Pentair Shurflo 1500 Manual de usuario

pentair.com

INSTALLATION AND

OPERATION MANUAL

BAIT & LIVEWELL PUMP

MODELS 1500 AND 2000

TABLE OF CONTENTS

2 911-1000 (10-01-20)

Safety Instruction....................................................................................................................................................................................3

Installation...............................................................................................................................................................................................4

Operations...............................................................................................................................................................................................5

Troubleshooting ......................................................................................................................................................................................6

SAFETY INSTRUCTIONS

3911-1000 (10-01-20)

SAVE THESE INSTRUCTIONS: This manual contains

important instructions that should be followed during

installation, operation, and maintenance of the product.

Carefully read and follow all safety instructions in this

manual.

IMPORTANT SAFETY TERMINOLOGY

indicates a hazard which, if not avoided, will

result in death or serious injury.

indicates a hazard which, if not avoided, can

result in death or serious injury.

indicates a hazard which, if not avoided, can or

may result in minor or moderate injury.

NOTE addresses practices not related to personal injury.

CALIFORNIA PROPOSITION 65 WARNING

This product and related accessories contain

chemicals known to the State of California to cause cancer,

birth defects or other reproductive harm.

SAFETY INSTRUCTIONS

Always use fuse with amps rating specified on

pump label. Failure to do so may result in serious personal

injury, fire hazards and will void the warranty.

Do not disassemble base from pump body.

Warranty will be voided upon disassembly. SHURFLO is not

responsible for problems due to disassembly of base from

pump body.

 Do not pump oil, diesel fuel, gasoline or other flammable

liquids with this pump.

 Always disconnect power before servicing pump.

 Always use fuse size specified in specification.

 Seacock MUST be closed before removing pump for

service.

INSTALLATION

4 911-1000 (10-01-20)

MOUNTING

(Suggested installation & operation only. Your installation

may vary)

Mount scoop-type thru-hull [high speed pick-up] to hull. Do

not drive screws through hull!

 Below water level thru-hull fittings must have a seacock

shut-off valve.

 Install a 1” NPT-M brass nipple fitting into pump inlet and

mount directly to seacock.

 SHURFLO recommends installing our 330 livewell fill

valve.

PLUMBING

 Use smooth I.D. discharge tubing

 Tubing should be rated for below water line use.

 Always use double clamps for connections below the

water line.

 Tubing should enter tank at top to avoid tank draining

while pump is off. (See illustration for recommended

installation).

Avoid airlock & maximize performance: Avoid any sagging

or loops in the tubing. Tubing must go up from pump to tank.

Use full -flow style valves only. Valve is used to regulate

flow to tank while at rest and while under way (2 different

settings).

ELECTRICAL

 Use 16GA wire for all circuits. If installation is over 20

feet, use 14GA wire.

 Brown pump wire must be connected to positive power.

 When the controller detects a lock rotor condition (high

amps) for more than 10 seconds it will turn the pump off

until power gets reset.

 Use waterproof connectors and splices.

 Attach all wires to UL Marine approvedduty switch rated

at or above 15 amps.

 Wire connections should be made above water level at

the highest possible position.

 Seal wire connections to prevent corrosion and

electrolysis.

12 VDC BATT.

12' LIFT

(MAX)

WATER

LEVEL

RED

(OFF ) (ON )

BLACK

BROWN (+ )

75°

SHURFLO Fill Valve

Model 330

Do NOT Allow Tubing to Sag.

Always Use Double Stainless Steel Clamps

for Plumbing Below Water Line.

Optional 1/2" NPT Port f

or Washdown Connection.

Sea-Cock Safety Valve Required.

Be sure Valve Opening is as Large as

Bait Pump Dishcarge Port I.D.

Pump Should be Mounted within 75° of

Vertical to Insure Quick Evacuation of Air.

Must "ENTER" at

Top of Tank

Water-Level

Pump MUST be

below Water-Level

SHURFLO Bait Pump Model 385

Wrong Position for Discharge Port

OTHER INSTALLATION OPTIONS:

Through Hull Fitting 6"-12" Off Keel

U/L Marine Approved, Ignition Protected

On/Off Switch. 15 AMP Rating (Min.)

Pump MUST be

Below Water Level

Tubing must travel upward

from pump to bait tank.

If tubing sags below horizontal

pump may become air-locked.

FUSE

(Refer to Specs. for size)

OPERATION

5911-1000 (10-01-20)

 Never operate equipment if gasoline fumes are present.

 Always test pump before leaving dock.

 Open sea cock before running pump, do not run pump

dry.

 Tank fill time should be tested at rest and under way.

 Pump will fill tank faster while boat is running at higher

speeds. General tank fill times are between 7 minutes

[warmer water] and 10 minutes [colder water].

 Measure tank fill time from empty while at rest and adjust

valve position for desired time.

 Measure tank fill time at normal cruising speed and

adjust valve to desired time.

 Refer to tank size chart for optimal pump size. Note

position for later reference.

 Always remember to adjust valve when at rest or under

way.

 Flow should be circular and slightly upward so debris

clears from bottom of tank. Flow should not be too fast

that fish get tired.

TIPS: Vibration induced by sea conditions or transportation

may cause plumbing or pump hardware to loosen. Check for

system components that may be loose. Many symptoms can

be solved by simply tightening.

MAX. HEAD FT. [M] MAX. AMPS FUSE OUTLET PORT

14 [4.27] 810 1-1/8"

18 [5.5] 10 15 1-1/8"

14 [4.27] 4 6 1-1/8"

18 [5.5] 5 6 1-1/8"

TECHNICAL DATA

NAME VOLTAGE MODEL # 0' [0M] 3’[1M] 6' [2M]

1500 12 V* 358-001-00 1800 [6813] 17 0 0 [6 4 34] 1600 [6056]

2000 12 V 358-011-00 2200 [8327] 2000 [7570] 1900 [7191]

2000 12 V 358-012-00 2200 [8327] 2000 [7570] 1900 [7191]

1500 24 V 358-101-00 1800 [6813] 17 0 0 [6 4 34] 1600 [6056]

2000 24 V 358-111-00 2200 [8327] 2000 [7570] 1900 [7191]

FLOW GPH [LPH]

*Specifications given at design voltage 13.6 VDC per ABYC recommendations.

6 911-1000 (10-01-20)

TROUBLESHOOTING

Pump will not start or no water:

 Check electrical connections including fuse, switch and

ground connection.

 Check if voltage is present at the pump.

 Check for improper fuse rating or wire size.

 Sea-Cock / thru-hull or valve closed?

 Pump mounted above water level.

 Sea-Cock valve not fully open.

 Check if tank flow adjust valve is closed.

 Check if inlet is clogged.

7911-1000 (10-01-20)

PAGE INTENTIONALLY LEFT BLANK

All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.

Because we are continuously improving our products and services, Pentair reserves the right to change specications without prior notice. Pentair is an equal opportunity employer.

1101 Myers Parkway | Ashland, Ohio, USA 44805 | Ph: 800 854-3218 | pentair.com

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Bomba de agua de Pentair

Pentair

Pentair Fairbanks Nijhuis 5900 Series Manual

Pentair

Pentair HYPRO 9305C Series Manual de usuario

Pentair

Pentair LINCOLN POWER-MASTER III Manual del propietario

Pentair

Pentair Hypro 9915-DP803 Manual de usuario

Pentair

Pentair AURORA 654A Instrucciones de funcionamiento

Pentair

Pentair IntelliFlo VS-3050 Manual de usuario

Pentair

Pentair AURORA LAYNE VERTI-LINE Series Manual de usuario

Pentair

Pentair Nocchi VLR Series Manual de usuario

Pentair

Pentair Berkeley 3PL Guía

Pentair

Pentair Jung Pumpen US 73 E, Ex Manual de usuario

Pentair

Pentair SHURFLO 4008 RV REVOLUTION Manual de usuario

Pentair

Pentair Aurora 382B CC Series Manual de usuario

Pentair

Pentair HYDOMATIC HGRS200 Manual

Pentair

Pentair HYPRO 9302C Series Manual de usuario

Pentair

Pentair Hydromatic P33A1 Manual

Pentair

Pentair Myers MBSP-01 Manual de usuario

Pentair

Pentair AURORA 342A Instrucciones de funcionamiento

Pentair

Pentair Simer A5300 Manual de usuario

Pentair

Pentair STA-RITE PNC Manual de usuario

Pentair

Pentair Hydromatic SHEF50 Guía de configuración

Pentair

Pentair Jung Pumpen U2 KS Manual de usuario

Pentair

Pentair MYERS VRS20-21TRE Manual

Pentair

Pentair HYDROMATIC EZ OUT SYSTEM Manual

Pentair

Pentair JUNG PUMPEN MULTICUT 35/2 M Tan, EX Manual de usuario

Manuales populares de Bomba de agua de otras marcas

Neptun

Neptun NPHW 5500 Manual de usuario

Sensidyne

Sensidyne Gilian BDX-II Instrucciones de instalación y funcionamiento

Draper

Draper 47808 Manual de usuario

Trolla

Trolla 12820 Manual de usuario

Sunfab

Sunfab SVH Series Manual de usuario

WilTec

WilTec 50740 Manual de usuario

Fieldmann

Fieldmann FVC 5015 EK Manual de usuario

Everbilt

Everbilt EFSUB5-122HD Manual de usuario

Graco

Graco Husky 3300e Manual de usuario

esotec

esotec 101018 Manual de usuario

moyno

moyno 2000 CC Manual de usuario

Becker

Becker BASIC VASF 2.80/1-0.AC230 Manual de usuario

Sykes AmeriPumps

Sykes AmeriPumps GP100M Guía de solución de problemas

DUROMAX

DUROMAX XP WX Series Manual de usuario

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Manual de usuario

Franklin Electric

Franklin Electric IPS Manual de usuario

Xylem

Xylem e-1532 Series Manual de usuario

Milton Roy

Milton Roy PRIMEROYAL Manual de usuario