BUTTON OPERATIONS IN MODEL ADJUSTMENT MODE
MODEL ADJUSTMENT MODE
CH1 CH2 CH3 CH4
ABC
TOUCH SENSITVE SLIDERS IN MODEL ADJUSTMENT MODE
SCAN Tap-and-Hold each slider to scan the channel for a Paul C. Buff light.
If one is found, the CyberSense will display the model setting that is associated
with that light on the screen. If one cannot be found, it will blink “---“ three times.
When the CyberSense finds a light, it will set that light’s model mode to the global
model lamp setting shown in the lower-left corner of the CyberSense display.
TOGGLE Double-tapping the slider will toggle that light ON or OFF, when the CyberSense
has found a light on the channel.
If the model lamp is ON, double-tapping the slider will turn it OFF. If the light is OFF, double-tapping the slider will send
the global model lamp setting to the light. If the global model lamp setting is MODEL OFF, double-tapping the slider does
nothing.
SLIDE Increase or decrease the model lamp setting of a light on a particular channel by sliding your finger UP or DOWN.
If the unit’s global model lamp setting is OFF or FULL, the slider does nothing.
ABC
TOGGLES THE GLOBAL MODEL
LAMP SETTING ACCESS FLASH
ADJUSTMENT MODE
ACCESS
SETUP MODE
Icon 1 Icon 2
Icon 3 Icon 4
