Contents
• Glide Handheld Scanner • Mini USB Cable • Software CD
•
Four AAA Battery • User Manual • Quick Start Guide
•
Calibration Sheet • Cleaning Cloth • Pouch
2
Table of Contents
Package Contents ...................................................................................... 1
Important Safety Instruction ........................................................................ 1
Product Overview ....................................................................................... 3
Placing AAA Batteries ................................................................................. 4
Inserting a microSD Card ........................................................................... 4
Power on/off ............................................................................................... 4
Scanning ..................................................................................................... 5
Playback ..................................................................................................... 6
Viewing the images................................................................................... 6
Zoom ........................................................................................................ 6
Delete ...................................................................................................... 6
Settings ....................................................................................................... 7
Connecting to a PC .................................................................................... 8
Transferring the Scanned Images to PC .................................................. 8
Disconnect the scanner from a PC .......................................................... 8
ezScanPal V2.0 Software Installation ......................................................... 9
A glance at ezScanPal V2.0 ....................................................................... 9
Cleaning and Calibrating .......................................................................... 10
Cleaning the scanner.............................................................................. 10
Calibrating the scanner........................................................................... 10
Helpful Hints ............................................................................................. 10
Specifications ........................................................................................... 12
One (1) Year Limited Warranty ................................................................. 13
3
Product Overview
1Battery Indicator
2LCD Screen
3Left button • Moves left in the menu.
• Moves to the previous scanned image.
4Menu button • Moves up in the menu.
• Brings up the Mode menu.
5Right button • Moves right in the menu.
• Moves to the next scanned image.
6Power/Scan
button
• Press and hold to turn the power on/off.
• Press slightly to start/stop the image scan.
7Battery cover
8Playback • Select to view the scanned images.
9Setting • Select to make Scan Setting and System
Setting.
10 Delete button • Moves down in the menu.
• Brings up the Delete menu.
11 OK/Zoom button • Press to make or confirm the selection in the
menu.
• Zoom the scanned image.
12 MicroSD card slot • Compatible with a microSD card up to 32GB.
13 Mini USB port • Connects to PC for file transfer.
14 Alignment guide • Alignment reference before scanning.
14
13
12
7
2 3 4 5 6
10 11
1
8 9
4
microSD card (required, not
included) should be inserted
with metal side up.
Placing AAA Batteries
1. Gently push and slide the battery cover away from the LCD screen.
2. Place 4 alkaline batteries according to the polarity indicators inside the
compartment.
3. Slide back the battery cover.
Note:
• A new set of batteries will scan approximately 300 A4-sized color
documents at 300 dpi or 200 A4-sized color documents at 600 dpi with
new batteries installed.
• Remove batteries if the scanner is not used for long time.
Inserting a microSD Card
Insert a microSD card into the card slot with metal side up to scan and store
the images.
Note: The microSD card must be formatted by
the scanner for the first time use. It is recom-
mended to save any images on the memory
card before reformatting.
Formatting the microSD memory card
1. Insert a new microSD card into the scanner,
then turn on the scanner.
2. Select (Setting), and press OK/Zoom button.
3. Select SYSTEM (System Setting), and press OK/Zoom button.
4. Press Left / Right button repeatedly to select FORMAT and press
OK/Zoom button.
5. Select "Yes" to comfirm formatting.
Power on/off
• Press and hold Power/Scan button for a few seconds to turn ON/OFF.
5
Scanning
1. Press and hold Power/Scan button to turn on the power.
Note: CARD message appears on the screen if no card is inserted.
2. Select
(Setting) >
SCAN
(Scan Setting)
> Direction to set the scan
direction to Up or Down.
3. Place the scanner flat against the document with the scanning lens facing
down. Make sure the area you want to scan is between the Alignment
guides.
4. Press Power/Scan button to activate the Scan. The
Scanning
/
Scanning
scanning
icon appears.
5. Follow the arrow indication on the LCD screen to
slowly slide the scanner up or down and keep your
hand stable to get the best quality picture.
6. To stop scanning, press Power/Scan button again.
The scanned image will show on the screen and save
to the memory card automatically.
7. To start a new scan, repeat the steps 3~6.
Note:
• The progress bar status during the scanning:
Green Good scan.
Orange Poor scan. Lower the scan speed.
Exclamation mark Unsuccessful scan. Please re-scan.
Helpful Hints:
• Scan at a slow and constant speed to optimize scan quality.
• When scanning books or magazines, begin scan from the bind and glide
outward.
6
Playback
Viewing the images
1. Select (Playback), and then press OK/Zoom button.
2. Press Left or Right button to view the previous or
next images.
Note: To return to the main menu, press Menu button.
Zoom
1. Select the image you want to zoom in the (Playback) mode.
2. Press OK/Zoom button repeatedly to zoom in the image.
3.
Press the directional buttons ( Up/ Down/ Left / Right) to
navigate around the image.
4. To exit the Zoom mode, press OK/Zoom button repeatedly.
Delete
1. Select the image you want to delete in the (Playback) mode.
2. Press Delete button, select DELETE ONE or
DELETE ALL, then press OK/Zoom button.
3. Select Yes, and then press OK/Zoom button to
delete.
4. To exit the Delete menu, press Menu button.
Main Menu
DELETE
ALL
DELETE
ONE
7
Settings
1. Select Setting, and then press OK/Zoom button.
2. Press Left / Right button to select either SCAN Scan Setting or SYSTEM
System Setting and then press OK/Zoom button.
3. Press Left / Right button to select the option you wish to change
and then press OK/Zoom button.
Note: To return to the Setting mode for more tasks, press Menu
button.
Menu Sub-menu Descriptions
Scan Setting
Color Mode Select Color or Gray mode for the scanning.
Resolution Select 300 dpi or 600 dpi for the scanning.
Direction Sets the scanning direction to Down or Up.
File Type Select JPG or PDF file format for the
scanning.
Calibration Calibrates the scanner. Refer to Calibrating
the scanner for details.
System Setting Language Select a screen display language list out the
languages.
Format Formats all the data stored in the memory
card.
Factory
Default
Restores the current settings to the factory
presets.
8
Connecting to a PC
Transferring the Scanned Images to PC
1. Turn off the power before connecting to a PC.
2. With the microSD inserted to the scanner, connect the mini USB cable to
the Scanner and then to a USB port on your computer.
Note:
microSD card should be inserted with metal side up.
3. Turn on the power of the scanner.
4. Your computer will recognize the scanner as a removable disk. Click
“Open folder to view files”.
5. You may transfer the scanned images to your PC using the drag and drop
method.
Disconnect the scanner from a PC
• Double click the "Safely Remove Hardware" icon in Windows before re-
moving the USB connection.
Note:
• The above steps may vary in different Windows versions.
•
If the removable device window did not launch automatically, go to “My
Computer” and find the device under removable disk.
Otros manuales para SIC4014H/G7
1
Tabla de contenidos
Idiomas:
Otros manuales de Escáner de Philips
