Philips DB21-A Manual de usuario

NOTE : LAMP STYLE WILL VARY WITH FIXTURE OPTIONS.

HEAD

SCREWS

(3X)

HEAD

ASSEMBLY

THREADED

GLOBE

LAMP

GLOBE

GASKET

(IN RECESS)

CAUTION

WARNING : TURN POWER OFF BEFORE INSTALLING OR

PERFORMING ANY MAINTENANCE ON THIS FIXTURE.

Failure to do so may result in severe injury or death.

GFI PROTECTION! Fixtures which may come in contact with or

be exposed to moisture (i.e. outdoors) shall be installed on a

GFI (Ground Fault Interruptor) circuit. (120V only.)

The fixture should not be installed in low lying areas or where

water may accumulate and stand for long periods of time.

INSTALLATION

WARNING : Make sure the power is off before installing or

servicing this fixture.

Install the anchor rods into a concrete footing as indicated on

the supplied template. Install and level the baseplate with

ballast assembly as shown on the template.

Connect the supply lines from the supply conduit to the fixture's

input leads according to NEC procedures. Tie the wires so they

do not lie on the ground. HID & Fluorescent : Connect the lamp

supply quick-connect to the ballast quick-connect pigtail.

Set the fixture onto the baseplate and tighten the three

mounting screws to secure the fixture. Be sure not to crimp any

wires between the baseplate and tube.

Install a lamp per the relamping instructions below and test the

fixture for proper operation.

RELAMPING

Make sure power is off before relamping. Loosen the three head screws on top of the head assembly until the

assembly is loose. Lift the head assembly entirely off, lifting by the louvers, not the roof. Unscrew the

globe and set it aside. Replace the lamp or install a new one per the lamp style on the lamp label. HID fixtures

should use coated lamps for best results. Make sure the globe gasket is correctly seated, and securely replace

the globe. Set the head onto the fixture and tighten the three head screws securely.

32000950, revision F

100 Craftway Dr.

Littlestown, Pennsylvania 17340-0128

Phone: 717-359-7131

INSTALLATION INSTRUCTIONS:

BOLLARDS

This fixture is intended for installation in accordance with the National Electrical Code and local code

specifications. Failure to adhere to these codes and instructions may result in serious injury and/or damage

to the ballast and void the warranty. These instructions do not purport to cover all details or variations in

equipment, nor to provide for every possible contingency related to installation, operation, maintenance,

or mounting situation. Should specific problems occur that are not addressed by these instructions, contact

your Sales Representative or distributor for assistance. Retain these instructions for future reference.

page 1 of 2

SAFETY WARNING:

ALWAYS TURN FIXTURE OFF/DISCONNECT POWER AND ALLOW TO COOL BEFORE

PERFORMING ANY MAINTENANCE, INCLUDING RELAMPING AND CLEANING!

This fixture can become very HOT! The fixture housing and lens, especially if it is glass, can become hot enough

to blister hands. Attention should be paid to where the fixture is mounted, particularly if it can be touched by

children or pets. To help prevent premature failure, decreased performance, overheating and risk of fire, keep

fixture and lens clean and free of leaves, mulch, debris and mineral deposits from water. The fixture and lens

can be cleaned using a soft cloth and a solution of mild liquid soap and warm water. Wipe clean and dry with a

soft, lint-free dry cloth. Avoid polishing fixture or lens.

30"

HID,

FLUOR.,

INC. & LED

21"

HID,

FLUOR.,

INC. & LED

14"

INC. & LED

ONLY

HEAD MOUNTING

SCREWS, (3X)

HEAD

ASSEMBLY

LAMP

GLOBE

TUBE

BALLAST

ASSEMBLY

QUICK-

CONNECT

CONDUIT STUB

(BY OTHERS)

BASE

PLATE

MOUNTING

SCREWS, (3X)

LEVELING NUTS (3X)

ANCHOR RODS (3X)

SET IN POURED

CONCRETE FOOTER

STANDARD

FIXTURE

STYLES

NOTE : FIXTURE STYLE AND BALLAST TYPE

WILL VARY WITH FIXTURE OPTIONS.

PICTURED TO THE RIGHT : 21" HID.

page 2 of 2

32000950, revision F

INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS

IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS!

WARNING - Lamp gets HOT quickly! To reduce the risk of FIRE OR INJURY TO PERSONS:

Do not operate fixture with a missing or damaged lens/lens assembly.

Contact only switch or plug when turning fixture on or off. Do NOT touch hot lens or housing.

Turn off or unplug fixture and allow to cool before relamping. Keep lamp away from combustibles.

Do NOT touch lamp with bare hands at any time, use a soft cloth as oil from skin may damage lamp.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Luz exterior de Philips

Philips

Philips Ecomoods 169008716 Manual de usuario

Philips

Philips 168244716 Manual de usuario

Philips

Philips 169139316 Manual de usuario

Philips

Philips 168179316 Manual de usuario

Philips

Philips 15385/**/16 Manual de usuario

Philips

Philips 168578716 Manual de usuario

Philips

Philips Ecomoods 169098716 Manual de usuario

Philips

Philips ecoMOODS 16907/87/16 Manual de usuario

Philips

Philips 172389316 Manual de usuario

Philips

Philips Ledino 16802/93/16 Manual de usuario

Philips

Philips 163394716 Manual de usuario

Philips

Philips 169289316 Manual de usuario

Philips

Philips ClearWay BGP303 Guía del usuario

Philips

Philips Stela Square BPP614 Manual de usuario

Philips

Philips 16928/47/16 Manual de usuario

Philips

Philips UHP UX21511 Manual de usuario

Philips

Philips hue Calla Large Manual de usuario

Philips

Philips ecoMOODS 16914/93/16 Manual de usuario

Philips

Philips Ledino 16811/87/16 Manual de usuario

Philips

Philips ecoMOODS 16924/47/16 Manual de usuario

Philips

Philips Ecomoods 16901/93/16 Manual de usuario

Philips

Philips Ledino 168073116 Manual de usuario

Philips

Philips 163804716 Manual de usuario

Philips

Philips Ecomoods 16903/47/16 Manual de usuario

Manuales populares de Luz exterior de otras marcas

Sealey

Sealey LED37 Manual de usuario

nordlux

nordlux VEJERS Guía del usuario

SImx

SImx ELITE LED LHTC637 Manual de usuario

GEV

GEV CAROLINE 10833 Manual de usuario

NEBO

NEBO NEB-LSP-0020 Manual de usuario

WE-EF

WE-EF PFL540 LED Manual de usuario

Lindby

Lindby 9949029 Manual de usuario

HEPER

HEPER DOGO Side LW6048.585-US Instrucciones de instalación y funcionamiento

HEPER

HEPER LW8034.003-US Instrucciones de instalación y funcionamiento

Maretti

Maretti VIBE S 14.6080.04.A Manual de usuario

BEGA

BEGA 84 253 Manual

HEPER

HEPER MINIMO Instrucciones de instalación y funcionamiento

LIGMAN

LIGMAN BAMBOO 3 Manual de usuario

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manual de usuario

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manual de usuario

urban ambiance

urban ambiance UQL1273 Manual de usuario

TotalPond

TotalPond 52238 Manual de usuario

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manual de usuario