Philips BASS+ SHB4385 Manual de usuario

SHB4385

BASS+

User manual

www.philips.com/support

1EN

Contents

1 Important safety instructions 2

Hearing Safety 2

General information 2

2 Your Bluetooth wireless

headset 3

What's in the box 3

Other devices 3

Overview of your Bluetooth

wireless headset 4

3 Get started 5

Charge the battery 5

Pair the headset with your

Bluetooth device at the rst

time 6

Pair the headset with another

Bluetooth device 6

4 Use your headset 7

Reconnect the headset to your

Bluetooth device 7

Power on/o 7

Manage your calls and music 7

LED indicator status 8

How to wear 8

5 Factory reset the headset 9

6 Technical data 10

7 Notice 11

Declaration of conformity 11

Disposal of your old product

and battery 11

Compliance with EMF 12

Environmental information 12

Trademarks 12

8 Frequently asked questions 13

2EN

1 Important

safety

instructions

Hearing Safety

Danger

•To avoid hearing damage, limit the time you

use headset at high volume and set the

volume to a safe level. The louder the volume,

the shorter the safe listening time is.

Be sure to observe the following

guidelines when using your headset.

• Listen at reasonable volumes for

reasonable periods of time.

• Be careful not to adjust the volume

continuously upwards as your

hearing adapts.

• Do not turn up the volume so high

that you can’t hear what’s around

you.

• You should use caution or

temporarily discontinue use in

potentially hazardous situations.

• Excessive sound pressure from

earphones and headset can cause

hearing loss.

• Using headset with both ears

covered while driving is not

recommended and may be illegal in

some areas while driving.

• For your safety, avoid distractions

from music or phone calls while in

trac or other potentially dangerous

environments.

General information

To avoid damage or malfunction:

Caution

•Do not expose headset to excessive heat.

•Do not drop your headset.

•Headset shall not be exposed to dripping or

splashing.

•Do not allow your headset to be submerged

in water.

•Do not use any cleaning agents containing

alcohol, ammonia, benzene, or abrasives.

•If cleaning is required use a soft cloth, if

necessary dampened with a minimum amount

of water or diluted mild soap, to clean the

product.

•The integrated battery shall not be exposed

to excessive heat such as sunshine, re or the

like.

•Danger of explosion if battery is incorrectly

replaced. Replace only with the same or

equivalent type.

About operating and storage

temperatures and humidity

• The storage temperature is between

-15°C to 55 °C. The operation

temperature is 45°C (max.) (up to

90% relative humidity).

• Battery life may be shorter in high or

low temperature conditions.

3EN

2 Your

Bluetooth

wireless

headset

Congratulations on your purchase, and

welcome to Philips! To fully benet

from the support that Philips oers,

com/welcome.

With this Philips wireless headset, you

can:

• enjoy convenient wireless

handsfree calls;

• enjoy and control wireless music;

• switch between calls and music.

What's in the box

Philips True Wireless headset

BASS+ SHB4385

Replaceable rubber ear caps x 2 pairs

Charging case

USB charging cable (for charging only)

Quick start guide

Other devices

A mobile phone or device (e.g.

notebook, Bluetooth adapters, MP3

players etc) which supports Bluetooth

and is compatible to the headset (see

‘Technical data” on page 10).

4EN

Overview of your

Bluetooth wireless

headset

a Microphone

b Multi-function buttons

c LED indicator (headset)

d Micro USB charging slot

e LED indicator (charging case)

5EN

3 Get started

Charge the battery

Note

•Before you use your headset for the rst time,

place the headsets in the charging case and

charge the battery for 3 hours for optimum

battery capacity and lifetime.

•Use only the original USB charging cable to

avoid any damage.

•Finish your call before charging the headset,

as connecting the headset for charging will

power the headset o.

Charging case

Connect one end of the USB cable into

the charging case, and another end into

the power source.

» The charging case starts charging.

• Charging process is veried by the

white LED light next to the USB

socket on the case..

• When the charging case is fully

charged, the white light goes o.

Tip

•The charging case serves as a portable backup

battery for charging the headset. When the

charging case is fully charged, it supports one

full recharge cycle for the headset.

Headset

Place the headset in the charging case.

» The headset start charging.

• Charging process is veried by white

LED lights on the earpieces.

• When the headset is fully charged,

the white light goes o.

Tip

•Normally, a full charge takes 2 hours (for the

headset or charging case).

6EN

Pair the headset with

your Bluetooth device at

the rst time

1 Make sure that the headset is fully

charged and powered o.

2 On both earpieces, press and hold

the multi-function buttons for

approximately 3 seconds.

» The LED on both earpieces

ashes in white for 3 times; and

then it ashes in blue.

» Both earpieces are now

powered on and are paired with

each other.

» The headset is now in pairing

mode and is ready to pair with a

Bluetooth device (e.g. a mobile

phone).

3 Turn on the Bluetooth function of

your Bluetooth device.

4 Pair the headset with your

Bluetooth device. Refer to the user

manual of your Bluetooth device.

Note

•After powering on, if the headset cannot nd

any previously connected Bluetooth device, it

will automatically switch to pairing mode.

The following example shows you how

to pair the headset with your Bluetooth

device.

1 Turn on the Bluetooth function

of your Bluetooth device, select

Philips SHB4385.

2 Enter the headset password

"0000" (4 zeros) if prompted. For

those Bluetooth devices featuring

Bluetooth 3.0 or higher, no need to

enter a password.

Philips SHB4385

SHB4405

Pair the headset with

another Bluetooth device

If you have another Bluetooth device

that you want to pair with the headset,

make sure the Bluetooth function in any

other previously paired or connected

devices are turned o. Then follow the

steps in ‘Pair the headset with your

Bluetooth device at the rst time’.

Note

•The headset stores up to 2 devices in the

memory. If you try to pair more than 2 devices,

the earliest paired device is replaced by the

new one.

7EN

4 Use your

headset

Reconnect the headset

to your Bluetooth device

1 Turn on the Bluetooth function of

your Bluetooth device.

2 Make sure the headset is powered

o.

3 On both earpieces of the headset,

press and hold the multi-function

buttons for approximately 3

seconds.

» The LEDs on both earpieces

ash in white for 3 times; and

then it ashes in blue.

» Both earpieces are now

powered on and are paired with

each other.

» The headset will search the last

connected Bluetooth device and

reconnect to it automatically.

If the last connected one is

not available, the headset will

search and reconnect to the

second last connected device.

Tip

•The headset cannot connect to more than

1 device at the same time. If you have two

paired Bluetooth devices, only turn on the

Bluetooth function of the device that you want

to connect.

•If you turn on the Bluetooth function of your

Bluetooth device after turning on the headset,

you have to go to the Bluetooth menu of the

device and connect the headset to the device

manually.

Note

•If the headset fails to connect to any

Bluetooth device within 15 minutes, it will turn

o automatically to save the battery life.

•In some Bluetooth devices, connection may

not be automatic. In this case, you have to

go to the Bluetooth menu of your device and

connect the headset to the Bluetooth device

manually.

Power on/o

Task Multi-

function

button

Operation

Turn the

headset on.

Right and

left ear-

pieces

Press and

hold for 3

seconds.

Turn the

headset o.

Right or left

earpiece

Press and

hold for 4

seconds.

» The

white

LED

ashes

once.

Manage your calls and

music

Music control

Task Multi-

function

button

Operation

Play or pause

music.

Right

earpiece

Press once.

Skip forward. Right

earpiece

Press twice.

Skip

backward.

Right

earpiece

Press 3

times.

8EN

Volume up Left ear-

piece

Press twice.

Volume down Left ear-

piece

Press once.

Call control

Task Multi-

function

button

Operation

Pick up/hang

up a call.

Right ear-

piece

Press once.

» 1 beep.

Reject an

incoming call.

Right ear-

piece

Press and

hold for 1

second.

» 1 beep.

Switch caller

during a call.

Right ear-

piece

Press twice.

Voice control

Task Multi-

function

button

Operation

Siri/Google

Now.

Right

earpiece

Press twice

and hold for 1

second.

LED indicator status

Headset status Indicator

The headset is

connected to a

Bluetooth device,

while the headset

is in standby

mode.

The blue LED

ashes for every 5

seconds.

The headset is

powered on.

The white LED

ashes 3 times.

The headset is in

pairing mode.

The blue LED

ashes.

The headset

is on but not

connected to a

Bluetooth device.

The blue LED

ashes.

If no connection

can be made, the

headset will turn

itself o within 15

minutes.

Low battery level

(headset).

You will hear

‘battery low’ on the

headset.

Low battery level

(charging case).

The red LED on

the charging case

ashes every 1

second.

Battery is

fully charged

(headset).

The white LED on

the headset is o.

Battery is fully

charged (charging

case).

The white LED on

the charging case

is o.

How to wear

1 2

Otros manuales para BASS+ SHB4385

Tabla de contenidos

Otros manuales de Auriculares de Philips

Philips

Philips VOX150 Manual de usuario

Philips

Philips OptiFit earloop SHB6110 Manual de usuario

Philips

Philips SHI1605 Manual de usuario

Philips

Philips SHB6000/00 Manual de usuario

Philips

Philips SHB9100/00 Manual de usuario

Philips

Philips SpeechOne psm6000 Manual de usuario

Philips

Philips OptiFit earloop SHB6110 Manual de usuario

Philips

Philips SHB1400 Manual de usuario

Philips

Philips SHM6600 Manual de usuario

Philips

Philips SHB7102BB/61 Manual de usuario

Philips

Philips SHM7410 Manual de usuario

Philips

Philips SHM3100/37B Manual de usuario

Philips

Philips SHB9100WT/00 Manual de usuario

Philips

Philips VOX120 Manual de usuario

Philips

Philips SHQ3017 Manual de usuario

Philips

Philips SHU2000 Manual de usuario

Philips

Philips SHM1900 Manual de usuario

Philips

Philips SHM7405/00 Manual de usuario

Philips

Philips SHM6103 Manual de usuario

Philips

Philips SHQ1007/28 Manual de usuario

Philips

Philips SHB7103 Manual de usuario

Philips

Philips SHB1400 Manual de usuario

Philips

Philips SHM3200 Manual de usuario

Philips

Philips SHB7110/97 Manual de usuario

Manuales populares de Auriculares de otras marcas

Sena

Sena SMH10 Manual de usuario

IASUS

IASUS Stealth IA-NT4-BASIC-BT Manual de usuario

Sennheiser

Sennheiser EPOS ADAPT 230 Manual de usuario

Doro

Doro Flexus HS2005 Manual de usuario

GE 98971 Manual de usuario

Hama

Hama 00184070 Manual de usuario

Plantronics

Plantronics Blackwire 3200 Series Manual de usuario

Blue Tiger

Blue Tiger Advantage PLUS Manual de usuario

Jawbone

Jawbone Icon Manual de usuario

Jabra

Jabra FR 20 Manual de usuario

Roxcore

Roxcore Flow A+ Manual de usuario

Turtle Beach

Turtle Beach XP 510 Manual de usuario

Jabra

Jabra PRO 9460 Duo Manual de usuario

HyperX

HyperX HyperX Cloud Flight Manual de usuario

Bose

Bose MIE2 Mobile Manual de usuario

Jabra

Jabra Steel Manual de usuario

HyperX

HyperX cloud ii Manual de usuario

Southwing

Southwing SA505 Manual de usuario